RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: Ian Shaw
Showing results 1 to 25 of 60
Search took 0.52 seconds.
Forum: RC Jets
01-04-2009, 02:57 AM
Replies: 19
Views: 6,250
Posted By Ian Shaw

RE: To the Batplane

Nice! Lozza..
Forum: RC Jets
09-14-2008, 01:55 PM
Replies: 16
Views: 6,544
Posted By Ian Shaw

RE: Extending thermocouple wire ?

Not sure what engine you are refering to but typicaly K type thermocouples are used with turbines. K types use a cable called (compensating cable) which basically means the conductors are made of the...
Forum: RC Jets
04-27-2008, 05:10 AM
Replies: 10
Views: 1,946
Posted By Ian Shaw

RE: Kingcat C.G.

Hi there, the correct measurement for the center of gravity is, 10.7" Aft of L.E at the wing root. Hope this helps
Forum: 3D Flying!
11-09-2007, 03:46 PM
Replies: 360
Views: 50,165
Posted By Ian Shaw

RE: Engine for Funtana X50

I was thinking of putting an irvine 53 in my 50 x. Can anyone tell me if this will be enough for hovering and general 3D?. It's that or splash out on a YS63. By the way what's it like with a yS 63?...
Forum: 3D Flying!
10-29-2007, 01:49 AM
Replies: 21
Views: 3,178
Posted By Ian Shaw

RE: AeroWorks .90 - 1.20 Yak 54 QB

[/b]
Forum: 3D Flying!
10-27-2007, 02:12 PM
Replies: 21
Views: 3,178
Posted By Ian Shaw

RE: AeroWorks .90 - 1.20 Yak 54 QB

I am very undecided between the aeroworks and the QQ 69" Yak I have a YS 110 waiting to go in either one. Any suggestions to which it would be more suited.
Forum: RC Jets
09-15-2007, 01:20 PM
Replies: 3
Views: 1,154
Posted By Ian Shaw

RE: 10X Crow set up and Weatronics Rx

What I did was match the right aileron with aux2 channel 7(left aileron). Then I mixed flap and FPRN, and adjusted the points to get 20mm up aileron on full flap. This is for a JR 9x 2 I assume the...
Forum: RC Jets
09-15-2007, 01:17 AM
Replies: 3
Views: 1,154
Posted By Ian Shaw

RE: 10X Crow set up and Weatronics Rx

I had the same problem. What I did was put the ailerons on two seperate channels in the Weatronics. It worked then.
Forum: RC Jets
07-14-2007, 02:12 AM
Replies: 16
Views: 2,777
Posted By Ian Shaw

RE: Weatronic Receiver or Futaba Receiver + Powerbox??

I have just bought a weatronics 10 -20 R .. Not sure on what Batteries to use.. Any ideas please?
Forum: RC Jets
07-02-2007, 03:30 PM
Replies: 10
Views: 2,060
Posted By Ian Shaw

RE: Doc's New Super Bandit

I thought I had seen one like it before:D
Forum: RC Jets
06-30-2007, 09:22 AM
Replies: 922
Views: 144,056
Posted By Ian Shaw

RE: Comp ARF Flash update

He He.. Guess we all have our bad days Geoff..:D
Forum: RC Jets
06-29-2007, 01:48 PM
Replies: 22
Views: 2,906
Posted By Ian Shaw

RE: Kingcat total weight??

Raf, the black as you can see is done. Just the white to spray now. Looking forward to trying it out.
Thanks too Mike Gay for spraying and laurie for the masks.
Sorry Mike, your surname has been...
Forum: RC Jets
06-29-2007, 01:30 PM
Replies: 22
Views: 2,906
Posted By Ian Shaw

RE: Kingcat total weight??

[sm=shades_smile.gif]Raf,
Did'nt take the wrong way:)

Verticals, that was one of my other reasons for a bigger engine:D Although the P120 was plenty fast enough for me flat out, I could of...
Forum: RC Jets
06-29-2007, 12:17 PM
Replies: 22
Views: 2,906
Posted By Ian Shaw

RE: Kingcat total weight??

The P-120 is a superb engine for the Kingcat. It's just that I wanted to paint the model, more detail and put a bigger smoke tank in it, which of course is adding alot more weight to it. So I thought...
Forum: RC Jets
06-29-2007, 11:45 AM
Replies: 22
Views: 2,906
Posted By Ian Shaw

RE: Kingcat total weight??

Sandor,
to be honest, I have never felt that I needed the extra aileron movements on landing with crow brakes in. I guess I will stick to being uncool for the time...
Forum: RC Jets
06-29-2007, 07:29 AM
Replies: 922
Views: 144,056
Posted By Ian Shaw

RE: Comp ARF Flash update

I NOSE what you mean Fred!!!:D
Forum: RC Jets
06-26-2007, 02:17 PM
Replies: 22
Views: 2,906
Posted By Ian Shaw

RE: Kingcat total weight??

[/quote] also can i use more flaps ? or stick with the original settings , i wanted to slow it down some more.


Hi Sandor, I am no expert, but do you have crow brakes in on landing?, I have...
Forum: RC Jets
06-12-2007, 03:42 PM
Replies: 922
Views: 144,056
Posted By Ian Shaw

RE: Comp ARF Flash update

Mine came out at nearly 24lb's with a Jetcat 120, Behotec retracts, x2 Sanyo 2400 Nicads and a 3700 NIMH for ECU. I used these batteries instead of lipo's, as I knew I would have to add nose weight...
Forum: RC Jets
06-10-2007, 03:07 PM
Replies: 424
Views: 70,116
Posted By Ian Shaw

RE: A few pics from Wroughton

No Worries Dick, I will just remember to slow it down a little, next time. :D
Forum: RC Jets
06-01-2007, 04:11 PM
Replies: 14
Views: 1,988
Posted By Ian Shaw

RE: It was 40 years ago today...

Frank Whittle was born on June 1 1907, in the Earlsdon district of Coventry.
Forum: RC Jets
05-29-2007, 04:04 PM
Replies: 922
Views: 144,056
Posted By Ian Shaw

RE: Comp ARF Flash update

NICLAS, again, I have not used a heat blanket. But like yourself, I was a bit concerned about the stories I have heard on RCU,regarding the heat issues.
I can only say for peice of mind, I did a...
Forum: RC Jets
04-26-2007, 02:23 PM
Replies: 37
Views: 3,410
Posted By Ian Shaw

RE: smoke

Bukyem,
I have been down that route, and bought a gallon of the stuff. The results were ok, but nothing like was expecting. To be ownest I had better results with deisel. Now I am...
Forum: RC Jets
03-31-2007, 11:36 AM
Replies: 7
Views: 2,094
Posted By Ian Shaw

RE: Elite Force Pilot George Bush, on Sale 23.99

This is the fella!
Forum: 3D Flying!
01-13-2007, 10:47 AM
Replies: 36
Views: 4,480
Posted By Ian Shaw

RE: Best 3d plane for ys 160 Dingo

Weather is a bity choppy at the moment 30-40mph wind and rain. Might struggle a bit in that wind.. :) Dont worry I will let you know how it goes...
Forum: 3D Flying!
01-13-2007, 06:01 AM
Replies: 36
Views: 4,480
Posted By Ian Shaw

RE: Best 3d plane for ys 160 Dingo

With a friend from my club, we have managed to correct the problem. There was a slight twist in the back end of the fus. With a hot air gun and gradually twisting the fus it came back in. I guess...
Showing results 1 to 25 of 60
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.