RCU Forums - Search Results

Search: Posts Made By: rockwell

Showing results 1 to 6 of 6
Search took 0.48 seconds.

Forum: E-Flite Helicopters

08-08-2006, 11:15 PM

Replies: 4,787

E-FLIGHT BLADE CP

Views: 527,250

Posted By rockwell

RE: E-FLIGHT BLADE CP

I just built up a bcp with separates to use my dx6 with. Bought a crashed blade with a bad 4 in 1 for $60. I mounted a e-flite 2 in 1 and a gws pg-03 gyro on it along with my dx6's reciever. I'm...

Forum: E-Flite Helicopters

08-08-2006, 10:52 PM

Replies: 1,322

Eflite Blade CX

Views: 203,167

Posted By rockwell

RE: Eflite Blade CX

Ok, I figured it out. I thought I was paying attention when I replaced the motors but in an act of stupidity, I reversed the motors or the plugs. The net effect was that the rotors were spinning...

Forum: E-Flite Helicopters

08-07-2006, 03:09 PM

Replies: 1,322

Eflite Blade CX

Views: 203,167

Posted By rockwell

RE: Eflite Blade CX

Tried that but I don't think it's a trim issue. I can get it to center but any rudder and the motor takes off with the heli spinning behind it. When holding in my hand and I rotate slightly, the...

Forum: E-Flite Helicopters

08-07-2006, 03:04 PM

Replies: 1,322

Eflite Blade CX

Views: 203,167

Posted By rockwell

RE: Eflite Blade CX

Have you put new motors in your cx? Any problems with yaw after you did it? My cx acts like the gyro's on steroids since I replaced my motors.

Forum: E-Flite Helicopters

08-07-2006, 02:25 PM

Replies: 1,322

Eflite Blade CX

Views: 203,167

Posted By rockwell

RE: Eflite Blade CX

Anybody out there replace the motors and then have a wildly uncontrollable yaw problem?

Forum: E-Flite Helicopters

07-04-2006, 11:46 PM

Replies: 1,322

Eflite Blade CX

Views: 203,167

Posted By rockwell

RE: Eflite Blade CX

I charge thru the jst connector using my celectra. Just make a charge cable with a couple of banana plugs on the other end. BTW, when will you get your CP PRO?

Showing results 1 to 6 of 6