RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: saltonseadog
Showing results 1 to 25 of 50
Search took 0.43 seconds.
Forum: Traxxas Monster Truck forum
04-21-2008, 12:20 PM
Replies: 18
Views: 1,632
Posted By saltonseadog

RE: Watercooled Tmaxx

Just might keep it too cool!
Forum: Traxxas Monster Truck forum
02-20-2008, 12:08 AM
Replies: 584
Views: 35,924
Posted By saltonseadog

RE: HOW OLD ARE YOU????

Was flying my Dads hand built control line plane which he had held togather with rubber bands way before Cox made the PT Trainer.
Forum: Traxxas Monster Truck forum
02-20-2008, 12:02 AM
Replies: 51
Views: 4,386
Posted By saltonseadog

RE: Traxxas Big Bore

The Big Bores are nice. I have some, but I like the adjustable screw type better. I got a set for about the same or less. I just prefer them over the plastic spacers.
Forum: Traxxas Monster Truck forum
02-19-2008, 11:55 PM
Replies: 20
Views: 1,265
Posted By saltonseadog

RE: After-run Procedure Question.

The directions for my OS .18 says not to put ARO in the Carb because it can ruin the seals. I do both on my Traxxas motors tho.
Forum: Traxxas Monster Truck forum
01-30-2008, 02:25 AM
Replies: 6
Views: 955
Posted By saltonseadog

RE: t-maxx 3.3 wheelies?

Let the thing get broken in before you go tearing it up! LOL! After a few more tanks, the engine will run better. If you have it tuned right and the slipper clutch isn't too loose, you will be asking...
Forum: Traxxas Monster Truck forum
01-03-2008, 12:45 PM
Replies: 3
Views: 507
Posted By saltonseadog

RE: Taps for my 2.5?

Thanks! I have a dremel. I will get a bit!
Forum: Traxxas Monster Truck forum
01-03-2008, 12:25 AM
Replies: 3
Views: 507
Posted By saltonseadog

Taps for my 2.5?

Taps as in sundown, goodbye!

Couldn't get the wife's 2.5 SMAXX engine to run right the last couple times out, so set out today to tune it. It started OK, but when it got up to about 220...
Forum: Traxxas Monster Truck forum
01-02-2008, 12:02 PM
Replies: 53
Views: 3,158
Posted By saltonseadog

RE: Say Hello To The TQ3-2 With Charging Capabilities! Rate It!

I just take the batteries out and recharge them. It's not cool, but I didn't risk ruining my radio with a soldering iron.
Forum: Traxxas Monster Truck forum
12-24-2007, 06:15 PM
Replies: 8
Views: 717
Posted By saltonseadog

RE: OS.18 pipe

Are you talking about these guys?
http://www.fantomracing.com/
Forum: Traxxas Monster Truck forum
12-24-2007, 06:03 PM
Replies: 8
Views: 717
Posted By saltonseadog

RE: OS.18 pipe

Duh! I actually have the blue pipe on this truck, but I was thinking of upgrading this one and putting the blue pipe on my wife's truck.
I will check out the phantom!
Thanks!
Forum: Traxxas Monster Truck forum
12-24-2007, 04:15 PM
Replies: 8
Views: 717
Posted By saltonseadog

OS.18 pipe

This is probly a repeat question, but I did a serch and came up with nothing. I have a T-Maxx with an OS.18TM engine, and am running a stock Traxxas pipe. What would be a good pipe for this rig?
Forum: Traxxas Monster Truck forum
12-22-2007, 09:46 PM
Replies: 31
Views: 2,410
Posted By saltonseadog

RE: tmaxx thread

DUDE! This thread is older than 3% of the people on this forum!
Forum: Traxxas Monster Truck forum
12-15-2007, 01:24 PM
Replies: 32
Views: 2,473
Posted By saltonseadog

RE: Ebay engine

I buy a lot of my RC stuff on EBAY. I haven't been ripped off yet. I got a new 3.3 that didn't run very long before the conrod ruined the whole thing, but that was probly me running it too hot!
I...
Forum: Traxxas Monster Truck forum
12-15-2007, 01:07 PM
Replies: 7
Views: 649
Posted By saltonseadog

RE: Revo+Dog+Snow=BLAST!

My Lab runs with my trucks. She doesn't try too bite them anymore, just likes to race them.
Forum: Traxxas Monster Truck forum
12-11-2007, 11:22 PM
Replies: 7
Views: 621
Posted By saltonseadog

RE: tmaxx noise? plx help

I don't know about "usually" but I just had the bearing on the inside of the input shaft go bad and wreak a bit of havok. I don;t remember if this was the truck that was squeeling, but the next time...
Forum: Traxxas Monster Truck forum
12-07-2007, 09:41 PM
Replies: 20
Views: 1,884
Posted By saltonseadog

RE: Truck wont coast

A tiny bit inside, but not much. Just bad bearing, I suppose. I have ccleaned the gears up a bit, and smothed the case down where the bearing got hot and screwed it up, and I just might give it a...
Forum: Traxxas Monster Truck forum
12-07-2007, 08:33 PM
Replies: 7
Views: 403
Posted By saltonseadog

RE: anyone have this happen??

Sometimes I wish I would lose interest.
Forum: Traxxas Monster Truck forum
12-07-2007, 08:18 PM
Replies: 59
Views: 4,493
Posted By saltonseadog

RE: revo 3.3 whats one worth

Nothing quite like taking one out of the box for the first time!
Forum: Traxxas Monster Truck forum
12-07-2007, 08:14 PM
Replies: 20
Views: 1,884
Posted By saltonseadog

RE: Truck wont coast

Well,it didn't take long to find the culpret. A bearing on the input shaft (I think its the input shaft) the shaft the spur gear assembly is on , froze up. Of course, that put "just a little stress"...
Forum: Traxxas Monster Truck forum
12-07-2007, 05:54 PM
Replies: 20
Views: 1,884
Posted By saltonseadog

RE: Truck wont coast

Yes, its my only 2wd left. The wife wanted reverse. I will probly make it 4X4 next time I have the front apart.
Forum: Traxxas Monster Truck forum
12-07-2007, 05:09 PM
Replies: 20
Views: 1,884
Posted By saltonseadog

RE: Truck wont coast

Did put a diff in wrong once, but this one is 2WD so throw that idea out!
Forum: Traxxas Monster Truck forum
12-07-2007, 01:30 AM
Replies: 59
Views: 4,493
Posted By saltonseadog

RE: revo 3.3 whats one worth

"It's worth....about,,,about a hundred dollars"




"RainMan"
Forum: Traxxas Monster Truck forum
12-07-2007, 01:19 AM
Replies: 3
Views: 528
Posted By saltonseadog

RE: Pipe gasket

Thanks for the input! I tried to call LHS, but tey were too busy to answer phone when I called. I will probably just get one from them.
I went to the hardware store tonight, and could only find...
Forum: Traxxas Monster Truck forum
12-07-2007, 01:09 AM
Replies: 7
Views: 622
Posted By saltonseadog

RE: Shortening revo shafts?

Hijack Alert!!!!

Sorry to hijack your thread, ut one of my blue dust bbots got ripped up. My instinct told me fogetaboutit! Am I right?
Forum: Traxxas Monster Truck forum
12-06-2007, 06:11 PM
Replies: 20
Views: 1,884
Posted By saltonseadog

RE: Truck wont coast

I will tear into the tranny tonite if I have time. I hope its is simple, because I am.
Showing results 1 to 25 of 50
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.