RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: Super E-MAXX
Showing results 1 to 24 of 24
Search took 0.43 seconds.
Replies: 3,214
Views: 431,894
Posted By Super E-MAXX

RE: The Official Traxxas Slash short-course race truck

In reference to the Proline Suspension Kit, I put it on my truck with the stock shocks. It handled good and tracked awesome. BUT I took a jump and landed and broke a front A-arm from the kit. I am...
Replies: 1
Views: 886
Posted By Super E-MAXX

SC10 & MM5700 brushless motor ?'s

I have a pretty much stock SC10 with a MM5700 esc / motor. I am in Iraq so heat is starting to be a problem again now that winter is leaving us. I am trying to tune down the speed a little bit to...
Replies: 12
Views: 4,038
Posted By Super E-MAXX

RE: Associated RC10 T4 Brushless motor/esc issues

Hey Thanks for all the help and suggestions. I tightened my diff up and it takes off like a rabbit now. Thanks again, now I can go play around in this sand in Iraq. If I have anymore problems that...
Replies: 12
Views: 4,038
Posted By Super E-MAXX

RE: Associated RC10 T4 Brushless motor/esc issues

Yes it sounds like a buzzing noise and I have tried to tighten it up and also loosen it, to no avail. It still does it.
Replies: 12
Views: 4,038
Posted By Super E-MAXX

RE: Associated RC10 T4 Brushless motor/esc issues

Oh yeah, the battery issue is being fixed as soon as the mail runs. I have two 2s 5000 Mah lipos on the way, since the esc has an internal lipo cutoff. That should help as soon as I check the...
Replies: 12
Views: 4,038
Posted By Super E-MAXX

RE: Associated RC10 T4 Brushless motor/esc issues

Thanks for the help. I will try your suggestions after I replace my rear shock tower that broke today. Also, the slipping noise only happens durring full throttle on take off, and as it gets up to...
Replies: 12
Views: 4,038
Posted By Super E-MAXX

Associated RC10 T4 Brushless motor/esc issues

I have a Associated RC10 T4 with a Novak 5.5 brushless motor with a Sphere Competition TC Spec esc. I am running it with a 4200 Mah battery pack. My problem is when I leave the start finish line at...
Replies: 3
Views: 515
Posted By Super E-MAXX

RE: Associated RC10T4 Question

I am new to the electric motors also, so will a higher 27 turn motor run faster than say a traxxas 550 12 turn motor? Not sure how the turns work. I want something that will spank my competition over...
Replies: 3
Views: 515
Posted By Super E-MAXX

Associated RC10T4 Question

I am currently deployed in Iraq and purchased a RC10T4 from a soldier over here. It has a Novak GT7 esc, with a unknown motor type. I have done some researching and found a Trinity Co27 Monster Stock...
07-23-2007, 03:00 PM
Replies: 10,131
Views: 587,380
Posted By Super E-MAXX

RE: Official Nitro Evader ST Thread v2.0

I was thinking about putting a rc10gt clutchbell and spur gear in my evader, will it work?
07-18-2007, 06:41 AM
Replies: 10,131
Views: 587,380
Posted By Super E-MAXX

RE: Official Nitro Evader ST Thread v2.0

I have a nitro evader st with an OS .18CV-R. I have tore up the differentials in two different transmissions, and I have a brand new transmission that I am going to put in and rebuild the other two....
Replies: 20,623
Views: 1,302,210
Posted By Super E-MAXX

RE: The Evader Coalition ~ T.E.C.

I have a nitro evader st with an OS .18CV-R. I have tore up the differentials in two different transmissions, and I have a brand new transmission that I am going to put in and rebuild the other two....
Replies: 20,623
Views: 1,302,210
Posted By Super E-MAXX

RE: The Evader Coalition ~ T.E.C.

Need Help!!! I bought a nitro evader st from a friend. It has an os .18 engine on it. All it has been driven is to break it in. I got it and have stripped out 3 spur gears. Any help would be...
03-01-2007, 09:43 AM
Replies: 7
Views: 1,705
Posted By Super E-MAXX

T-MAXX 3.3 Center Drive Shafts

Has anyone had any problems with the center drive shafts on the tmaxx 3.3? I have torn up several and was wanting to switch to steel shafts. Any Suggestions?
Replies: 102
Views: 6,812
Posted By Super E-MAXX

RE: E-Savage/E-Maxx upgraded Motors

Do you run the S-600 with the stock Novak EVX or do you have to purchase another one for an E-MAXX?
02-05-2007, 07:07 AM
Replies: 10
Views: 2,471
Posted By Super E-MAXX

RE: T-maxx rear pipe?

Will the TSAIS dual rear exhaust fit a S-MAXX? I was thinking about putting one on my S-MAXX, and thought since it is the same chasis it would. Will I have any problems that anyone knows about? ...
01-06-2007, 06:00 PM
Replies: 29
Views: 3,217
Posted By Super E-MAXX

RE: Brushless E-Maxx!

Yes it is a bone stock E-MAXX I wanted to get the motor then start replacing things as needed. I have the money saved to buy a Novak brushless system. How much do you think I would be looking at if...
01-05-2007, 02:45 PM
Replies: 29
Views: 3,217
Posted By Super E-MAXX

RE: Brushless E-Maxx!

Thanks for the info on the 6.5 system, I am new to installing new motors in my emaxx. Is it a complicated thing or can a novice do it fairly quick. Also are there any modifications to the way the...
01-05-2007, 07:28 AM
Replies: 29
Views: 3,217
Posted By Super E-MAXX

RE: Brushless E-Maxx!

I AM LOOKING AT GETTING THE HV-MAXX 6.5 SYSTEM. I WAS WANDERING HOW IT WOULD KEEP UP WITH MY FRIENDS NITRO VEHICLE? AND IS THE 4.5 SYSTEM BETTER OR IS THE 6.5 SUFFICIENT?
12-19-2006, 07:20 AM
Replies: 1
Views: 711
Posted By Super E-MAXX

Best lipo setup for E-Maxx

What is the best lipo setup for a stock E-Maxx? I am wanting to go brushless, but i have heard that the Novak brushless system is ok, but the Mamba Monster Max is supposed to be better. Does anyone...
11-02-2006, 09:43 PM
Replies: 2
Views: 698
Posted By Super E-MAXX

Revo, Revo3.3, T-MAXX2.5R, OR T-MAX3.3????

I AM WANTING TO GET A NITRO MT. WHICH ONE SHOULD I GET? I PROBABLY WILL BE DOING MORE BASHING THAN RACING, BUT MIGHT RACE A LITTLE. NO TRACK OR GOOD STUFF IN THE AREA OF GEORGIA I LIVE IN TO...
11-02-2006, 10:33 AM
Replies: 82
Views: 8,666
Posted By Super E-MAXX

RE: Good reasons to set my Revo on fire and throw it off of a cliff:

I was thinking of buying a Revo 3.3 for my second MT. How hard are they to tune and how many times driving it until I would break a comrod
11-01-2006, 03:52 PM
Replies: 9
Views: 1,876
Posted By Super E-MAXX

RE: E-MAXX HV Brushless Motor Upgrade

Thanks for the help...the EVX I was talking about was for the brushless system. My exsisting EVX is tore up that is why I am just going to switch it to bruchless. Thanks.
11-01-2006, 07:52 AM
Replies: 9
Views: 1,876
Posted By Super E-MAXX

E-MAXX HV Brushless Motor Upgrade

I need help!!! I am going to purchase the Novak HV-Maxx brushless motor (4.5) for my E-MAXX. Tower Hobbies said all it requires is installing the motor with the EVX and it is ready to roll. Can...
Showing results 1 to 24 of 24


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.