RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 12
1
2
3
11
Last »
Search: Posts Made By: Raserx
Showing results 1 to 25 of 289
Search took 0.51 seconds.
Forum: T-Rex heli
06-07-2007, 08:31 PM
Replies: 5
Views: 604
Posted By Raserx

RE: My first outdoor FFF and Nose-in approach!!

Best part is its still in one piece...thumbs up!!
Forum: Speed - RC Gas Boats
06-05-2007, 09:25 PM
Replies: 2
Views: 618
Posted By Raserx

RE: Shockwave engine question ...any help?

Hey Flabum,
Thanks for the reply. Actually, the tank wasn't dirty. Just cleaned out old fuel when I put on new hoses. No I didn't clean the carb yet(knock self on head). I was hopiing to find out...
Forum: Speed - RC Gas Boats
06-05-2007, 08:54 PM
Replies: 6
Views: 973
Posted By Raserx

RE: 84 apache

Crimony thats a big boat....[X(] That wouldn't even fit in my ranger bed. But, it sure is pretty.
Forum: Speed - RC Gas Boats
06-05-2007, 08:45 PM
Replies: 2
Views: 618
Posted By Raserx

Shockwave engine question ...any help?

Hey Guys,
I have a yellow shockwave55. It has a tuned pipe, water pump, clutch and I added some turn fins to help stabilize in the turns.

My question is about tuning the zenoah. The boat...
Forum: T-Rex heli
06-02-2007, 11:14 PM
Replies: 12
Views: 1,001
Posted By Raserx

RE: UP AND DOWN

bent flybar![sm=what_smile.gif]

might want to get a new one. They are cheap yet priceless...my two cents.
Forum: T-Rex heli
06-02-2007, 11:10 PM
Replies: 10
Views: 865
Posted By Raserx

RE: newbie with q on which heli too buy WAY TOO MANY OUT THERE

Trex 450S was my first electric heli. I love it. Great flyer easy on parts. Big following lots of advice and will keep parts cost low and abundent.

Can't go wrong wit the REX!
Forum: T-Rex heli
05-28-2007, 10:17 PM
Replies: 2
Views: 489
Posted By Raserx

RE: Tail trouble revalation...uneven left right control

HEY Barracuda,

You are correct...however, when the tail servo is no correctly adjusted w/ the gyro you MAY get uneven left right tail control. I have heard questions about uneven piroette rates...
Forum: T-Rex heli
05-28-2007, 01:38 PM
Replies: 2
Views: 489
Posted By Raserx

Tail trouble revalation...uneven left right control

Hey Guys,

I recently discovered one of the reasons the tail will spin faster one direction than the other. I have heard people ask about this before.

Long story short. I recently switched...
Forum: T-Rex heli
05-14-2007, 08:47 PM
Replies: 33
Views: 3,223
Posted By Raserx

RE: water proofing

The balloon trick should work for most of the electronics. (i.e. put them in an empty balloon and zip tie the end shut) it works for boats.

The servos would be easy enough. silicone all the...
Forum: T-Rex heli
04-23-2007, 05:01 AM
Replies: 5
Views: 693
Posted By Raserx

RE: difference btw. 450 SA and SE

Yes. All the SE parts will flt the SA.
Forum: T-Rex heli
04-19-2007, 06:36 PM
Replies: 11
Views: 1,066
Posted By Raserx

RE: V2 crash...

OH..OW!! sorry to hear it dude.
Forum: T-Rex heli
04-19-2007, 06:27 PM
Replies: 2
Views: 479
Posted By Raserx

RE: Head rebuild

Hey Kurtzz,
Yup all the head parts are the same they are just black plastic. I would recommend you to buy the metal upgrades to replace you old plastic pieces. They are a little more expensive...
Forum: T-Rex heli
04-16-2007, 07:17 PM
Replies: 10
Views: 832
Posted By Raserx

RE: control linkages

you can always dremel them down to the needed size. then the set up should go by leveling all the control levers...per Bob.
Forum: T-Rex heli
04-16-2007, 07:04 PM
Replies: 49
Views: 5,448
Posted By Raserx

RE: n00b TREX 450 XL build

Hey Guys,
I my opinion...the 325 pro woodies are the absolute best beginner blades (let the flaming begin). They fly very well, are usually very well balanced and matched..and best of all...
Forum: T-Rex heli
04-15-2007, 07:07 PM
Replies: 28
Views: 2,046
Posted By Raserx

RE: Loops, just do them

hey JT,
Here is a pic of my first loop.http://i91.photobucket.com/albums/k312/Raserx/get-attachment-11.jpg It looked great until I lost too much altitude on the back side. Pretty much a full...
Forum: T-Rex heli
04-15-2007, 07:00 PM
Replies: 8
Views: 782
Posted By Raserx

RE: ground effect?

over five feet and you should be fine...If you are trimming your heli, you need a big open enclosed garage or building.
Forum: T-Rex heli
04-15-2007, 03:00 PM
Replies: 4
Views: 639
Posted By Raserx

RE: Pitch Guage How To

Hey Rick,

Try searching a couple of my posts. I have explained alot of set up per the finless video's.

If you don't have your control levers lever you won't get equal positive and negative...
Forum: T-Rex heli
04-14-2007, 08:28 PM
Replies: 29
Views: 2,712
Posted By Raserx

RE: HELP TAIL SERVO CHOICES

The HS81MG is a great budget servo for the tail. I highy reccomend it. I one on both my S and SE...it works well witht the telebee gyro also. I do hard sport flying and am learnign 3D...loops...
Forum: T-Rex heli
04-14-2007, 08:25 PM
Replies: 6
Views: 624
Posted By Raserx

RE: successful first flights with new Rex

YOU GO HOBO!!

How was it..? Details man, details..!

congrats!
Forum: T-Rex heli
04-14-2007, 08:23 PM
Replies: 2
Views: 597
Posted By Raserx

RE: My SE V2 vs SE

I have done the same set up with my SE and S.

The S has all the metal upgrades(except the tailcase).

the only difference between the two helis are the servo's. The S has cheap ss100's and...
Forum: T-Rex heli
04-14-2007, 08:16 PM
Replies: 28
Views: 2,046
Posted By Raserx

RE: Loops, just do them

I'm sure its possible with an FP heli....but, you really need the collective to pull them off clean. Especially if you are trying flips.

Good luck...and let us know how it goes.

Its been...
Forum: T-Rex heli
04-14-2007, 06:57 PM
Replies: 8
Views: 1,020
Posted By Raserx

RE: TREX SA with 9C setup

As for what GT said.....Can I get an AMEN!
Forum: T-Rex heli
04-14-2007, 06:55 PM
Replies: 28
Views: 2,046
Posted By Raserx

RE: Loops, just do them

Loops just require forward flight..the faster you fly the faster your inputs need to be.

Or just get up real high (as high as you can safely judge orientation) and do a flip. The higher you go...
Forum: T-Rex heli
04-13-2007, 05:19 AM
Replies: 86
Views: 9,790
Posted By Raserx

RE: T-Rex 450SE "new" V2

I personally don't use loctitie on my motor screws.

I do check them alot though...I would hate to have one backout in flight...(mayday,mayday...were going in....splat!)
Forum: T-Rex heli
04-12-2007, 09:14 PM
Replies: 86
Views: 9,790
Posted By Raserx

RE: T-Rex 450SE "new" V2

No problem Sport,
Glad I could help...Its looking good. That frame looks strong..sweet.
Showing results 1 to 25 of 289
 
Page 1 of 12
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.