RCU Forums - Search Results

Search: Posts Made By: lancer367

Showing results 1 to 12 of 12
Search took 0.46 seconds.

Forum: Beginners

06-26-2010, 08:57 PM

Replies: 1

tenergy batteries

Views: 487

Posted By lancer367

tenergy batteries

Does anyone have any experience with tenergy batteries as far as quality and lifespan as compared to Parkzone or Eflite.

Forum: ARF or RTF

06-17-2010, 11:25 PM

Replies: 5

T 28 Trojan control problem

Views: 1,034

Posted By lancer367

T 28 Trojan control problem

I have a T 28 Trojan and on my forth flight it went into a dive twice and I had no control. I was able to recover before it hit the ground. It was as though I had lost the bind to the aircraft. I am...

Forum: Beginners

06-17-2010, 10:45 PM

Replies: 3

T 28 Trojan control problem

Views: 603

Posted By lancer367

T 28 Trojan control problem

I have a T 28 Trojan and on the forth flight it went into a dive and I had no control over the aircraft. Both times I was able to get control back before it hit the ground, but it was like I had lost...

Forum: Crash & Rebuild

05-21-2010, 10:49 PM

Replies: 0

ultra micro p 51 tail

Views: 488

Posted By lancer367

ultra micro p 51 tail

Quick tip for the weak tail on the p 51. I took a piece of .040 carbon rod about 2 inches long, cut a slot for it in the tail sarting from the rudder slot about 1 inch above stab and going forward at...

Forum: Speed - RC Nitro Boats

03-22-2010, 10:07 PM

Replies: 2

Go engine for Thundercat

Views: 571

Posted By lancer367

Go engine for Thundercat

Was wondering if anyone has put a go engine in a Thundercat 31. Tired of messing with the dynamite. Have heard good things about the go engines and need advice on which one would work best in this...

Forum: Speed - RC Gas Boats

01-01-2010, 03:26 PM

Replies: 3

maxcat

Views: 1,249

Posted By lancer367

maxcat

Does anyone out there know where a cowl can be purchased for a 57" maxcat.

Forum: Speed - RC Gas Boats

12-24-2009, 11:51 PM

Replies: 178

My MaxCat build

Views: 52,907

Posted By lancer367

RE: My MaxCat build

how do you get these plans and have them printed off to make templates. I have built three 1/8 hydros from wood kits so I think I could do one of these. Any help getting me started would be...

Forum: Speed - RC Nitro Boats

12-23-2009, 06:00 PM

Replies: 1

prop balancing

Views: 1,169

Posted By lancer367

prop balancing

I am wondering about working both sides of a prop when balancing. I have seen it done both ways, but have been told never touch the backside, only the face. Can anyone tell me if it matters.

Forum: Speed - RC Nitro Boats

12-15-2009, 01:05 AM

Replies: 2

thundercat 31

Views: 543

Posted By lancer367

RE: thundercat 31

thank you. is there a reason it is so hard on this boat over say a 1/12 hydro.

Forum: Speed - RC Nitro Boats

12-15-2009, 01:03 AM

Replies: 1

thundercat 31 x447 prop

Views: 660

Posted By lancer367

thundercat 31 x447 prop

has anyone tried an octura x 447 3 blade on the tc 31. I was thinking of giving it a try, but wanted to see if anyone has tested it out yet.

Forum: Speed - RC Nitro Boats

12-14-2009, 06:54 PM

Replies: 4

Propeller help!

Views: 810

Posted By lancer367

RE: Propeller help!

The props recommended are probably the best. Just wanted to say from experience that you may want to stay away from plastic and composite. Whenever I have run them if the prop ever leaves the water...

Forum: Speed - RC Nitro Boats

12-14-2009, 06:46 PM

Replies: 2

thundercat 31

Views: 543

Posted By lancer367

thundercat 31

has anyone out there had problems replacing the silicone stuffing tube. the old one came out easy enough, but the new one wouldn't go in. had to sand it down a little and even then had to put alot of...

Showing results 1 to 12 of 12