RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: cna91
Showing results 1 to 25 of 30
Search took 0.47 seconds.
Forum: Gas Engines
06-25-2013, 09:06 AM
Replies: 161
Views: 31,177
Posted By cna91

RE: RCGF 26cc won't draw fuel

It has already found a new home. He was going to get new bearings and check out everything else on the inside...Not sure if he ever did. He moved away a couple months ago.
Forum: Gas Engines
06-25-2013, 08:51 AM
Replies: 161
Views: 31,177
Posted By cna91

RE: RCGF 26cc won't draw fuel

I know this isnt what you want to hear, but I did replace my carb with a genuine Walbro on my RCGF 20 ...and it was still very unreliable on start up. Especially once warm. I eventually bit the...
Forum: Glow Engines
03-24-2012, 02:08 PM
Replies: 13
Views: 8,825
Posted By cna91

RE: Saito FA-91 rebuild

Any idea what the size of the valve cover screws are? I seem to have had one vibrate out. Thanks guys.
Forum: RC Warbirds and Warplanes
02-08-2012, 04:53 PM
Replies: 14
Views: 6,189
Posted By cna91

RE: Which Warbird for 30cc

Anyone know of a 30CC size warbird that is NOT fiberglass? And not Hangar 9? I like Hangar 9, but they are super proud $$$ I am actually trying to help a friend find his next endeavor. The field...
Forum: ARF or RTF
11-18-2011, 05:39 PM
Replies: 35
Views: 5,602
Posted By cna91

RE: Kangke Monocoupe

Do you guys think that a saito 170R3 will be too much engine for the yellow, 1/5 scale monocoupe? the way I understand it, the 170R3 is about the same power as a 120 four stroke. But I thought I...
Forum: Gas Engines
11-06-2011, 05:13 PM
Replies: 121
Views: 30,567
Posted By cna91

RE: RCGF 20cc rear carb information thread.

I have some friends that tried that pop off thing on this carb. What is a good replacement carb for the 20CC motor? That one listed above, 793, looks like it has the pump bulb for the prime.???? ...
Forum: Gas Engines
10-25-2011, 05:11 PM
Replies: 121
Views: 30,567
Posted By cna91

RE: RCGF 20cc rear carb information thread.

Help. Some back ground. RCGF 20CC rear carb. It took forever to start engine the first time. It wouldn't draw fuel. Finally primed the carb and it ran. Broke it in as described in manual. ...
Forum: Glow Engines
10-08-2011, 11:09 AM
Replies: 14
Views: 1,394
Posted By cna91

RE: Saito 91 inverted problems.

Okay, the winners of the what's wrong with my engine sweepstakes is all those that suggested fuel. At the field today I was going through the process eliminating things, one at a time. Finally I...
Forum: Glow Engines
10-07-2011, 02:59 PM
Replies: 14
Views: 1,394
Posted By cna91

RE: Saito 91 inverted problems.

I thought about that. It still looked pretty new when I got it. No oily residue, no burn marks etc... Are these engines marked already or did you mark it when you took it apart. IF I have to go...
Forum: Glow Engines
10-07-2011, 11:31 AM
Replies: 14
Views: 1,394
Posted By cna91

RE: Saito 91 inverted problems.

I haven't seen any bubbles yet, but I will look closer next time. Also, the fuel is a month old and it runs in another Saito. 170R3. But then again, I have in-board glow on the 3 cyl.

Thanks...
Forum: Glow Engines
10-07-2011, 09:38 AM
Replies: 14
Views: 1,394
Posted By cna91

RE: Saito 91 inverted problems.

Power Master 20/20. Tank is inline with carb. Nothing has changed other than the worn out engine that WAS on it. Replaced with same size Saito. The old Saito was running fine other than the...
Forum: Glow Engines
10-07-2011, 07:07 AM
Replies: 14
Views: 1,394
Posted By cna91

RE: Saito 91 inverted problems.

I tried to do as you suggested. I never could get even a good top end. It died there too once the glow was removed. I kept it on and ended up burning out two glow plugs. Frustrated I took the...
Forum: Glow Engines
10-05-2011, 01:18 PM
Replies: 14
Views: 1,394
Posted By cna91

Saito 91 inverted problems.

Ok all, I have read numerous numerous threads, and I am now at my wits end with my Saito 91 inverted. Have spent a couple hours trying to get it to run at low end. Replaced stock plug with an OS type...
Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service
09-27-2011, 01:07 PM
Replies: 5
Views: 5,351
Posted By cna91

RE: Aurora 9 + Left Slider + Flaps

I have tried to move flaps to one of the 3 position switches like I had on my DX7. However even when setting up the flaps in the flaps menu and choose a switch, it has no effect unless I use the...
Forum: Gas Engines
09-26-2011, 10:32 AM
Replies: 161
Views: 31,177
Posted By cna91

RE: RCGF 26cc won't draw fuel

Edwin, I think you were the one I talked too quite a few months ago about that flying field in Lockhart. I have been flying there with them. Look up Lockhart Aeromodelers on Facebook.
Forum: Gas Engines
09-26-2011, 09:31 AM
Replies: 161
Views: 31,177
Posted By cna91

RE: RCGF 26cc won't draw fuel

Wildeone has the answer that made MINE run. Once we put fuel in the carb, it started and has started since then. Starts easily with the chicken stick without having to syringe fuel in. Thanks for...
Forum: Gas Engines
09-22-2011, 04:56 PM
Replies: 161
Views: 31,177
Posted By cna91

RE: RCGF 26cc won't draw fuel

I have a RCGF rear carb 20CC. It HAS the Walbro on it. Not sure which carb it is, but it does say Walbro on it. It WILL NOT draw fuel. The engine has never been started before. Took the carb off...
Forum: Aerodynamics
03-27-2011, 09:16 AM
Replies: 5
Views: 906
Posted By cna91

RE: Please help. Diagnose CG for H9 60 Stang

Thanks, I just wanted to make sure I was thinking the right thing. It looks like I was. I will report back with what I found out next time I go fly it. In the meantime, if there are anymore...
Forum: Aerodynamics
03-27-2011, 07:26 AM
Replies: 5
Views: 906
Posted By cna91

Please help. Diagnose CG for H9 60 Stang

I flew my new H9 60 sized Mustang yesterday. I bought it second hand. It is the older "marie" with the yellow tail. It has a saito 91 in it and it flies well. The only thing is...the manual calls for...
Forum: Park Flyers & Backyard Flyers
10-31-2010, 03:07 PM
Replies: 54
Views: 26,037
Posted By cna91

RE: Parkzone Stinson Reliant SR-10

Besides the recommended PZ servo, what are you guys using for the flap servo? I am hearing that even with the trying to loosen the hinge by moving it up and down still makes it need a servo with...
Forum: RC Warbirds and Warplanes
06-05-2010, 10:49 PM
Replies: 26
Views: 5,435
Posted By cna91

RE: Best 60 size P47 Thunderbolt

Yeah, you are 100% right. I think I over estimated the "sport" look of the wing. Every video I saw of this bird flying showed that it took off real quick like, so when I started, stopped and...
Forum: RC Warbirds and Warplanes
06-05-2010, 01:11 AM
Replies: 26
Views: 5,435
Posted By cna91

RE: Best 60 size P47 Thunderbolt

Not much to say here. The wind chaged to almost a straight crosswind right as I was going out...I shouldn't have tried, I should have waited for better conditions for my first time with a low wing,...
Forum: RC Warbirds and Warplanes
06-03-2010, 08:51 PM
Replies: 26
Views: 5,435
Posted By cna91

RE: Best 60 size P47 Thunderbolt

Yeah, I am hookin it up right now. I found my nice double cleviced rods with lock-nuts that were on my 15 pound Taylorcraft for the ailerons and am doing a couple z bends on rudder and elevator with...
Forum: RC Warbirds and Warplanes
06-02-2010, 08:35 PM
Replies: 26
Views: 5,435
Posted By cna91

RE: Best 60 size P47 Thunderbolt

Hey Fellas....do you guys trust these connectors on your Jug? The guy I bought it from has been flying it like this but I never have trusted these things...Why, I dont know, never had one fail,...
Forum: RC Warbirds and Warplanes
05-31-2010, 07:03 PM
Replies: 26
Views: 5,435
Posted By cna91

RE: Best 60 size P47 Thunderbolt

Clear as mud now :) ...great points both ways hmmmmm...what to do, what to do? :D
Showing results 1 to 25 of 30
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.