RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: ashman71
Showing results 1 to 14 of 14
Search took 0.40 seconds.
Replies: 56
Views: 4,387
Posted By ashman71

RE: Official RAVEN ST Thread

I'm running Dirt Hawgs on the rear. Great tyres, last for ages..
Replies: 56
Views: 4,387
Posted By ashman71

RE: Official RAVEN ST Thread

Hey, great to hear others are running this truck. I've had a Raven ST for a couple of months, very happy with it. My LHS raved about it as great value for money and I'd have to agree. I'm...
Replies: 6
Views: 537
Posted By ashman71

RE: repairing a servo

Hey,
I've stripped a few servos and have salvaged parts (cogs etc.) to make new ones from old. It's not hard if you're careful as those little gears are small and fiddly. Assuming you got the...
Replies: 6
Views: 697
Posted By ashman71

RE: Tires/Wheels

2 holes on opposite sides of the rim should be fine. My rims came pre-drilled with that configuration. It's mainly to prevent "bounce" on landing and over rough stuff. I have Dirt Hawgs on my...
Replies: 28
Views: 6,352
Posted By ashman71

RE: sportwerks raven st

Sounds like the same thing that happened to me.. Take off the wheel, did the axle snap where the small axle roll pin goes through? (this is the small metal pin that fits into the wheel hub - the...
Replies: 28
Views: 6,352
Posted By ashman71

RE: sportwerks raven st

Nice pics, great job. I've had the Raven for a few months and so far very happy with it. I've also posted a few times and not got much response so good to see a few more out there. For the...
Replies: 6
Views: 903
Posted By ashman71

RE: raven st rtr a lemon?

Hey, I've had a Raven for about 3 months - very happy with it so far and I'm bashing the hell out of it. The ESC shouldn't have died so soon - take it back to your LHS if you think that's what it...
Replies: 7
Views: 913
Posted By ashman71

RE: How do you know when to change the brush on a motor?

You can run it dead but this can be a pain if you're all ready to go and it stop/starts... Check the positive (red wire) side of the motor and if the small spring clip holding in the brush cannot...
Replies: 6
Views: 501
Posted By ashman71

RE: Sportwerks Raven ST - first impressions

Hey guys, there's another fairly recent Raven ST thread - posted 11/15/2006 "Sportwerks Raven" and I put up a few pics. Very happy with this truck so far...
Replies: 21
Views: 1,802
Posted By ashman71

RE: Sportwerks raven

Radio gear seems fine - two months and no glitches. The range is good and the trim settings work well. It feels pretty light weight (plasticy) but considering the price of the package I can't...
Replies: 21
Views: 1,802
Posted By ashman71

RE: Sportwerks raven

Hey! As per above post here's some photos..
ashman
Replies: 21
Views: 1,802
Posted By ashman71

RE: Sportwerks raven

Hey, great to hear others are running this truck. I've had my Raven ST for about 2 months and very happy so far. I've run it around 35 times on the original brushes and they only now need...
Replies: 5
Views: 559
Posted By ashman71

RE: run time mystery

Thanks people, very helpful - glad I found this forum. I will try the suggestions and likely go for some NimH batteries..
Replies: 5
Views: 559
Posted By ashman71

run time mystery

Hey,
First time post, new to RC and have read forums until my eyes are hanging out but can't find a solution...
I have a Sportwerks Raven ST, few weeks old - very happy for first truck. Came...
Showing results 1 to 14 of 14


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.