RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: cdlegate
Showing results 1 to 25 of 75
Search took 0.39 seconds.
04-19-2011, 10:04 PM
Replies: 8
Views: 7,797
Posted By cdlegate

RE: Body Clip Alternatives

i have been known to use safty pins when i lost my clips

oh and also paperclips
04-18-2011, 07:48 AM
Replies: 4
Views: 550
Posted By cdlegate

RE: gear mesh problem

its the tmaxx with reverse blck tranny

i normally use a peice of paper to do it but it seems to slip when i do it that way now... and the odd thing is it normally would slip when i shifted...
04-17-2011, 05:28 PM
Replies: 4
Views: 550
Posted By cdlegate

gear mesh problem

ever since i had tranny problems i have noticed when i try to mesh up my gears the motor has to be moved as far as possible towards the spur gear to go together tight enough not to slip...
and I...
04-17-2011, 05:26 PM
Replies: 2
Views: 575
Posted By cdlegate

RE: revo 3.3 tranny issue..

i am not sure if this retains to your tranny or not but there is a shear pin inside it that might of broke...that happend to my Tmaxx 2.5 with reverse last week..
04-17-2011, 05:20 PM
Replies: 5
Views: 616
Posted By cdlegate

RE: stampede servo stupidity

if u are carefull enough u can take apart one of the others and see how they are in there.... i had that problem one time way back with a servo that I took to bad ones and combined them into one......
04-17-2011, 04:33 PM
Replies: 5
Views: 616
Posted By cdlegate

RE: stampede servo stupidity

I am not sure if i understand what your saying or not but if you took the servo arm off when u cleaned it you may not have it back on in the right spot
if that is the case its a simple fix
...
04-17-2011, 04:28 PM
Replies: 10
Views: 1,896
Posted By cdlegate

RE: TRAXXAS WARRANTY ?

ive had to send in a engine after breaking it in because it never would run right...they sent me back a new replacement without any problems.
04-15-2011, 08:56 PM
Replies: 6
Views: 596
Posted By cdlegate

RE: tranmission with reverse problem

my spur gear was alittle wore down but worked just fine...or so i thought.
now comes the weird part... when transmission was in forward gear it wouldnt slip....now when i put it in reverse...it...
04-15-2011, 08:54 PM
Replies: 4
Views: 3,807
Posted By cdlegate

RE: what header for .19T?

what i did was use the bolt that u used to bolt the header to the motor.... .. i put the 2 hex bolts through the holes of the header and hooked the ends of the springs to the head of the...
04-14-2011, 07:16 PM
Replies: 2
Views: 590
Posted By cdlegate

need to claify somthing on charging

i have a blue lipo 5000mah 7.4 volt 20c if i understand right i can charge this safely at 5amps
if that is correct that means i can also balance charge at that same rate...correct?
04-14-2011, 08:42 AM
Replies: 6
Views: 596
Posted By cdlegate

RE: tranmission with reverse problem

now that i am thinking about it....i believe when this problom happens i loose power to both front and back wheels..... so if that is the case we can rule out front differential...right?
04-14-2011, 08:18 AM
Replies: 6
Views: 596
Posted By cdlegate

RE: tranmission with reverse problem

if that is the case....would the way to test that be by putting the car on a stand and unhooking the front driveshaft and see if it stops...?
04-13-2011, 09:01 PM
Replies: 6
Views: 596
Posted By cdlegate

tranmission with reverse problem

the other day i sheared the pin in the tranny and replaced it. Now i go and sometimes i hear what sounds like gears stripping when i get on the throttle from a stand still or throttle the engine...
Replies: 2
Views: 644
Posted By cdlegate

Spektrum DX3S Error

whenever i turn it on I get a ERROR on the screen and nothing works.... can anyone help me with this problem
04-12-2011, 04:56 PM
Replies: 3
Views: 394
Posted By cdlegate

RE: replacing front bearing

i would replace the rear one but i cant find the size for it listed....and the engine isnt that old... so i am hoping since i didnt know the size i will skip that for now
04-12-2011, 10:21 AM
Replies: 3
Views: 394
Posted By cdlegate

replacing front bearing

i orderd 2 different bearings for my dynamite engine because i didnt know if one would work better over the other or if i could even use one of them...
my quesiton is the difference in the 2...
04-09-2011, 07:38 PM
Replies: 1
Views: 329
Posted By cdlegate

Spektrum DX3S Error

whenever i turn it on I get a ERROR on the screen and nothing works.... can anyone help me with this problem
04-08-2011, 11:56 AM
Replies: 1
Views: 1,104
Posted By cdlegate

DYN2494 glow plug alternative

have dynamite .19t engine and was looking for a alternative glow plugs hopefully good quality and cheaper then the DYN2494 that it calls for
i believe its a cold glow plug and that is what i want...
04-02-2011, 03:04 PM
Replies: 12
Views: 1,118
Posted By cdlegate

RE: temp goes up at idle but cools while on throttle

the front bearing doesnt leak any fluid at all.. just bubbles up when u blow air through engine and apply soapy water..... the only other leak i had was the the stupid bold that u tighten down to...
04-01-2011, 10:31 PM
Replies: 12
Views: 1,118
Posted By cdlegate

RE: temp goes up at idle but cools while on throttle

just pulled the engine out and did a test again for air leaks...found none except front bearing...and that leaks aliitle between rubber seal and (inner bearing)
04-01-2011, 10:25 PM
Replies: 21
Views: 21,476
Posted By cdlegate

RE: 3.3 VS dynamite .19

i have the 19t and i love it...i did have a issue though.... i had the car off the ground and had LSN set really rich and did the pinch test.. when i did that it revved up really high and before i...
03-31-2011, 07:44 PM
Replies: 12
Views: 1,118
Posted By cdlegate

RE: temp goes up at idle but cools while on throttle

i am running dynamite fuel... this whole geting hot thing started the other day when i was trying to tune it and had it tuned rich because of breakin and i was holding it in the air and pinched the...
03-31-2011, 07:12 AM
Replies: 12
Views: 1,118
Posted By cdlegate

RE: temp goes up at idle but cools while on throttle

ok..i think what i did helped....hasnt got hot....i also increased the idle gap and richend it up and am now in the process of leaning the lsn again to get somewhat good performance....also i did...
03-31-2011, 06:33 AM
Replies: 12
Views: 1,118
Posted By cdlegate

RE: temp goes up at idle but cools while on throttle

i agree that is sounds like its lean at the lsn....idle gap is really small and at idle it will spit fuel out...sometime to the point where it floods one thing i forgot to mention was its a ...
03-30-2011, 04:16 PM
Replies: 12
Views: 1,118
Posted By cdlegate

temp goes up at idle but cools while on throttle

i can have it set so rich at idle that it floods and spits fuel out exhaust but temps keep climbing and i kill it when it gets into the 250's while at idle... but on the gas it cools back down and...
Showing results 1 to 25 of 75
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.