RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: hoverlow44
Showing results 1 to 25 of 28
Search took 0.40 seconds.
Forum: Beginners
03-25-2014, 07:51 PM
Replies: 56
Views: 3,618
Posted By hoverlow44

Yeah, you should read the whole post. Its...

Yeah, you should read the whole post. Its actually a 35% Edge with a 3w 85. And i do have bigger packs for other electric 100 Amp planes. Which i always balance. Not going to not balance $400 battery...
Forum: Beginners
03-25-2014, 12:02 PM
Replies: 56
Views: 3,618
Posted By hoverlow44

Just order 2 packs of the 2 S and 1 pack of the...

Just order 2 packs of the 2 S and 1 pack of the 6s.

Looking to get it set up like you did. Im glad you told me about that site, i couldnt find thunder power style extensions.
Forum: Beginners
03-25-2014, 07:54 AM
Replies: 56
Views: 3,618
Posted By hoverlow44

Its not buried, i just cant plug my balance board...

Its not buried, i just cant plug my balance board into it because it is too big. The balance leads stick out enough to stick my volt/load checker into it
Forum: Beginners
03-25-2014, 07:18 AM
Replies: 56
Views: 3,618
Posted By hoverlow44

Well that's helpful to have and i thank you for...

Well that's helpful to have and i thank you for that. I apologize for coming off as a smart ass. I didn't mean to. I was going to make my own balance extensions. BTW I'm 30....have my own home. I...
Forum: Beginners
03-24-2014, 02:26 PM
Replies: 56
Views: 3,618
Posted By hoverlow44

Yes i know all of this. That is why i always load...

Yes i know all of this. That is why i always load check the volatge of each cell. It is hard for me to balacne charge due to the location of the battery in a new plane im building. So if i check...
Forum: Beginners
03-24-2014, 12:26 PM
Replies: 56
Views: 3,618
Posted By hoverlow44

i always check individual cell voltage under...

i always check individual cell voltage under load. .5 A
Forum: Beginners
03-24-2014, 10:43 AM
Replies: 56
Views: 3,618
Posted By hoverlow44

I really mean .01. But that is in my smaller 2s...

I really mean .01. But that is in my smaller 2s lipos i use for Rx. In my larger batteries like my 8S which are subject to about 50A or more of discharge when flying my 70" yak, then there is a...
Forum: Beginners
03-24-2014, 07:49 AM
Replies: 56
Views: 3,618
Posted By hoverlow44

Yeah thats true. usually packs that always go out...

Yeah thats true. usually packs that always go out of balance usually have something wrong within the cells, and shouldn't be used anymore.
Forum: Beginners
03-24-2014, 07:22 AM
Replies: 56
Views: 3,618
Posted By hoverlow44

Most of my planes have accessible areas to...

Most of my planes have accessible areas to balance a lipo. It is a new plane im building where it looks like it will be difficult to balance since battery is in an awkward place due to CG reasons....
Forum: Beginners
03-23-2014, 05:25 PM
Replies: 56
Views: 3,618
Posted By hoverlow44

Use a volt checker with load application.

Use a volt checker with load application.
Forum: Beginners
03-23-2014, 05:24 PM
Replies: 56
Views: 3,618
Posted By hoverlow44

Well i got some lipos in planes as Rx power, and...

Well i got some lipos in planes as Rx power, and it is a pain to remove the battery just to balance it. It's doable, but that would involve like 20 min everytime just to remove and re install the...
Forum: Gas Engines
03-20-2014, 01:06 PM
Replies: 10
Views: 1,078
Posted By hoverlow44

i will try again, and if i cant do it, ill just...

i will try again, and if i cant do it, ill just send the engine to AI and have them figure it out and install the needed parts. Might be more efficient than me trying to guess and order parts every...
Forum: Gas Engines
03-20-2014, 12:21 PM
Replies: 10
Views: 1,078
Posted By hoverlow44

i talked to the guy at aircraft international,...

i talked to the guy at aircraft international, and he says that it sounds like the sparkplug cap is corroded and not making good connection. He says he doubts it has to do with the carburetor. Im at...
Forum: Gas Engines
03-20-2014, 09:36 AM
Replies: 10
Views: 1,078
Posted By hoverlow44

Speedrace, i will try that. Once i leaned out the...

Speedrace, i will try that. Once i leaned out the low end i noticed that the engine became harder to start. The reason i leaned it out was because idle had to be a bit high for the engine to not die....
Forum: Gas Engines
03-20-2014, 08:49 AM
Replies: 10
Views: 1,078
Posted By hoverlow44

All day dan, What should i look for to determine...

All day dan, What should i look for to determine it has a faulty diaphragm?
Forum: Gas Engines
03-20-2014, 08:03 AM
Replies: 10
Views: 1,078
Posted By hoverlow44

I also have the needles at stock setting. H: 3/4...

I also have the needles at stock setting. H: 3/4 turn L: 1 turn. Well, started at those settings anyway.
Forum: Gas Engines
03-20-2014, 07:53 AM
Replies: 10
Views: 1,078
Posted By hoverlow44

3W 75i US Started fine, and now it won't start at all. Help.

I have a 3W 75i. I initially had issues getting it to draw fuel. Even with the choke on, it wouldn't draw. So then i covered the Carb with my thumb and started turning the prop back and forth on the...
Forum: Giant Scale Aircraft - 3D & Aerobatic
03-18-2014, 12:24 PM
Replies: 16
Views: 2,085
Posted By hoverlow44

Hmmmm i've had 5645's for about 5 years now and...

Hmmmm i've had 5645's for about 5 years now and not a single plane with them has developed those issues. I have them in a 33% cap and the rest on 1.20 sized aerobatic planes, like a funtana and a yak...
Forum: Giant Scale Aircraft - 3D & Aerobatic
03-18-2014, 09:46 AM
Replies: 16
Views: 2,085
Posted By hoverlow44

Yeah i wont argue with you about the Savox's...

Yeah i wont argue with you about the Savox's performance and reliability. They are a heck of a servo. Im just curious as to why you dont like the hitec 5645's? Is it the speed? Sorry about the...
Forum: Beginners
03-18-2014, 08:34 AM
Replies: 56
Views: 3,618
Posted By hoverlow44

I usually check the voltage of each cell, and...

I usually check the voltage of each cell, and they are always with in .01 V of each other. And this is in my 8S 4400 mah pack that i fly my 70" yak for about 8 minutes of 3d flight. Now, using the...
Forum: Giant Scale Aircraft - 3D & Aerobatic
03-18-2014, 08:07 AM
Replies: 16
Views: 2,085
Posted By hoverlow44

Those Savox have about half the torque of the...

Those Savox have about half the torque of the tactical and are more expensive. Yes they are probably a better servo in terms of where they are manufactured, but the tactic are actually pretty good...
Forum: Beginners
03-18-2014, 08:00 AM
Replies: 56
Views: 3,618
Posted By hoverlow44

Debate on Lipos. To balance or not?

So I wasn't sure where to post this.. Iv'e been flying for a while now, and im pretty knowledgeable when it comes to RC components such as servos, batteries and such. I have a debate going on with my...
Forum: Giant Scale Aircraft - 3D & Aerobatic
03-18-2014, 07:30 AM
Replies: 16
Views: 2,085
Posted By hoverlow44

Yeah, they make some decent stuff. I particularly...

Yeah, they make some decent stuff. I particularly like the gassers 30cc-50cc and above
Forum: Giant Scale Aircraft - 3D & Aerobatic
03-17-2014, 12:14 PM
Replies: 16
Views: 2,085
Posted By hoverlow44

Now if $59.99 is still too much for your budget,...

Now if $59.99 is still too much for your budget, then you can go with these hitec 645's, they have about 133 oz/in which isn't bad, but should be plenty for basic maneuvers like loops, knife edge and...
Forum: Giant Scale Aircraft - 3D & Aerobatic
03-17-2014, 12:10 PM
Replies: 16
Views: 2,085
Posted By hoverlow44

I would recommend these tactical servos. You get...

I would recommend these tactical servos. You get the best bang for your buck. I would recommend at least 168 OZ/in but these tactic have like 300+. and you can run straight on a 7.4 lipo without a...
Showing results 1 to 25 of 28
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.