RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: kenneth1951
Showing results 1 to 17 of 17
Search took 0.41 seconds.
09-05-2007, 06:24 AM
Replies: 9
Views: 1,209
Posted By kenneth1951

RE: Aerofly Pro Idleup with Futaba 7cap?

:D[>:][X(] adle up is only throtel hold.
to get neg pitch you need to go into pitch settings
06-15-2007, 02:48 PM
Replies: 19
Views: 1,030
Posted By kenneth1951

RE: CRAP ! I messed with the engine setting. I need help

try thred lock between carb and engine and gasket on mufler
you can have a look at fuel pipe in gas tank they tend to split
but you are runing lean[X(][sm=drowning.gif][sm=punching.gif]
hope...
06-13-2007, 03:53 PM
Replies: 61
Views: 9,796
Posted By kenneth1951

RE: Welcome Hirobo!

hi i have a hirobo sceadu os30 great heli but i carnt get proper engine setting for it throtel half way then looses power checked mufler for blockage that was ok there are not many around
such a...
06-13-2007, 03:37 PM
Replies: 20
Views: 1,861
Posted By kenneth1951

RE: Engine maintenance/care question

drain it then start engine let it run out then
put in after run oil in carb and turn engine over[8D][X(]
06-13-2007, 03:25 PM
Replies: 19
Views: 1,030
Posted By kenneth1951

RE: CRAP ! I messed with the engine setting. I need help

;):eek: setting for bottom 1 turn from closed top one 1 1/2 but make sure there is no carbon
in muffler nippel hope it helps just had same prob[:@][>:]
05-31-2007, 05:01 AM
Replies: 12
Views: 941
Posted By kenneth1951

RE: Need help on lift off

center it on top off trainer legs use elec ties and fasten tightly
05-15-2007, 06:32 AM
Replies: 3
Views: 588
Posted By kenneth1951

RE: Paddle adjustments HOW?

try ajusting pitch:([:'(]
05-15-2007, 06:27 AM
Replies: 33
Views: 2,757
Posted By kenneth1951

RE: hELP, FALCON 3D CRASHED! NOW NO LIFT!!

could be main rotor shaft did you strip all down and check all. to check
feather bar take blades off and the links of turn blade holders together
you will soon know if bent:eek:[X(][>:] after...
05-15-2007, 06:15 AM
Replies: 7
Views: 919
Posted By kenneth1951

RE: Another Falcon 3d newbie with Qs!

:([8D]:)fly bar paddles should have no pitch
04-26-2007, 03:57 AM
Replies: 4
Views: 830
Posted By kenneth1951

RE: NEW WALKERA #60 HELP TO FLY TIPS?

i take it is elec if you dont know anything about it you should have ask the shop to set it up
for you they never fly straite out of box and fly it outside plenty of room there [>:]:D:eek:
...
04-23-2007, 07:49 AM
Replies: 13
Views: 749
Posted By kenneth1951

RE: Problems with BLADE CP

[&:][:@][&o]
be safe allways get pro to set it up then you wont be disapointed when you try to fly it[:-]may the force be with you
04-05-2007, 05:38 AM
Replies: 1
Views: 390
Posted By kenneth1951

RE: safety

[:@]you should never be in front one misteak split personality happy flying fly with care
Forum: AutoGyros
04-03-2007, 04:54 AM
Replies: 16
Views: 7,375
Posted By kenneth1951

RE: Rotorshape Autogyro by LAheli

:Di can see the light come forth and multiply gyro
03-30-2007, 05:05 PM
Replies: 1
Views: 450
Posted By kenneth1951

battery charging

[:@]I have just baught some flight batterys 2400ma ,I charged them at 500ma for 4 and 3quater hours , the battery checker still said low power, have i charged them for long enough, how long do you...
03-30-2007, 04:48 PM
Replies: 4
Views: 840
Posted By kenneth1951

RE: Mercer County NJ Club Looking For Pilots

[:'(]love to come a bit two far travel 5.000m
03-30-2007, 04:39 PM
Replies: 6
Views: 744
Posted By kenneth1951

RE: Futaba Radios

you should not fly and recharge at 9.4 you should get warning from reaeiver8.5 land immediatey
03-30-2007, 03:51 PM
Replies: 11
Views: 1,476
Posted By kenneth1951

RE: raptor 50 for realflight??

if you think rapter 90 are easy to fly your trying to run befor you can walk beter starting with a 30 easer to controll and you will still need lessons be safe you can allways upgrade to 50
Showing results 1 to 17 of 17


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.