RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: Gary Morris
Showing results 1 to 25 of 500
Search took 1.15 seconds.
02-24-2012, 06:02 AM
Replies: 0
Views: 2,074
Posted By Gary Morris

Dji Naza Quad Flame Wheel 450 Kit

After a long break from flying or posting, nearly 2 years, I have gotten back into RC after watching several first person videos on YouTube. The one Quad that really caught my eye is the Naza Flame...
10-19-2008, 02:17 PM
Replies: 9,014
Views: 1,998,438
Posted By Gary Morris

RE: New Mini Electric is here the Falcon 3D!!

After a very long absence, I thought I'd stop by to see how this thread is going or if it was still alive, I'm surprised that it is! I'm glad most of you have enjoyed the Falcon as much as I have, I...
07-19-2008, 10:49 AM
Replies: 3
Views: 2,359
Posted By Gary Morris

RE: locating blades for a 117

You can find blades here: http://www.shopatron.com/product/part_number=1-39675/113.0.385.377.0.0.0 hope this helps!

Gary Morris
07-19-2008, 10:45 AM
Replies: 60
Views: 17,945
Posted By Gary Morris

RE: ParkZone Vapor RTF/BNF

I would not recommend putting two batteries in series as this would damage the speed controller, adding another cell parallel would do little but add weight and mostly likely only lengthen the flight...
07-12-2008, 12:10 PM
Replies: 60
Views: 17,945
Posted By Gary Morris

RE: ParkZone Vapor RTF/BNF

I've had my Vapor for a few days, it has flown perfectly until this morning. As soon as I launched it I was getting severe glitching on rudder, throttle and elevator. I landed, tried rebinding and...
Forum: RC Sailboats
03-17-2008, 02:05 PM
Replies: 17
Views: 4,087
Posted By Gary Morris

RE: Big boat servo help needed

Sounds like you have a really old servo, probably Circa 1980's or earlier. All modern servos use three wires, positive, negative and a signal wire looking at the top of the servo lead where it plugs...
Forum: RC Sailboats
03-14-2008, 08:56 AM
Replies: 15
Views: 12,770
Posted By Gary Morris

RE: Graupner's newest sailboat, Trueblue

There are only two clubs in Tennessee, both of them are too far away to be of any help.

Thanks,

Gary
Forum: RC Sailboats
03-06-2008, 07:43 AM
Replies: 15
Views: 12,770
Posted By Gary Morris

RE: Graupner's newest sailboat, Trueblue

The price is higher but the quality of the kit is also higher, when compared to say a Nirvana it's far superior in quality. This boat will end up costing over $300.00 when finished or even more but...
Forum: RC Sailboats
03-05-2008, 08:03 AM
Replies: 15
Views: 12,770
Posted By Gary Morris

RE: Graupner's newest sailboat, Trueblue

I have done and exhaustive search on the web for as much information as I could find on the Trueblue with little to no additional information. I did find one interesting post on a French website...
Forum: RC Sailboats
03-04-2008, 04:16 PM
Replies: 15
Views: 12,770
Posted By Gary Morris

RE: Graupner's newest sailboat, Trueblue

Jan,

Thank you for the information, I've already made some adjustments based on your input, hopefully it won't be long til I can take it out again and test the changes.

Regards,

Gary...
Forum: RC Sailboats
03-02-2008, 08:06 PM
Replies: 15
Views: 12,770
Posted By Gary Morris

RE: Graupner's newest sailboat, Trueblue

Thank you for your feedback, I really appreciate it, I wish there were more sailors in my area with knowledge like yourself. Please give me a few recommendations on how I can correct these issues. I...
Forum: RC Sailboats
03-02-2008, 03:37 PM
Replies: 15
Views: 12,770
Posted By Gary Morris

RE: Graupner's newest sailboat, Trueblue

Here's a link to a video of the maiden voyage of the Graupner Trueblue; http://www.rcgroups.com/forums/showatt.php?attachmentid=1743007


Gary Morris
Forum: RC Sailboats
02-14-2008, 09:35 AM
Replies: 15
Views: 12,770
Posted By Gary Morris

RE: Graupner's newest sailboat, Trueblue

I haven't seen much reported about Trueblue yet, but once it's established in the marketplace I think you'll find that it's a good sailboat. It is well made, much better than the Nirvana, and...
Forum: RC Sailboats
02-12-2008, 06:05 PM
Replies: 15
Views: 12,770
Posted By Gary Morris

Graupner's newest sailboat, Trueblue

Graupner recently has introduced a new sailboat to it's line-up, the "Trueblue". Weight is 8 lbs 4 oz. ready to run, length is 1000 mm, height is 5-1/2 feet, width is 8-1/2 in. This is a one meter...
02-02-2008, 01:21 PM
Replies: 9,014
Views: 1,998,438
Posted By Gary Morris

RE: New Mini Electric is here the Falcon 3D!!

It just takes patients and loads of practice, do not take a step forward in your learning curve until you have accomplished the first step, hovering. You want to be able to hover while your...
12-25-2007, 08:21 AM
Replies: 9,014
Views: 1,998,438
Posted By Gary Morris

RE: New Mini Electric is here the Falcon 3D!!

Merry Christmas to all my friends here on RCU, and a special Merry Christmas to all you Falcon 3D owners, I hope Santa brings you everything you want and need!


Merry Christmas!

Gary
Forum: AutoGyros
12-25-2007, 08:12 AM
Replies: 4
Views: 3,232
Posted By Gary Morris

RE: New XPG Autogyro Maiden Flight Report

I had another flight on my XPG yesterday, winds were 5-15 and gusty, temperature was in the low 40's. I had a total of three flights and lost orientation twice while flying my XPG. It seems that when...
12-13-2007, 09:52 AM
Replies: 9,014
Views: 1,998,438
Posted By Gary Morris

RE: New Mini Electric is here the Falcon 3D!!

Just wanted to pop in and say hi, it's been ages since I posted here last. I still have three Falcons including my original which I did the first review on. They are all still flying fine and I've...
Forum: AutoGyros
11-10-2007, 11:11 AM
Replies: 15
Views: 7,153
Posted By Gary Morris

RE: Autogyro pusher AL III

Antonio I understand what your saying but there are fewer and fewer modelers that are builders and few have the time to devote to building something that is not already mostly finished. It's such a...
11-08-2007, 02:55 PM
Replies: 2
Views: 2,425
Posted By Gary Morris

Scale F3C E-Sky Belt CP Full Canopy

Here are a few pictures taken this morning of the new E-Sky, F3C Scale full body canopy. It comes completely finished in gleaming gel coated fiberglass. The color choices are; red, green, white and...
Forum: AutoGyros
11-06-2007, 08:44 AM
Replies: 15
Views: 7,153
Posted By Gary Morris

RE: Autogyro pusher AL III

Simply beautiful models, congradulations on all the success, have you ever thought about marketing this as a kit?

Gary
Forum: AutoGyros
11-06-2007, 08:29 AM
Replies: 4
Views: 3,232
Posted By Gary Morris

RE: New XPG Autogyro Maiden Flight Report

Thank you too, and thanks for providing such nice balsa blades for the kit, they work beautifully! I am just waiting on another opportunity to fly the XPG, it's so much fun. Seems all my other recent...
Forum: AutoGyros
11-03-2007, 09:11 AM
Replies: 4
Views: 3,232
Posted By Gary Morris

New XPG Autogyro Maiden Flight Report

On Thursday, I finally got a chance to fly my new XPG Autogyro produced by Dan Schuartz of Foamfly.com and I must say it was a 100% success. Lets back up a few days to the construction stage. The...
10-14-2007, 06:14 AM
Replies: 2
Views: 12,176
Posted By Gary Morris

RE: EPP Eagle Kit, A Must Have!

I now have half a dozen flights on my EPP Eagle and the more I fly it the more I love it. I have to say that in calm conditions it flies better than anything else I've ever flown as far as three...
10-08-2007, 01:40 PM
Replies: 2
Views: 12,176
Posted By Gary Morris

EPP Eagle Kit, A Must Have!

I just finished my EPP Eagle from http://shop.eflypower.com/shop/views.asp?hw_id=1374 and all I can say is WOW!! This thing is a bird magnet, I took it out to a local ball park and launched into a...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.