RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: Mcgiver
Showing results 1 to 13 of 13
Search took 0.48 seconds.
Forum: The Clubhouse
09-12-2021, 10:59 AM
Replies: 12,313
Views: 1,353,205
Posted By Mcgiver

Zenoah G38 Carb

I'm trying to fine out which adjusting screw on the walbro carb is the high speed. Can anyone help me??
Replies: 30,072
Views: 1,306,378
Posted By Mcgiver

RE: THE LOUNGE 3...

You must have been thinkin with your dipstick, Jimmy'.
12-09-2009, 07:46 PM
Replies: 130
Views: 10,511
Posted By Mcgiver

RE: Mixing your own fuel

Why not run our glow engines on kerosene w/caster, its less than $4 a gallon??
Forum: Seaplanes
11-28-2009, 10:45 PM
Replies: 163
Views: 21,923
Posted By Mcgiver

RE: Please help me do the unthinkable ...

I say get you good flight simulator and learn , learn, learn. If you can fly on it and land without crashing you might stand a chance. Being a pilot is really a bad handycap. I have tried to teach...
11-07-2009, 08:49 PM
Replies: 13
Views: 21,425
Posted By Mcgiver

RE: Spektrum AR7000 Beware!

My recievers have heat shrink on them right where they come out of the case. They came that way new.
11-07-2009, 08:39 PM
Replies: 13
Views: 21,425
Posted By Mcgiver

RE: Spektrum AR7000 Beware!

Hey I have crashed a Yak and an Extra 260 because of Spektrum reciever battery pack failure. One of the cells went dead during flight with no warning and no simptons before hand. These batteries were...
01-07-2009, 10:08 PM
Replies: 1,595
Views: 111,837
Posted By Mcgiver

RE: WIN A FREE Scale Fuselage from V-East & Graupner Helis

Hey guys, I hope I win this heli. I could add it to my plane collection this year. [8D]
Forum: IMAC
03-21-2008, 02:18 AM
Replies: 8
Views: 1,527
Posted By Mcgiver

RE: Allen Taylor IMAC I March 29-30 Griffin,GA

Hello, can anyone tell me the best way to install a smoker system on a Saito 180 4 cycle engine. I have all the equipment to do this but I don't know if you just feed the oil into the muffler via...
11-19-2007, 01:35 PM
Replies: 96
Views: 8,894
Posted By Mcgiver

RE: Would you still be a member of AMA if it was not a requirement of your club?

I am not complaining about the AMA, I have belonged to it since 1976. When the dues get higher than I feel they need to be I will discontinue my membership !

Its not a matter of money, I am...
11-18-2007, 06:46 PM
Replies: 96
Views: 8,894
Posted By Mcgiver

RE: Would you still be a member of AMA if it was not a requirement of your club?

Our club dues at one field are $25 a year. The other clubs dues here are $40 a year. I belong to two chartered clubs in WV and the AMA also. This model flying is gettin darn expensive, ain't it?

...
11-18-2007, 06:26 PM
Replies: 96
Views: 8,894
Posted By Mcgiver

RE: Would you still be a member of AMA if it was not a requirement of your club?

I have to say that just like all other organizations the AMA is getting too fancy and too big and too much dues. They don't need all those gaint buildings and land that they have aquired with our...
08-21-2007, 10:49 AM
Replies: 3
Views: 1,275
Posted By Mcgiver

RE: RECOMMEND THE BEST STILL/VIDEO CAMERA FOR SMALL ELECTRICS

Hello, Mcgiver here . I just happened upon your post and I saw a guy this past Sat. that had a small digital movie camera attached to his electric foamy bi-plane and it did a great job filming the...
08-27-2006, 08:51 PM
Replies: 0
Views: 437
Posted By Mcgiver

extra 300s 160 size

Looking for a wing half for an extra 300s 160 size. Anyone have one??
Showing results 1 to 13 of 13


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.