RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: Broke it again
Showing results 1 to 25 of 130
Search took 0.39 seconds.
02-04-2008, 11:21 PM
Replies: 56
Views: 18,291
Posted By Broke it again

RE: How is the Trx 3.3 engine?

Beer fridge? Ok well you go be productive working your way to the bottom of your courage or anti- depressant. Oh and Fish Killa! Is that all you have to say? Typical Texan.
02-04-2008, 06:34 PM
Replies: 56
Views: 18,291
Posted By Broke it again

RE: How is the Trx 3.3 engine?

Oh and the reason I didnt beleive the 660 had a filter was because I had a LT 500 Quadzilla and even the petcock didnt have filters. I have torn that thing down to bare bones abd nothing. So I was...
02-04-2008, 06:33 PM
Replies: 56
Views: 18,291
Posted By Broke it again

RE: How is the Trx 3.3 engine?

Fair enough. I stand corrected. Thanks for the pic. But I still think the 3.3 is crappy:D
02-04-2008, 04:42 PM
Replies: 56
Views: 18,291
Posted By Broke it again

RE: How is the Trx 3.3 engine?

TheRealDeal, after you said that, it got me thinking. But, I went out to the garage and double checked and there is definately no fuel filters on all 3. I checked the petcock and at the carbs. Here...
02-04-2008, 03:41 PM
Replies: 56
Views: 18,291
Posted By Broke it again

RE: How is the Trx 3.3 engine?

You are right on some aspects, but the 3.3 is crap inside and out. I am speaking of the whole car from bumper to bumper. You wanted me to bring it on. Is that just the motor side of it or would you...
02-04-2008, 10:08 AM
Replies: 6
Views: 501
Posted By Broke it again

RE: OS 18 dead/flat on bottom. Any ideas???

Hsn for bottom end bogging? Are you suggesting a lean bog? Well I have not touched the msn but top and bottom have been adjusted about 3 turns both ways just to eliminate any lean or rich setting....
02-04-2008, 09:59 AM
Replies: 56
Views: 18,291
Posted By Broke it again

RE: How is the Trx 3.3 engine?

beer=food --- I should have said it was useless for me. But at any rate, I dont use them because up until this 3.3, I never had an isswue with a motor crapping out on me. Check on other posts here...
02-04-2008, 09:51 AM
Replies: 3
Views: 540
Posted By Broke it again

RE: Need help quick Airtronics receiver

Thank you very much for the info.
Rob.
02-03-2008, 09:31 PM
Replies: 12
Views: 710
Posted By Broke it again

RE: Keep breaking my spur gear

He did state that he flipped it over onto the motor. That is a tell tale sign. He agrees that this is the problem, right?
02-03-2008, 07:31 PM
Replies: 12
Views: 710
Posted By Broke it again

RE: Keep breaking my spur gear

I bought the O.S. .18 motor and its great becaus eit sits alot lower than the 3.3. This is something you will have to think about after going through a dozen motor mounts. There is only one roll cage...
02-03-2008, 07:03 PM
Replies: 3
Views: 342
Posted By Broke it again

RE: controls not working

Is the antenna broken? If it is damaged it will cause problems. Do the servos twitch or just go wide open and closed?
02-03-2008, 07:01 PM
Replies: 56
Views: 18,291
Posted By Broke it again

RE: How is the Trx 3.3 engine?

Fuel filters are almost useless because the fuel tank seals fine and the airfilters get cleaned after use. They do not sit long enough to use after run. Trust me on the amount of fuel. I have no...
02-03-2008, 06:56 PM
Replies: 12
Views: 710
Posted By Broke it again

RE: Keep breaking my spur gear

There are sometimes 2 screws that strip when it flips, just save yourtself the headache and replace the motor mount with another brand and use all new screws. Dont waste your money on a rollcage...
02-03-2008, 05:56 PM
Replies: 12
Views: 710
Posted By Broke it again

RE: Keep breaking my spur gear

Check to see if the crappy motor mount is broken. On the 3.3, the motor sits too high and when it flips, you strip the screw to the motor mount that holds the ground wire for the starter. And...
02-03-2008, 05:44 PM
Replies: 13
Views: 852
Posted By Broke it again

RE: condition/value of this tmaxx

Crazy long antenna wire, what receiver is that?
02-03-2008, 05:38 PM
Replies: 17
Views: 965
Posted By Broke it again

RE: WOT no go with resonator

Put it up on a stand with no drag and rip the throttle to see if there are any bubbles in the fuel line. Are you also giving it a couple of high speed runs after you twealk each time?
02-03-2008, 05:30 PM
Replies: 56
Views: 18,291
Posted By Broke it again

RE: How is the Trx 3.3 engine?

Hope this helps with your question. The first pic is of the XTM 24.7. Installed in 2002 and beaten to death on a weekly basis. Runs perfect except pull start rope broke. Second picture is stock .15,...
02-03-2008, 04:31 PM
Replies: 3
Views: 540
Posted By Broke it again

Need help quick Airtronics receiver

Hi, can anyone tell me where the pos. neg. and signal go on this receiver. Everything I have seen said the black receivers from Airtronics is the old style, but I beleive this is the Z connector,...
01-30-2008, 06:13 PM
Replies: 6
Views: 501
Posted By Broke it again

RE: OS 18 dead/flat on bottom. Any ideas???

Yup, tuned perfectly on bottom, stalls at 3 seconds oinch test, revs up a little and then shuts down. There are others with this roblem but havnt found an exact solution.
01-28-2008, 07:21 PM
Replies: 15
Views: 1,007
Posted By Broke it again

RE: os .21?

Stock 3.3 wheelie bar! Problem solved.
01-28-2008, 07:19 PM
Replies: 19
Views: 944
Posted By Broke it again

RE: just bought a used t-maxx .15, some help plz

Keep this in mind also. The .15 t-,axx had stronger parts than the 3.3 parts. The only weak point I have found on the .15 is the spur gear. All of the drive shafts on the .15 are far superior in...
01-28-2008, 06:33 PM
Replies: 6
Views: 501
Posted By Broke it again

RE: OS 18 dead/flat on bottom. Any ideas???

Yes, the motor is broken in. I am on 9 tanks of fuel now. Slipper is set just to where it would tear your skin but will slip slightly, clutch shoes are fine. It seems like the attitude of the motor...
01-28-2008, 06:14 PM
Replies: 6
Views: 501
Posted By Broke it again

OS 18 dead/flat on bottom. Any ideas???

New os18tm is so flat when you take off. I have adjusted bottom end lean and rich with no change. I called OS and they told me to send it to them. Um, I would rather troubleshoot first but they want...
10-29-2007, 08:34 PM
Replies: 40
Views: 2,553
Posted By Broke it again

RE: Where does everyone Live?

Monument, Colorado!
Showing results 1 to 25 of 130
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.