RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 9
1
2
3
Last »
Search: Posts Made By: tdriver
Showing results 1 to 25 of 215
Search took 0.80 seconds.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
11-06-2011, 12:22 PM
Replies: 6
Views: 584
Posted By tdriver

spectrum ar6200 water proof

i fly helis and planes on the beach,and sometimes sh.. happens.

a few months ago i had to pull my 450 size heli from the bottom of the sea......
opened up dried/cleaned/oiled everything and...
Forum: Gas Engines
10-12-2011, 01:03 PM
Replies: 0
Views: 3,136
Posted By tdriver

RCEXL kill switch as ibec

i tried to "decrypt" the manual and the supplied super small pictures how to use the kill switch with only one battery..... no go....
then i put it in the scanner and zoomed it a few times,still...
Forum: Gas Engines
09-23-2011, 11:56 AM
Replies: 22
Views: 2,121
Posted By tdriver

RE: Choke Arm Repair???

something like this will do i think,and cost only a fraction.... throttle arm ,or this one (even cheaper)
Forum: Engine Conversions
09-15-2011, 12:18 PM
Replies: 2
Views: 1,662
Posted By tdriver

smallest size but reliable glow to gas conversion?

i have seen a lot of videos on youtube with glow to gas conversions but they are all 0.61 ci and up.

is there a size limit so they are still reliable on gas? (reliable as in good idle...
Forum: Gas Engines
09-11-2011, 11:44 AM
Replies: 18
Views: 1,485
Posted By tdriver

RE: storing with gas in tank/carb or not

something that i just remembered..... after a few days with the vent line closed,the tank collapses a bit,not too much though, is it possible for the tank to suck the gas out of the carb?

...
Forum: Gas Engines
09-11-2011, 07:28 AM
Replies: 18
Views: 1,485
Posted By tdriver

storing with gas in tank/carb or not

i fly my gassers on weekends sometimes every other week. (even less in winter)

from other posts i have gathered the information to not empty the tank/carb after flying. tygon gets stiff when...
Forum: Gas Engines
09-07-2011, 08:35 AM
Replies: 26
Views: 13,398
Posted By tdriver

RE: RCEXL Opto Kill Switch Ignition vs. receiver Voltage Question

the manuals i found have a note in red color: "the kill switch not including BEC function"

do you have a link to take a look?
Forum: Gas Engines
09-06-2011, 12:07 PM
Replies: 26
Views: 13,398
Posted By tdriver

RE: RCEXL Opto Kill Switch Ignition vs. receiver Voltage Question

interesting....are there any instructions to do this?
Forum: Engine Conversions
09-04-2011, 07:16 AM
Replies: 1
Views: 664
Posted By tdriver

cdi onboard tacho on magneto ?

has anyone tried a onboard tacho on a magneto engine?

afaik both need a magnet and both have one.....
a y-lead to a battery, one to the tacho,one to a hall sensor...... but still i may...
Forum: Gas Engines
09-03-2011, 10:48 PM
Replies: 4
Views: 709
Posted By tdriver

anyone use this kill switch?

anyone use this kill switch ?

it seems it can be used directly between the battery and the ignition,with less than 6 Volts.

opto switch from Hobbyking needs 6V and up,which makes this...
Forum: Gas Engines
09-03-2011, 10:33 AM
Replies: 1
Views: 461
Posted By tdriver

how to flood an engine.......

the subject is more a question......cause i don't know how this happened....

the last time the engine was running (yesterday) i did a high speed pass and hit the kill switch to check on the...
Forum: Gas Engines
08-30-2011, 10:24 AM
Replies: 12
Views: 2,486
Posted By tdriver

RE: butterfly vent hole ???

i checked everything mentioned above but there was no problem,

so i took off the carb and there is a vent hole after all and it is not the choke.


is it an easy task to remove the...
Forum: Gas Engines
08-28-2011, 01:03 AM
Replies: 26
Views: 2,602
Posted By tdriver

valid carb tuning technique

i'm new to gas engines and i'm reading/watching videos on how to tune the carb right.

the thing is i can't see the difference from slightly rich and slightly lean.......mostly on the low speed...
Forum: Gas Engines
08-28-2011, 12:27 AM
Replies: 12
Views: 2,486
Posted By tdriver

butterfly vent hole ???

i have an engine that won't properly shut down when the butterfly is 100% closed,
i thought it would be lean somehow but then i read this walbro tuneup "read special notes- #1" (at the end of page)...
Forum: Engine Conversions
08-20-2011, 11:56 PM
Replies: 1
Views: 835
Posted By tdriver

non ringed ABC liner on gas ??

i have a couple (smaller than usual....46fx) OS engines i'm thinking to convert to gas,
not so much to actually use them on my planes.... more than a project and for fun,but if everything works...
Forum: Gas Engines
07-29-2011, 09:57 PM
Replies: 26
Views: 2,980
Posted By tdriver

RE: Gasser for a 70 size sport plane?

if a 20cc won't fit,the rcgf 15 is also something to consider.
Forum: Gas Engines
07-24-2011, 07:21 AM
Replies: 6
Views: 1,815
Posted By tdriver

reed valve mounting screw RCGF 15

i was about to install the engine on the firewall, and i had to remove the carb at some point.

so far so good, then i noticed the reed valve was hold on the plastic "block" by a 2.5 X 5mm screw...
Forum: Gas Engines
07-18-2011, 01:44 PM
Replies: 23
Views: 1,684
Posted By tdriver

single battery possible?

is it possible to get away with a single battery setup for ignition and receiver?

i read in another forum (quote) "if you are fly 2.4 ghz, they can be the same battery as long as you use 2...
Forum: Gas Engines
07-16-2011, 11:39 PM
Replies: 29
Views: 16,298
Posted By tdriver

RE: Nitro Gasoline Conversion

a few pointers.....

first off ,definiteley a very stupid thing to do..........

a minor detail...
this heli looks like a raptor 60 to me (not 50), this one had the tt-70 pro pre-installed...
Forum: Engine Conversions
07-16-2011, 10:04 PM
Replies: 12
Views: 1,627
Posted By tdriver

RE: Walbro Remote Carb.

yes you can do that. just make sure the inside dimeter is not smaller than the venturi and the pipe is not too long.


btw.
what carb will you fit on it?
Forum: Gas Engines
07-14-2011, 09:37 AM
Replies: 58
Views: 6,710
Posted By tdriver

how long do you keep your 2 stroke mix?

how long do you keep your mix until you replace it with fresh one?
do you use any stabilizer like stabil to keep it fresh longer?

i 've read that 2 stroke oil already has some stabilizer in...
Forum: Gas Engines
07-11-2011, 09:30 AM
Replies: 18
Views: 1,501
Posted By tdriver

RE: storing gasser long term

i'm not comfortable to leave gas in the tank cause of the place i store my models.

could i use 2 stroke oil instead? the same one i mix in the fuel.

would that be equal to not dry out the...
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
07-01-2011, 07:23 AM
Replies: 0
Views: 654
Posted By tdriver

R30/50 V2 fuel tank dimensions please

can someone be so kind and measure the fuel tank dimension from the r30/50 V2 ?

(dimensions not capacity)

Height
Width
Length

i need that for a project and i don't know if it will...
Forum: RC Giant Scale Cars
06-05-2011, 02:11 AM
Replies: 4
Views: 934
Posted By tdriver

RE: pitstop-shop.nl any good? (hopefully yes...)

i guess nothing has changed.... what was the longest you had to wait?
i'm waiting for an engine btw.
Forum: RC Giant Scale Cars
06-04-2011, 11:05 PM
Replies: 4
Views: 934
Posted By tdriver

pitstop-shop.nl any good? (hopefully yes...)

anyoneboughtfrom them before?


i have ordered (and pe-paid) some parts from there,and although everything seemed to be in stocksomething actually wasn't.

did i mentioned 30 euros for fast...
Showing results 1 to 25 of 215
 
Page 1 of 9
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.