RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: frank1947
Showing results 1 to 25 of 82
Search took 0.48 seconds.
Forum: RC Jets
11-15-2010, 12:35 AM
Replies: 75
Views: 30,583
Posted By frank1947

RE: DUBAI RC Club New Runway

Hey Darryl,
Once again many thanks for the info. Being from out of town, and not taking the directions you sent with me, I made some wrong turns and ended up totally lost. I am sure however to...
Forum: RC Jets
11-10-2010, 03:56 AM
Replies: 75
Views: 30,583
Posted By frank1947

RE: DUBAI RC Club New Runway

Hi Darryl, Thanks for the Map, Are some guys flying on days other than the weekend? Frank
Forum: Glow Engines
01-25-2009, 07:03 AM
Replies: 12
Views: 4,377
Posted By frank1947

RE: Suevia 25cc Glow engine Type 252

Hi Richard,
Just saw your message. Due to many resons have not finalised my model with the Suevia installed but hope to so so in the near future. As to your question I bought my engine with the...
Forum: ARF or RTF
06-01-2007, 10:17 AM
Replies: 0
Views: 681
Posted By frank1947

ultra Katana 50 Manual

Hi,

I purchased an Ultra Katana 50 ARF while travelling and on coming home I noticed the box did not contain the building manual. On Going to Ultra’s website site I did not find an...
Forum: ARF or RTF
05-30-2007, 08:30 AM
Replies: 1,865
Views: 325,412
Posted By frank1947

RE: GP Super Stearman

Ed, Thank you so much for your reply on the CG issue your idea sounds great and I amjust about to go to the w/shop to try it out. Ant ideas on the other issues I raised in post 909
I am...
Forum: ARF or RTF
05-25-2007, 10:48 AM
Replies: 1,865
Views: 325,412
Posted By frank1947

RE: GP Super Stearman

hi, I am overwhelmed with all the info on the Super Stearman I wish I had seen this post earlier. I just finished my Super and enjoyed every minute putting it together. This is by far the largest...
Forum: ARF or RTF
04-24-2007, 09:37 AM
Replies: 6
Views: 946
Posted By frank1947

RE: GP Superstearman 120

Again, thank you gents for the tips enclosed. Taking it apart may be a pain, but alot less expensive than buying a bigger car or trailer.
04-19-2007, 09:01 AM
Replies: 5
Views: 984
Posted By frank1947

RE: Grommet position on JR servos

Danny,
Just to ensure I got this right is there a simple diagram or photo showing this typical installation as it seems I have been doing it all wrong for years. One never stops learning in this...
Forum: Kit Building
04-17-2007, 11:56 AM
Forum: ARF or RTF
04-17-2007, 04:43 AM
Replies: 6
Views: 946
Posted By frank1947

RE: GP Superstearman 120

Oldscaleguy,

Much appreciate the input.
Forum: Kit Building
04-17-2007, 04:36 AM
Replies: 11
Views: 1,443
Posted By frank1947

Mico ballons and epoxy & epoxy and paint

I have 2 questions for any one who can help,

1- My building instructions require that I mix epoxy with Microbaloons to make a fillet , no mention of how much or in what ratio ? Why do you need...
Forum: ARF or RTF
04-12-2007, 09:19 AM
Replies: 6
Views: 946
Posted By frank1947

GP Superstearman 120

My GP Superstearman 120 is nearing completion and what a beauty, A couple of things I noticed and which worrried me
a- the hinges are all CA and I wondered if they would be strong enough for a...
Forum: ARF or RTF
04-12-2007, 09:01 AM
Replies: 4,223
Views: 541,834
Posted By frank1947

RE: GP Patty Wagstaff - Building & Flying

This is a wonderful thread,since I just purchased my Patti and will fit it with a DA 50. This will be my first gas engine so the info being offered is invaluable. I need to ask a couple of questions...
04-12-2007, 06:54 AM
Replies: 6
Views: 1,235
Posted By frank1947

RE: JR FINALLY GOES 2.4GHZ!!!

can any kind soul explain to me what is the fuss all about. I have been using the JR 9303 pcm with no problems so far, what in heavens is so special about 2.4 ? Actually what is a 2.4? Maybe you can...
04-10-2007, 01:38 PM
Replies: 4
Views: 849
Posted By frank1947

RE: Which GP Flat out and recomended set up???

To elkiwi,

I bought and built the turmoil and cap 580 Paul is right they are a pain to build specially if you have not worked with foam and CA before. I replaced the standard motors with...
04-03-2007, 12:30 PM
Replies: 4
Views: 986
Posted By frank1947

RE: great planes yak 55 flightflex plane

I bought one a few months ago and can offer the folowing, they are "almost " indestructible on grass, Slightly underpowered, at a later stage you could upgrade to a brushless motor and get better...
03-31-2007, 12:48 PM
Replies: 21
Views: 10,183
Posted By frank1947

RE: paint to match ultracote

Skymortar, could you advise if auto paint can be brushed on rather than sprayed ? and what is latex paint ? if used is that fuel proof ?
03-31-2007, 10:15 AM
Replies: 2
Views: 557
Posted By frank1947

paints for planes (balsa)

Being in an area where hobby supplies are almost non existant can any one advise me on what paint to use on a balsa sheet model plane ? Availability are acrylic paints (water soluble ) commercial...
03-31-2007, 06:53 AM
Replies: 2
Views: 532
Posted By frank1947

RE: 6V regulator

Maybe someone can explain to me what is a matchbox ? Thank you.
03-14-2007, 10:27 AM
Replies: 18
Views: 1,648
Posted By frank1947

RE: 6.0 Volt Question

Where does one find the info on what servo can take what voltage? I use JR and HiTec servos only where can I get the info on whether the servo can or cannot use what voltage.
03-14-2007, 03:33 AM
Replies: 18
Views: 1,648
Posted By frank1947

RE: 6.0 Volt Question

Does this mean that the voltage (i.e. 6V ) is only a problem for the servos but not for the receiver?
Forum: ARF or RTF
03-07-2007, 05:45 AM
Replies: 0
Views: 752
Posted By frank1947

GP Superw Stearman 120

I am just finalising my GP Super Stearman 120 fitted with an OS 4 Stroke FS 1.20 with pump. A fellow modeller advised me that on landing the Stearman, if not coming in with enough speed, had a nasty...
03-01-2007, 08:42 AM
Replies: 11
Views: 7,228
Posted By frank1947

RE: JR servos ST 126 MG

For what its worth, I have been advised by my hobby shop who contacted support that for those with concerns on the ST125MG, the following test can be used. Connect using a 6 volt battery and if you...
02-27-2007, 12:19 PM
Replies: 11
Views: 7,228
Posted By frank1947

RE: JR servos ST 126 MG

Thank you for your answer. How or what test should I perform to ensure my servos(ST125MG) are ok? Is a range test enough? Once they prove to be ok could or would they possibly be a problem later on...
02-27-2007, 05:33 AM
Replies: 11
Views: 7,228
Posted By frank1947

RE: JR servos ST 126 MG

Hi Danny,

I am currently building a super Stearman by GP and just love the looks and quality of this model. I also purchased for this model a flight pack using the ST125MG servos. Now this may...
Showing results 1 to 25 of 82
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.