RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: thedub88
Showing results 1 to 25 of 210
Search took 0.50 seconds.
08-19-2007, 11:19 AM
Replies: 12
Views: 1,404
Posted By thedub88

RE: how long to charge

so I charge for .3 hours, which is what, 20 min?
08-18-2007, 06:08 PM
Replies: 12
Views: 1,404
Posted By thedub88

RE: how long to charge

so............. how long do I charge a 18oomah nicd @ 6 amps?
08-18-2007, 04:06 PM
Replies: 12
Views: 1,404
Posted By thedub88

how long to charge

how long do I charge a 1800 mah nicd battery with a 6 amp fast charger?
06-09-2007, 02:44 PM
Replies: 5
Views: 685
Posted By thedub88

RE: Break in after nitro % change?

OK guys I just start using the new stuff
thanks alot!!
06-09-2007, 11:25 AM
Replies: 5
Views: 685
Posted By thedub88

Break in after nitro % change?

I have a HPI RS4-3 18SS (original not the +). I bought 10% nitro fuel and a bunch of medium plugs, which made my engine overheat.
After reading and asking alot of questions, I found that I'm...
05-30-2007, 11:30 AM
Replies: 11
Views: 1,118
Posted By thedub88

RE: rs4 3 2 speed probs

What do you mean "it not shifting right into 2nd" its not sopposed to. From a stop, it should shift when the rpms gets up to max, it should take 3 to 4 seconds
05-27-2007, 07:57 AM
Replies: 11
Views: 1,118
Posted By thedub88

RE: rs4 3 2 speed probs

Make sure the black arm is not stuck inside the housing. Mine was stuck right from the factory!!!

Another possability is that the adjustment screw it too loose and it starts in second gear. ...
05-26-2007, 07:52 AM
Replies: 1
Views: 987
Posted By thedub88

RE: hpi nitro rs4 roto starter

make sure the drill is spining the correct direction. The shaft should spin counter clockwise, and you should hear "pop pop pop".

If it spins counter clockwise and you don't hear the pops, and...
05-23-2007, 11:38 AM
Replies: 6
Views: 748
Posted By thedub88

RE: Hpi 100cc gas tank

primers leak (air)
05-22-2007, 10:28 AM
Replies: 9
Views: 843
Posted By thedub88

RE: cvd center shafts for rs4 3

My bad, I looked quick, I see it now
never seen those before
05-21-2007, 07:02 PM
Replies: 9
Views: 843
Posted By thedub88

RE: cvd center shafts for rs4 3

there is no cvd for the center because it is a strait shaft, no bend
what hellsgod showed is for the front or the back
05-21-2007, 06:51 PM
Replies: 13
Views: 1,007
Posted By thedub88

RE: Building The Ultimate Nitro RS4 18SS

get the racing clutch (set to the middle holes) http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXLST3&P=7
tuned pipe (turbo if your not going to race)
new tires, (stock suck!!!!!!!!)I got these...
05-18-2007, 10:07 AM
Replies: 3
Views: 737
Posted By thedub88

RE: hpi nitro rs4 3 evo roto start problems

ya the shock is in the way, What I do is just go to one side of the shock or the other(doesn't matter which) not through it. The shaft is at an angle but it still works.

Just remember to make...
05-14-2007, 06:11 PM
Replies: 6
Views: 649
Posted By thedub88

05-14-2007, 05:55 PM
Replies: 7
Views: 674
Posted By thedub88

RE: begginer

20 mph???!!!! Give me a break!!!! don't bother

go nitro, nitro's better, cheaper, longer run times, plus they go 50mph+!!!!!


20mph dum!!
05-14-2007, 05:49 PM
Replies: 12
Views: 805
Posted By thedub88

RE: Where to read temp.

you have to adjust it

if your on board temp reading is different than your hand held, move the lead up to the next fin if it's says it's hotter, and move it down a lead if it's colder.

you...
Replies: 11
Views: 657
Posted By thedub88

RE: resizing photos

Do you have windows? Just use paint brush
05-07-2007, 03:47 PM
Replies: 8
Views: 698
Posted By thedub88

RE: im thinkin of getting one of them air fiters

Ya it's over kill, not necessary, but I bought it so I might as well use it:eek:
05-07-2007, 03:33 PM
Replies: 10
Views: 716
Posted By thedub88

RE: I can't break in my engine :( Please Help!

If the engine will run if you give it gas, your idle is too low
05-07-2007, 03:25 PM
Replies: 8
Views: 698
Posted By thedub88

RE: im thinkin of getting one of them air fiters

I got one of those filters before I read they suck. It wouldn't even fit under the body, so I had to modify it a bit.

Foxy 42 " no bling factor"? come on! alot of people think my intake...
05-04-2007, 07:00 AM
Replies: 5
Views: 605
Posted By thedub88

RE: glow plug initor

I bring 2, 7.2 stick packs with me everytime i go to bash just in case. Sometimes I need the other battery, but my batteries are like 15 years old so they don't last

New batteries will last...
05-02-2007, 12:57 PM
Replies: 11
Views: 1,470
Posted By thedub88

RE: Ram Air!!!

Forced induction doesn't work in two stroke engines. Turbos and superchargers are forced induction, read the 10 zillon threads on them and you'll learn why they don't work
05-01-2007, 05:07 PM
Replies: 5
Views: 747
Posted By thedub88

RE: Whats the difference?

The only thing i can think of is gearing. The hp doen't get you 50 mph (81)kmh, the gearing does. The hp just gets you there quicker. They both may get you to 50 mph, but the evo+ with the 2.2 hp...
05-01-2007, 04:57 PM
Replies: 2
Views: 432
Posted By thedub88

RE: Need help understanding how to upgrade a brake system

What will make your jato stop faster is turning down the brakes. Locking them up is making it go father than you want. I think it was Issic Newton that said "an object in motion wants to stay in...
04-29-2007, 09:00 AM
Showing results 1 to 25 of 210
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.