RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: lmisner
Showing results 1 to 11 of 11
Search took 0.72 seconds.
Forum: JR Radio & Spektrum Radios
05-23-2011, 06:22 AM
Replies: 14
Views: 1,150
Posted By lmisner

RE: S791 retract wiring help

I've run that servo on 5 cell packs and not experienced any problems, and was surprised to see the voltage proviso on Horizon's website, but YMMV. A simpler solution would be to solder a diode in...
Forum: JR Radio & Spektrum Radios
09-25-2009, 11:09 AM
Replies: 1
Views: 747
Posted By lmisner

Spektrum Antenna for 10X

Hi:

I have broken the plastic Spektrum antenna adapter that screws into the adjustable ball several times now. Does anybody make a metal adapter or better yet can the 12x antenna be retrofitted...
Forum: Electric Pattern Aircraft
06-05-2006, 11:24 AM
Replies: 40
Views: 21,485
Posted By lmisner

RE: World models groovy 50 F3A

Hey Guys:

I am putting an Eflite Power 60 (same as AXI 4130?) and a 6s pack in my Groovy. Has anyone put any cooling holes for the battery in the belly pan behind the wing? How about in the...
Forum: YS Engines Support
04-22-2006, 05:48 PM
Replies: 1
Views: 530
Posted By lmisner

YS 140L Header Problem

Hi:

My Johnson header backed out today in flight , so I finger snugged the header nut back in like I usually do and started to snug it with a wrench, when, you guessed it, the nut sheared,...
Forum: Team RCU - Don Szczur
04-11-2006, 11:26 AM
Replies: 5
Views: 1,381
Posted By lmisner

RE: Pit stop servo change- Matchmaker

Hi Don:

It sounds like the device is actually programming the center and end points of the servo, as can be done with Hitec servos and their programmer. Is this the case, or is something else...
Forum: Electric Pattern Aircraft
11-24-2005, 09:05 AM
Replies: 4
Views: 1,320
Posted By lmisner

RE: Groovy 50 Conversion questions

Hi:

I don't know if it is overkill, but this is about the same set up that I am going to use. It appears that the E-Flite 60 is the same as the AXI 4130, which is what I was going to use...
Forum: JR Radio & Spektrum Radios
11-22-2005, 08:59 PM
Replies: 5
Views: 1,009
Posted By lmisner

RE: 10X Idle up

Hi Len:

Thanks, that was it. I thought I knew most of the ins and outs of the 10X until I read your article. Lots of good stuff.

Lonnie Misner
Forum: JR Radio & Spektrum Radios
11-22-2005, 12:36 PM
Replies: 5
Views: 1,009
Posted By lmisner

10X Idle up

Hi Danny:

I wanted to do an idle up for both my H9 Sukhoi and my 2m Typhoon 2000. I ran across Len Alessi's great article and set it up per the article. Everything went OK for the T2K, but...
Forum: RC Pattern Flying
10-08-2005, 10:15 AM
Replies: 1
Views: 599
Posted By lmisner

Help identify coupler

Hi All;

I have a coupler and anti-vibe mount for the coupler and I don't know who makes them, since I purchased the engine (YS 1.40L) Johnson header, Hatori pipe and coupler from another modeler...
Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service
06-09-2005, 11:10 AM
Replies: 1
Views: 589
Posted By lmisner

HS-5245MG

Hi:

I have a two part question. Number 1 is will there be a karbonite or nylon gear version of the 5245MG, something like the JR DS3421SA? I am thinking of using them as elevator servos...
Forum: JR Radio & Spektrum Radios
05-02-2004, 07:28 AM
Replies: 3
Views: 565
Posted By lmisner

Range problem w/50MHz

Hi Danny:

The problem I have is, I am getting drastically reduced range on my new 6 meter stuff compared to my 72 MHz stuff. Initially I noticed it on my 10X on Ch 06 with a 649 Rx in my...
Showing results 1 to 11 of 11


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.