RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: rkflyboy57
Showing results 1 to 16 of 16
Search took 0.68 seconds.
Forum: Marketplace
05-02-2019, 06:31 PM
Replies: 1
Views: 537
Posted By rkflyboy57

$75 shipped to 97850 La Grande Oregon----Thank...

$75 shipped to 97850 La Grande Oregon----Thank you--Rick
Forum: Marketplace
11-21-2018, 03:48 PM
Replies: 0
Views: 554
Posted By rkflyboy57

Miniature Aircraft Furry 55--Genuine sn #55

This is the ultimate Fury 55 as is sn#55! Min Air Fury 55--I built and did the review article of the 55 when I worked for Heliproz in Billings Montana. I waited for the sn #55 as a documented...
Forum: Marketplace
11-21-2018, 03:26 PM
Replies: 0
Views: 783
Posted By rkflyboy57

Pawnee--Hanger 9--NEW

I built this Hanger 9 Pawnee and lost interest. It is Bind and Fly--or receiver ready which ever you choose. Set up with Align 2 in 1 7.4 volt li po battery and glow plug/regulator system- all new....
Forum: Marketplace
11-21-2018, 02:59 PM
Replies: 0
Views: 1,020
Posted By rkflyboy57

Kalt Mercury 50 CCPM KIT

I HAVE A BEAUTIFUL KALT 50 ccpm KIT. i AM LISTING AS USED BECAUSE IT WAS STARTED BY A young man who acquired it from his Uncle the founder of Heliproz. After starting it he decided to buy a T-Rex 600...
Forum: Marketplace
11-14-2018, 06:16 PM
Replies: 3
Views: 1,627
Posted By rkflyboy57

available

Is this engine still for sale?

Thank you--Rick
Forum: Marketplace
11-14-2018, 06:08 PM
Replies: 35
Views: 1,800
Posted By rkflyboy57

Is it for sale?

Is it for sale?
Forum: Marketplace
11-14-2018, 05:54 PM
Replies: 2
Views: 3,320
Posted By rkflyboy57

still available?

still available?
Forum: Marketplace
11-14-2018, 05:47 PM
Replies: 9
Views: 1,008
Posted By rkflyboy57

Would you take $200 shipped to 97850

Would you take $200 shipped to 97850 La Grande Oregon?
Thank you--Rick
Forum: Crash & Rebuild
02-04-2009, 11:00 PM
Replies: 19
Views: 5,240
Posted By rkflyboy57

RE: P-51 INTO THE TOWER

Hello Rod Springer!

Don't know if you remember me or not? I used to fly with Randy Underhill a lot. I 'm Rick Klages. Used to be from Josephnow Billings, Mt

I had all Bob's kits and they...
Forum: Electric RC Helis
01-04-2008, 08:58 PM
Replies: 9
Views: 2,233
Posted By rkflyboy57

RE: Which Gyro & Servos for a Mini-Titan?

I like the Jr DS 285 servos with the JR 3400mg for the tail. These cost a few dollars more than the HS-56's but you heli will fly much smoother. The Futaba 401 is a natural for this heli. It's a...
Forum: Electric RC Helis
01-02-2008, 11:57 AM
Replies: 2
Views: 729
Posted By rkflyboy57

RE: Best R/C Electric Co-Axial Helicopter

In my opinion the Blade CX is. However Hirobo makes a model in 2 different body styles called the XRB. They are by far the best flying and most durable of this type heli. They also are $90 more. The...
Forum: Electric RC Helis
01-02-2008, 11:48 AM
Replies: 2
Views: 657
Posted By rkflyboy57

RE: Pitch

Hello;
What kind of heli do you have? Is it ccpm or manual control. This makes a big differance in the setup. If it's ccpm (electronic mix) you need to set up as 120 or 140 degree ccpm swash in the...
Forum: Electric RC Helis
12-27-2007, 11:26 AM
Replies: 2
Views: 624
Posted By rkflyboy57

RE: H

Hello;
Most tx's and gyros have the option of allowing you to set up your gyro on a dedicated screen (gyro screen) on the tx. Most are required to use aux 2 port for the single wire, gyro signal...
Forum: Electric RC Helis
12-18-2007, 12:33 PM
Replies: 2
Views: 564
Posted By rkflyboy57

RE: gyro's

Gyro's can be a bit complex, and most have instructions that are not very clear; especially to the novice. They are very easy to install on the heli, just choose the proper location--either on a...
Forum: Electric RC Jets
07-14-2005, 12:07 AM
Replies: 8
Views: 2,789
Posted By rkflyboy57

RE: more thrust from ducted fan?

hello. you guys seem to know about ducted fans. I need to know where I can get replacement motors for a GWS A-10 that my wife and son bought me for Fathers day. I am using a Castle Pixi 20 amp speed...
Showing results 1 to 16 of 16


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.