RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: pyro2
Showing results 1 to 25 of 101
Search took 0.44 seconds.
Replies: 29
Views: 10,254
Posted By pyro2

RE: I am new to RC...Any suggestions for a girl Truck or Car?

Aah... another Pyro who is into rc!!

Now if I can just get rockets to launch off of my T4 I'd be set...:D
Replies: 8
Views: 613
Posted By pyro2

RE: Money motor endbell?

I've actually "cut" the comm using a Dremel. If you carefully chuck the shaft end opposite of the comm into it, you can spin it up. Take a piece of hard flat metal and tightly wrap 400-600 grit wet...
Replies: 231
Views: 15,873
Posted By pyro2

RE: NEW E-MAXX!!!!!!!

As far as catering to the bashers, you might want to get on the phone with, oh say, a company like RPM. I've spoken to them several times and they make parts mostly for bashers. Why? Because at least...
Replies: 44
Views: 3,103
Posted By pyro2

RE: An electric rc vehicle with an electric generator on it.

Back to the splitting of H2O into its elements.... the few little bubbles you get from plunking a 9 volt battery in a glass of water would come nowhere near the energy potential that was in the...
Replies: 10
Views: 1,974
Posted By pyro2

RE: How to correctly top off shock oil in TC4?

It sounds a lot more complicated than it is... the first couple of shocks were tricky, mostly due to figuring out how to do it in a manner I liked. Now it is a 5-10 minute job per shock. Not bad at...
Replies: 10
Views: 1,974
Posted By pyro2

RE: How to correctly top off shock oil in TC4?

The instructions that came with my T4 were pretty thorough on how to do this. With the shock held upright half fill it with oil and work the piston a few times making sure to keep the top of it under...
Replies: 1
Views: 403
Posted By pyro2

T4 with a "crunchy diff"....

Hi gang...again...

I just heard some clicking noises coming from the diff on my T4. I removed the tranny and took it apart. Found nothing worn that I could see. Cleaned everything and relubed...
Replies: 7
Views: 2,507
Posted By pyro2

RE: Grass tires...Which are best?

Thank you! Sounds like Moabs or pin type tires are in my future.
Replies: 7
Views: 2,507
Posted By pyro2

Grass tires...Which are best?

Hi all,
Just wondering what people have found to be the best grass/lawn/back yard tire. I'm running an RC10 T4 with Proline Dirt Works tires on the rear, and don't think they are all that great for...
Replies: 37
Views: 2,557
Posted By pyro2

RE: Desert Bronco Build : IT'S A TUBER!!!!!

May not be the best forum ( heck, I have an RC10 T4 and you would think I'm one of, oh maybe 6 people on the planet to own one judging by this forum....;) ) but I really like what you are building!...
Replies: 5
Views: 1,056
Posted By pyro2

RE: t4 tranny

Do you have the manual for it? If so, adjust/tighten the diff to the specs stated... if not, crank it up until the plastic T-nut ( white plastic thing behind where the dog bone seats) until it...
Replies: 15
Views: 930
Posted By pyro2

RE: kit vs rtr

I have a blast with my T4 RTR, but I'd have to agree that it was a bit of a let down to just open a box and cram a battery in it and go. I know, I know, I could have gotten the race spec kit, but...
Replies: 20
Views: 1,828
Posted By pyro2

RE: lets see your T4

Not the prettiest T4 out there, but it does get beaten pretty hard:D

Lunsford titanium turnbuckles
Rpm bumper, front a-arms, ball ends and shock spacers
Checkpoint Money motor
Integy...
Replies: 3
Views: 390
Posted By pyro2

RE: T4

RPM GT2 front A-arm conversion would be a good thing...
Replies: 14
Views: 725
Posted By pyro2

RE: What replacement part do I need? (Rustler XL-5)

I'd also get the axle pins that the rim hex locks on to. Looks like you bent that one rather nicely....what did you hit? A warehouse? LOL!!
Replies: 2,109
Views: 104,590
Posted By pyro2

RE: Project AEROMAX - LB's first 3-speed..

I vote for the box trailer.... Then fill it with a custom A123 Lion battery pack putting out enough power to weld two battleships together, hooked to a brushless motor that requires liquid nitrogen...
Replies: 24
Views: 1,338
Posted By pyro2

RE: 4th of july fun

I may take my T4 with me to run around a bit after we get the $20,000 fireworks show set up. There is usually a few hours between getting it ready and then shooting it;)

I don't think strapping...
Replies: 2,109
Views: 104,590
Posted By pyro2

RE: Project AEROMAX - LB's first 3-speed..

I searched back a bunch of pages and can't find the link to that 1/4 scale truck that guy in europe built. Could you point me to that again? I want to show it to some folks:D
Replies: 96
Views: 4,834
Posted By pyro2

RE: Introduction and Questions

Well now, that would explain that.... yup! I'm an IJEET!!![sm=spinnyeyes.gif]
Replies: 96
Views: 4,834
Posted By pyro2

RE: Introduction and Questions

Brandon, mayhaps I'm an ijeet, but on you main web page under NiMH packs I can't find any sub c packs higher than 3800Mah, yet I know further back in this post you have links to 4200 and 4500's...
Replies: 33
Views: 1,893
Posted By pyro2

RE: I LOVE MY JOB!!!!!! but I need your help

The blade is down;) and I'm an east coast kind of person anyway... not a big fan of earthquakes[&:]
Replies: 33
Views: 1,893
Posted By pyro2

RE: I LOVE MY JOB!!!!!! but I need your help

Ya know.... something is just plain wrong here..... you are at work right? Makes me look at my job and really consider blading myself off:( I just get to calibrate massive dc electronic loads all day...
Replies: 130
Views: 8,687
Posted By pyro2

RE: The Official T4 Thread

A hop up option for you folks.... Try putting a set of the RPM GT2 front A arms w/ bulkhead. I have them on mine with the RPM wide front bumper. These things can take a beating;) I found out the hard...
Replies: 2,109
Views: 104,590
Posted By pyro2

RE: Project AEROMAX - LB's first 3-speed..

1/10th?!?!?! the tractor would be 33" alone!!![sm=spinnyeyes.gif]
Replies: 2,109
Views: 104,590
Posted By pyro2

RE: Project AEROMAX - LB's first 3-speed..

Good grief!! Those things are almost as long as a full size couch with the trailers on them[X(]
Showing results 1 to 25 of 101
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.