RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: chrisandalex1
Showing results 1 to 25 of 25
Search took 0.41 seconds.
04-22-2007, 08:39 PM
Replies: 1
Views: 578
Posted By chrisandalex1

Finally ran new MCD on New Track

Well after a long wait 3 motors that didn't work and having to ship everything internationally, I got to run my racerunner on our new track. I LOVE IT. I'll post some pictures of the track we built...
03-12-2007, 07:37 PM
Replies: 67
Views: 4,432
Posted By chrisandalex1

RE: 2 engines go bad in ten minutes

Some of these CY rings seal like crap (some don't seal at all---made in Taiwan) when they are new, and people sometimes even have a hard time starting a new engine.

Doug, are you using better...
03-11-2007, 10:40 PM
Replies: 67
Views: 4,432
Posted By chrisandalex1

RE: 2 engines go bad in ten minutes

Doug,
Since you built the engine I am putting in next(30.5 Esp mod & ported), and given that I have this fuel. And taking in to account that I have ordered the H1R oil. What are your...
03-11-2007, 10:03 PM
Replies: 67
Views: 4,432
Posted By chrisandalex1

RE: 2 engines go bad in ten minutes

They were complete engines purchased from Dave's motors.
03-11-2007, 09:02 PM
Replies: 67
Views: 4,432
Posted By chrisandalex1

RE: 2 engines go bad in ten minutes

Would different pipe materials make a difference here? Alluminum vs stainless vs Titanium pipes. Which of these metals dissipates heat the best? Is one better than the other for performace or is...
03-11-2007, 08:50 PM
Replies: 67
Views: 4,432
Posted By chrisandalex1

RE: 2 engines go bad in ten minutes

I have a lot of this VP C-16 fuel, and the best fuel here in mexico is 91 octane maybe. My idea is that I mix these fuels, and use the H1R oil at 25:1. I to love the smell of the racing fuel. there...
03-11-2007, 05:12 PM
Replies: 67
Views: 4,432
Posted By chrisandalex1

RE: 2 engines go bad in ten minutes

HI Guys,
This is the oil I was using, and we ran it at 20:1 for breakin.

Lucas Oil
Semi-Synthetic 2-Cycle High Temp Racing Oil

This product is an advanced technology TCW3 "low smoke"...
03-11-2007, 04:29 PM
Replies: 67
Views: 4,432
Posted By chrisandalex1

RE: 2 engines go bad in ten minutes

This is my thought as well. I am however still concerned about which oil to mix with the higher octane gas.
03-11-2007, 12:01 AM
Replies: 67
Views: 4,432
Posted By chrisandalex1

RE: 2 engines go bad in ten minutes

I don't know the answer, I am reading about it though.
03-11-2007, 12:00 AM
Replies: 67
Views: 4,432
Posted By chrisandalex1

RE: 2 engines go bad in ten minutes

is it really higher temp, or does is slow down the burn rate for a increase in the detonation time?
03-10-2007, 11:32 PM
Replies: 67
Views: 4,432
Posted By chrisandalex1

RE: 2 engines go bad in ten minutes

Can you please explain to me why you would do that.
03-10-2007, 10:57 PM
Replies: 67
Views: 4,432
Posted By chrisandalex1

RE: 2 engines go bad in ten minutes

BEL-RAY S2 is a high quality petroleum based lubricant developed for small motorcycles, mopeds and motor scooters. Bel-Ray S2 provides a high level of wear protection and reduces smoking and engine...
03-10-2007, 09:49 PM
Replies: 67
Views: 4,432
Posted By chrisandalex1

RE: 2 engines go bad in ten minutes

I was using a synthetic oil that seamed to mix well. to be on the safe side however, I have ordered Bel Ray H1R for the new motors.
03-10-2007, 05:48 PM
Replies: 67
Views: 4,432
Posted By chrisandalex1

RE: 2 engines go bad in ten minutes

I run the racing fuel because I have it. Actually I have a lot of VP C-16 fuel which is 115 octane. It should work very well for the motor. I know it is not necessary, but it should be better. It...
03-10-2007, 05:42 PM
Replies: 67
Views: 4,432
Posted By chrisandalex1

RE: 2 engines go bad in ten minutes

No, I wish it were that simple. Actually we ran them on the bench for quite a while, then ran them for a few minutes at 1/4 throttle, all the time checking them plugs to make sure we were good. ...
03-10-2007, 09:09 AM
Replies: 67
Views: 4,432
Posted By chrisandalex1

RE: 2 engines go bad in ten minutes

No Doug, But I am putting one of your 30.5 motors in now. I hope I have better success this time.
03-09-2007, 04:45 PM
Replies: 67
Views: 4,432
Posted By chrisandalex1

RE: 2 engines go bad in ten minutes

My Motive was not so much that as it is to try to stop what I have seen in many areas on the forums people reading too much into a situation. I hope everybody continues to respond in the same...
03-09-2007, 02:10 PM
Replies: 67
Views: 4,432
Posted By chrisandalex1

RE: 2 engines go bad in ten minutes

Just so that everybody understands this is just an unfortunate situation, Doug has been very helpful and has asked that I send the motors to him. Also, everybody I have spoken too has said that they...
03-09-2007, 09:53 AM
03-09-2007, 09:51 AM
03-09-2007, 09:03 AM
Replies: 67
Views: 4,432
Posted By chrisandalex1

RE: 2 engines go bad in ten minutes

I was using VP 110 octane fuel and a 20:1 mixture. I try to take some pictures and post them.
03-09-2007, 12:20 AM
Replies: 67
Views: 4,432
Posted By chrisandalex1

2 engines go bad in ten minutes

I just got my 2 new MCD race runners today. I bought the Dave's Motors bb17x - ESP Modified & ESP Fully Ported 27.2cc Zenoah Engine 4.25+ HP. Both of them inside of ten minutes have exactly the...
03-04-2007, 05:46 PM
Replies: 61
Views: 4,745
Posted By chrisandalex1

RE: MCD Company

WELL, As a consumer I think having all information available to me is important. Actually, this is why I love forums like this. After doing my own discovery, I still believe it is the best product...
02-22-2007, 10:33 PM
Replies: 9
Views: 722
Posted By chrisandalex1

RE: I'm new, and need some help

HI Everyone,
Thanks for the advise. As it turns out I ended up changing my order and I'm getting the new MCD Pro Truck Baja 1000. I'll let you know how it goes, and I'll post some pictures of it...
02-21-2007, 11:52 PM
Replies: 9
Views: 722
Posted By chrisandalex1

I'm new, and need some help

Hello, I am both new to the forum and to the hobby. I live in Mexico, and I don't have any hobby shops down the street. My friends and I are building our own course for off-road buggies, and buying...
Showing results 1 to 25 of 25


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.