RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: Joe Petro
Showing results 1 to 25 of 500
Search took 0.80 seconds.
Forum: Unusual R/C
08-19-2020, 05:04 PM
Replies: 4
Views: 3,614
Posted By Joe Petro

hydro foam https://youtu.be/YY0Y64nfGFQ

hydro foam
https://youtu.be/YY0Y64nfGFQ
Forum: Speed - RC Nitro Boats
01-26-2020, 04:55 PM
Replies: 7
Views: 6,072
Posted By Joe Petro

Good stuff Rod! Air cooling makes it that much...

Good stuff Rod!
Air cooling makes it that much simpler...
Forum: Speed - RC Gas Boats
10-25-2016, 04:10 PM
Replies: 3
Views: 1,058
Posted By Joe Petro

Looks good! Fast and stable! Try the 2716/2-20....

Looks good! Fast and stable! Try the 2716/2-20. Works excellent on mine.
Forum: RC Boats General Discussion
10-25-2016, 04:01 PM
Replies: 4
Views: 568
Posted By Joe Petro

Check out the latest issue of Robot magazine. It...

Check out the latest issue of Robot magazine. It has one of our Tugster tug boats setup for autonomous missions.
Forum: Speed - RC Gas Boats
05-03-2016, 10:21 AM
Replies: 14
Views: 1,532
Posted By Joe Petro

Very nice build. We need some video! Joe

Very nice build.
We need some video!

Joe
Forum: Speed - RC Nitro Boats
05-03-2016, 10:19 AM
Replies: 4
Views: 927
Posted By Joe Petro

Just to be clear, we have our hi-temp silicone...

Just to be clear, we have our hi-temp silicone manufactured for us.
Tim has good products, but they are not the same.

Joe
Forum: Speed - RC Gas Boats
06-06-2015, 06:20 PM
Replies: 9
Views: 912
Posted By Joe Petro

We don't recommend our pipe for an outboard. It...

We don't recommend our pipe for an outboard. It will not end well...
The only pipe we recommend for our Gas Tunnel hull is the QD outboard pipe.
Very good power and it keeps the weight closer to...
Forum: RC Scale Boating
12-18-2014, 12:31 PM
Replies: 26
Views: 20,310
Posted By Joe Petro

Just to be clear, Our Tugster (with our motor and...

Just to be clear, Our Tugster (with our motor and ESC) will run about 80 minutes with a 5000 mah LiPo 2S pack.
When used with 2 of our 6v Gel Cell batteries, it goes to over 3 hours.

That 4600...
Forum: Speed - RC Gas Boats
08-22-2014, 03:32 AM
Replies: 4
Views: 2,529
Posted By Joe Petro

It sounds like you are flooding it. Open the...

It sounds like you are flooding it. Open the choke, hold the throttle full open and pull the starter until it pops or something.
Return the throttle to low or idle.
It should start.

I don't...
Forum: Speed - RC Gas Boats
07-10-2014, 07:40 PM
Replies: 8
Views: 1,518
Posted By Joe Petro

http://www.rcuniverse.com/forum/attachment.php?att...

http://www.rcuniverse.com/forum/attachment.php?attachmentid=2013301
Forum: Speed - RC Gas Boats
07-02-2014, 06:49 PM
Replies: 8
Views: 591
Posted By Joe Petro

Now that you mention it, I don't see how...

Now that you mention it, I don't see how either... I need to read these posts more carefully before I respond. I thought he said that it quit and there was water in the carb. Didn't see the water in...
Forum: Speed - RC Gas Boats
07-02-2014, 05:42 PM
Replies: 8
Views: 591
Posted By Joe Petro

Your water pump has a ruptured diaphragm. Replace...

Your water pump has a ruptured diaphragm. Replace the pump...

Joe
Forum: RC Boats General Discussion
06-27-2014, 05:41 PM
Replies: 11
Views: 606
Posted By Joe Petro

Not on a 26 inch boat...

Not on a 26 inch boat...
Forum: Speed - RC Gas Boats
04-25-2014, 10:44 AM
Replies: 14
Views: 1,108
Posted By Joe Petro

Glue in a rear brace so it can't move back and...

Glue in a rear brace so it can't move back and use rubber bands to hold it in place.
Forum: Speed - RC Gas Boats
04-25-2014, 08:48 AM
Replies: 14
Views: 1,108
Posted By Joe Petro

Run it and let us know how it goes. Joe

Run it and let us know how it goes.

Joe
Forum: Speed - RC Gas Boats
04-25-2014, 05:44 AM
Replies: 14
Views: 1,108
Posted By Joe Petro

Have you actually tried this to find that it...

Have you actually tried this to find that it didn't work? You never know, this may be the new thing!

We tested many strake locations on the EV during development, but they were always symmetrical....
Forum: Speed - RC Gas Boats
04-24-2014, 06:11 PM
Replies: 14
Views: 1,108
Posted By Joe Petro

I actually recommended that he leave them as is....

I actually recommended that he leave them as is. He already glassed over them and I suggested that he try it and see what happens.
It might work better!

Most racing Vee hulls will list or lean to...
Forum: Speed - Electric
03-21-2014, 04:36 PM
Replies: 5
Views: 4,392
Posted By Joe Petro

Try to get the boat balanced as much as possible...

Try to get the boat balanced as much as possible before you put the decks on. You may need to change things (Dremel) to get the packs far enough forward.

We are testing a prototype mount for 56 mm...
Forum: Speed - RC Gas Boats
03-13-2014, 08:48 PM
Replies: 35
Views: 9,780
Posted By Joe Petro

Primer and spot putty will take care of that.

Primer and spot putty will take care of that.
Forum: Speed - RC Gas Boats
03-13-2014, 12:27 PM
Replies: 35
Views: 9,780
Posted By Joe Petro

Looks excellent! Flip those trim tab brackets...

Looks excellent! Flip those trim tab brackets over for easier adjustment.
Also put the nut just under the screw head for the same reason.

Very nice build.

Joe
Forum: Speed - RC Gas Boats
03-04-2014, 07:19 PM
Replies: 4
Views: 718
Posted By Joe Petro

Zippkits...

Zippkits...
Forum: Speed - RC Gas Boats
02-17-2014, 07:57 AM
Replies: 119
Views: 20,285
Posted By Joe Petro

http://www.rcuniverse.com/forum/attachment.php?att...

http://www.rcuniverse.com/forum/attachment.php?attachmentid=1969461
Forum: Speed - RC Gas Boats
02-13-2014, 07:50 AM
Replies: 119
Views: 20,285
Posted By Joe Petro

Wow! You like living on the edge, don't you...

Wow!
You like living on the edge, don't you Ron? Or is that just the morphine talking...
Forum: Speed - RC Gas Boats
01-09-2014, 07:40 AM
Replies: 126
Views: 14,435
Posted By Joe Petro

Very nice work on the cat! I am a big fan of...

Very nice work on the cat!
I am a big fan of the work you do. I know how much time and effort goes into these things and you are doing good.

Keep the pictures coming. I need ideas for a new wood...
Forum: Speed - RC Gas Boats
12-22-2013, 12:48 PM
Replies: 14
Views: 3,532
Posted By Joe Petro

The 670 is perfect for this boat. Joe

The 670 is perfect for this boat.

Joe
Showing results 1 to 25 of 500
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.