RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: terry990
Showing results 1 to 20 of 20
Search took 0.64 seconds.
Forum: Classic RC Pattern Flying
09-20-2004, 02:29 PM
Replies: 112
Views: 33,511
Posted By terry990

RE: 60's/70's Pattern Ships

I just purchased an eu-1 from an auction and updated the retracts to rom-air. Webra motor, rear exhaust. Looks good. drop me a line if intrested....
Forum: RC Jets
09-20-2004, 02:07 PM
Replies: 234
Views: 45,057
Posted By terry990

RE: Giant B-52 Destroyed

I have a question, does anyone know what type of servos, batteries, ect were used on this bird??? What kind of redundency???
Forum: Crash & Rebuild
09-20-2004, 01:09 PM
Replies: 9
Views: 2,415
Posted By terry990

RE: B52 Crash

I should have read further into the forms before i posted.... Just finished reading all of the posts about the crash and the one thing no one has discussed in any detail was equipment failure....
...
Forum: Crash & Rebuild
09-20-2004, 11:27 AM
Replies: 9
Views: 2,415
Posted By terry990

B52 Crash

I just found this video today. If you have not seen this its well worth a look....


http://www.gizmodo.com/archives/scale-model-b52-eats-dirt-020838.php
Forum: Giant Scale Aircraft - 3D & Aerobatic
06-02-2004, 05:40 PM
Replies: 3
Views: 620
Posted By terry990

RE: Double Vision

thanks for your reply!!! I'm almost at the point of having someone Chip recommends build and set up the plane for me. Just send me the bill....

Thanks

Terry
Forum: Giant Scale Aircraft - 3D & Aerobatic
06-02-2004, 02:25 PM
Replies: 3
Views: 620
Posted By terry990

Double Vision

Hi Chip I hope you get this post as I'm new to this service. First I have been flying rc for over 5 years so the basics of flight are well under my belt. I'm interested in building one of your...
Forum: The Clubhouse
05-05-2004, 08:22 AM
Replies: 49
Views: 3,557
Posted By terry990

RE: Just one more question...?

Over the past five years of reading RC Report I have read a number of reviews about engines, planes, and RC related equipment that were not endearing to the vendor. As a matter of fact RC Report...
Forum: AMA Discussions
11-22-2002, 06:50 PM
Replies: 56
Views: 6,982
Posted By terry990

"illegal" hovering

It dosen't take a top notch pilot to hover!

Just takes a lot of practice with the right plane.
Forum: AMA Discussions
11-08-2002, 04:23 PM
Replies: 56
Views: 6,982
Posted By terry990

"illegal" hovering

Just a passing thought. As I am learning to hover and after watching others who have been doing it for some time with great success I can make this observation.

Hovering any aircraft is...
Forum: AMA Discussions
11-08-2002, 03:45 PM
Replies: 98
Views: 8,009
Posted By terry990

Hate the AMA?

I very rarely join in these discussions. A lot of ink has been used about the $58.00 yearly dues that we pay for the one year membership in the AMA. Folks I pay $300.00 per year to the gun club...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
09-23-2002, 10:07 PM
Replies: 69
Views: 5,698
Posted By terry990

Hitec digital lockup - fact finding mission

So is the answer yes trust the equipment, or no do more research?

Thanks

Terry
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
09-23-2002, 06:25 PM
Replies: 69
Views: 5,698
Posted By terry990

Hitec digital lockup - fact finding mission

I now have a total of 12 hitech 5945 digital servos that are in new planes. I just purchased the hitech programer and have reset each of the servos and set the dead band. 7 of these servos are old...
Forum: Profile and Fun Flying Planes
09-18-2002, 10:35 AM
Replies: 13
Views: 889
Posted By terry990

Morris ARF and engine combo

The TOPCAP ARF with an MVVS 49 and pipe is a good place to start. If you can afford the extra cost install digital servos on everything.

Have flown this setup all season (Virginia) and it just...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
09-17-2002, 02:01 PM
Replies: 2
Views: 555
Posted By terry990

f.M. or P.C.M. ?

looks to me like chester needs to be using PCM on his gas planes. Something not mentioned here is that you will get little more distance during a range check with the antenna down using PCM.

In...
Forum: Futaba Radios Direct support forum
09-13-2002, 05:19 PM
Replies: 4
Views: 604
Posted By terry990

Futaba Receivers

Thanks for the quick response and the information.

Terry
Forum: Futaba Radios Direct support forum
09-13-2002, 04:53 PM
Replies: 4
Views: 604
Posted By terry990

Futaba Receivers

Whats a WC2??
Forum: Futaba Radios Direct support forum
09-13-2002, 04:46 PM
Replies: 4
Views: 604
Posted By terry990

Futaba Receivers

I have heard that when using the reciever to support dual elevator servos that the refresh rate is slower on the upper channel than on the lower channel. If this is true one of the elevator halves...
Forum: Profile and Fun Flying Planes
09-12-2002, 05:50 PM
Replies: 1,587
Views: 282,887
Posted By terry990

Build your own PBF (Pizza Box Flyer, Flying Pizza Box)

Hi Tim

The PBF is an easy plane to fly if you remember to always keep the nose high. The plane has no airfoil so you are not generating any lift to speak of as it moves through the air. When its...
Forum: Profile and Fun Flying Planes
09-12-2002, 05:26 PM
Replies: 13
Views: 889
Posted By terry990

Morris ARF and engine combo

topcap with mvvs 49 and pipe

Run the 49 on 5% nitro and a 12 3/4 x 3/4 control line apc prop and it will do any stunt in the book. Anymore nitro and the motor can overheat.



climbing flat...
Forum: Profile and Fun Flying Planes
09-12-2002, 05:17 PM
Replies: 1,587
Views: 282,887
Posted By terry990

Build your own PBF (Pizza Box Flyer, Flying Pizza Box)

A buddy at the field build one of these and i got to fly it last weekend. What a trip! Loops in its own length. Rolls like a cork screw. SPINS all the way to the ground if you don't watch out.
...
Showing results 1 to 20 of 20


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.