RCU Forums - Search Results

Search: Posts Made By: Stewbaru

Showing results 1 to 4 of 4
Search took 0.41 seconds.

Forum: RC Truggy

01-25-2008, 12:21 AM

Replies: 406

Can I Have an official Mammoth ST thread?

Views: 46,373

Posted By Stewbaru

RE: Can I Have an official Mammoth ST thread?

If it has alloy or aluminium braces, this could be the cause.

Aluminium on aluminium is known to cause RF interferance. You could try to isolate or insulate the contacting alloy parts with...

Forum: Car Nitro & Gas Engines

05-31-2007, 07:28 PM

Replies: 6

OFNA Force 0.25 Needle Settings

Views: 4,437

Posted By Stewbaru

RE: OFNA Force 0.25 Needle Settings

Thanks Oz,

Your carbie is the same as mine, LSN on RHS of clutch.

Last time I checked, my (Now that I know it is) MSN was 8 turns out.
LSN is 1/2 turns below flush and HSN is about 3.5...

Forum: Car Nitro & Gas Engines

05-31-2007, 08:07 AM

Replies: 6

OFNA Force 0.25 Needle Settings

Views: 4,437

Posted By Stewbaru

RE: OFNA Force 0.25 Needle Settings

Ozzie,

Once again, the LSN is located in the carb housing and is oh\n the right hand side when viewed from clutch end?
If this is the case, then have been adjusting the MSN and haven't...

Forum: Car Nitro & Gas Engines

05-30-2007, 02:22 AM

Replies: 6

OFNA Force 0.25 Needle Settings

Views: 4,437

Posted By Stewbaru

OFNA Force 0.25 Needle Settings

Hey Y'all,

After getting some mis-information from a mate, I find I may have been adjusting the wrong needle on my force 25.

I need to reset the MSN to factory settings.
Can anyone advise...

Showing results 1 to 4 of 4