RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: YZ-212
Showing results 1 to 25 of 33
Search took 0.69 seconds.
Forum: Park Flyers & Backyard Flyers
10-15-2003, 09:01 AM
Replies: 3
Views: 617
Posted By YZ-212

RE: GWS E Starter

Yes in stock trim the e-starter is a great trainer. Can fly slow and speeds up quite well. The roll rate with the ailerons is super slow so if you decide to try to roll it make sure you have plenty...
Forum: Electric General Discussion
08-30-2003, 04:59 AM
Replies: 6
Views: 866
Posted By YZ-212

Cap 232 Downed - Any suggestions?

I'll concur with Matt Kirsch about the E-starter. In it's stock form this is an easy plane to fly not to mention cheap 40 bucks. I started out on a tiger moth and feel that the e-starter is as easy...
Forum: Brushed/Brushless motors, speed controls, gear drives
08-27-2003, 04:09 AM
Replies: 1
Views: 796
Posted By YZ-212

razor 400 bolt pattern?

Does the razor motors have the same bolt/screw pattern as a speed 400? Reason for my asking is I'm looking for a better gearbox than the gws units. I'm tired of bending the output shaft on any little...
Forum: Electric General Discussion
08-26-2003, 06:54 PM
Replies: 11
Views: 2,173
Posted By YZ-212

What Bi-plane to get?

http://www.hobbypeople.net/gallery/128428.asp

http://hobbypeople.net/review/128401hp.htm

here are 2 bipes that look nice, but not shure how they fly!
Forum: Park Flyers & Backyard Flyers
08-25-2003, 06:36 AM
Replies: 2
Views: 725
Posted By YZ-212

Covering a GWS plane with Oracover

Just wondering if it's doable? I haven't used monokote type coverings yet, but am wanting to strengthen the air frame and wings of my e-starter. I've read that oracote is a low temp covering, but is...
Forum: Park Flyers & Backyard Flyers
08-25-2003, 04:41 AM
Replies: 6
Views: 1,216
Posted By YZ-212

E-starter hinges

After a few flights of my E-Starter I noticed how flemsy the ailerons were so I decided to trade them out with bulsa ones. I used CA hinges and foam safe CA to hold them on, no problems yet. A tip I...
Forum: Electric General Discussion
08-18-2003, 08:26 PM
Replies: 7
Views: 779
Posted By YZ-212

Is a e starter a good plane to introduce me to arobatics?

I've had great success with the E-Starter. It is my second plane my first was the Tiger Moth. If you fly the plane with out trying to do any airobatics it flys great. I think it's just as easy to fly...
Forum: Brushed/Brushless motors, speed controls, gear drives
08-18-2003, 04:08 AM
Replies: 1
Views: 1,063
Posted By YZ-212

Razor 400 motocalc results vs tested results

I've learned so much from the community here I thought that I would add some info from my testing various props for my razor motor. Along with my testing I compared my results with motocalc to see...
Forum: Brushed/Brushless motors, speed controls, gear drives
08-16-2003, 04:37 AM
Replies: 2
Views: 1,444
Posted By YZ-212

Using watt meter with brushless

I just got a astro flight micro meter to try to prop my plane correctly and I am not sure how to connect every thing. It would be ok if my system was brushed, but i'm using a brushless motor and am...
Forum: Brushed/Brushless motors, speed controls, gear drives
08-15-2003, 03:42 AM
Replies: 1
Views: 735
Posted By YZ-212

2mm pinion for razor motor

Any one have any idea where I can purchase pinion gears for my razor 400? I just pulled my pinion from my gws 300 motor and the pinion is way to loose to fit on the razor.
Forum: Park Flyers & Backyard Flyers
08-06-2003, 10:29 PM
Replies: 8
Views: 882
Posted By YZ-212

What size motor would get the e-starter vertical?

The stock motor on the e starter draws about 9 amps out of the box. Too much for your lipo bats. The kokam lipos you have are only rated at 4 amps. When I first flew my e starter on the stock set up...
Forum: Park Flyers & Backyard Flyers
08-06-2003, 04:51 AM
Replies: 8
Views: 882
Posted By YZ-212

What size motor would get the e-starter vertical?

Oh yay 2 things. Plenty of vertical and with bulsa ailerons this is a great little plane for 40 bucks.
Forum: Park Flyers & Backyard Flyers
08-06-2003, 04:49 AM
Replies: 8
Views: 882
Posted By YZ-212

What size motor would get the e-starter vertical?

Hey FastStang what lipo bats are you using? If your using a 2 cell pack you could parallel 2 of them together to make a 2s2p which would up the capacity and the current capability. A 2 cell pack that...
Forum: Brushed/Brushless motors, speed controls, gear drives
08-04-2003, 06:02 AM
Replies: 1
Views: 601
Posted By YZ-212

How does this set up sound?

GWS E-Starter
castle creations phoenix 25
Razor rz400 brushless
mated to a gws gearbox at 6.6:1
swinging a 12 x 8 prop

moto calc suggests 9 amps 81 watts 25 oz thrust.

Don't have a scale to...
Forum: Brushed/Brushless motors, speed controls, gear drives
07-31-2003, 09:47 PM
Replies: 0
Views: 760
Posted By YZ-212

Those looking for Razor motors

I just ordered a rz400 from these folks and they said they have a few left. Best bet is to look them up and call them!

http://www.nesail.com
Forum: Brushed/Brushless motors, speed controls, gear drives
07-31-2003, 06:51 AM
Replies: 8
Views: 2,212
Posted By YZ-212

E-Starter brushless motors

I'm replacing my motor on my gws e=starter and wast to move to brushless. Flying weight now is about 14 oz and the stock motor is the GWS EPS300C . I'm not looking for hovering performance, but would...
Forum: E-Flight Power Sources
07-25-2003, 02:29 PM
Replies: 7
Views: 1,399
Posted By YZ-212

Lipo's getting hot!

Thanks Matt that clarifies it. sounds like a 2s2p is the ticket.
Forum: E-Flight Power Sources
07-25-2003, 05:45 AM
Replies: 7
Views: 1,399
Posted By YZ-212

Lipo's getting hot!

Just flew my GWS E-starter today for the first time. Flys great by the way. It's a stock set up with the eps 300c motor and gws 5 amp esc. I'm using a kokam 1020 2s pack lipo and a etech 700 2s pack....
Forum: Electric General Discussion
07-25-2003, 05:11 AM
Replies: 8
Views: 859
Posted By YZ-212

E-trainer suggestions, please!

I'll chime in here. I bought the GWS E-Starter a few weeks ago and finally got to take it out today. Built it stock except for the tail section (modified it internally for strength). I am using...
Forum: Brushed/Brushless motors, speed controls, gear drives
07-19-2003, 03:50 AM
Replies: 3
Views: 1,312
Posted By YZ-212

GWS geared motors

http://www.foamfly.com

Great service and fast turn around. If you don't see what you want, call him and he may be able to help you.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
07-02-2003, 04:03 AM
Replies: 9
Views: 893
Posted By YZ-212

futaba 6EXA

I have had one for about 2 months now and like it. Easy to program and is comfortable in my hands. I will tell you this is my first radio and I have nothing to compare it to. I'm a newb, but haven't...
Forum: Electric General Discussion
06-28-2003, 05:12 AM
Replies: 45
Views: 3,705
Posted By YZ-212

Aerobird: First flight report...

1 rule I learned the hard way is to use throttle control to to adjust your altitude and the elevator for maneuvering. Once up to a comfortable height throttle back to 3/4 to 1/2 and adjust your...
Forum: Batteries & Chargers
06-28-2003, 04:56 AM
Replies: 7
Views: 1,469
Posted By YZ-212

Triton Peak Delay at Start Explained

I too have the triton and to this date it has served me well. I charge nmh, nicads and lipos and haven't had any problems with any of them. I use an astroflight power supply rated at 13.5 amps. I use...
Forum: Batteries & Chargers
06-20-2003, 03:47 AM
Replies: 4
Views: 800
Posted By YZ-212

Charging Questions (Triton)

My experience is minimal, but when charging my new packs with the triton I notice the same thing. I think the batteries are rated consevitivly and that your O.K.. Mine do the same thing about 100 -...
Forum: Electric General Discussion
06-19-2003, 10:52 PM
Replies: 18
Views: 1,852
Posted By YZ-212

Electric power equal to 0.90 glow?

Download a trial version of motocalc and see if that can help you.
Showing results 1 to 25 of 33
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.