RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: Francis Fernand
Showing results 1 to 25 of 88
Search took 0.68 seconds.
03-23-2005, 07:32 AM
Replies: 275
Views: 31,060
Posted By Francis Fernand

RE: Attn: Hobbico Elite Owners

Geistware,

I do not have any meter, but I can get one.

How do I know if the Elite is not calibrated ? or How do I calibrate the Elite ?

Thanks in advance,
03-21-2005, 05:15 PM
Replies: 275
Views: 31,060
Posted By Francis Fernand

RE: Attn: Hobbico Elite Owners

Geistware,

The cutoff is 0.9V/cell equals to 3.6V.
The connection is directly to the pack (no switch).

Francis
03-21-2005, 01:42 PM
Replies: 275
Views: 31,060
Posted By Francis Fernand

RE: Attn: Hobbico Elite Owners

Hey Geistware,

I have a 4.8 volts NiCad 4 cell 1500mAH AU pack that I programmed the following parameters for cycling:
A) 4 cells
B) 1500 mah
C) charge at 0.15 Amps.
D) discharge at 0.30...
Replies: 13
Views: 1,640
Posted By Francis Fernand

RE: "Replacement" for 5945MG

Thanks, I'll do that.
11-14-2004, 01:26 PM
Replies: 2
Views: 2,216
Posted By Francis Fernand

Smart-Fly failsafe on regulator 6V question ?

Hi Robert,

I was asking wich regulator-LiON packs to use in my 27% CAP and found that a fellow member here in RCU recommend both Smart-Fly and Fromeco regulators. I found this on the XXXXXXX...
Replies: 13
Views: 1,640
Posted By Francis Fernand

RE: "Replacement" for 5945MG

Michael,

Another question.

I was checking the Fromeco website and found this:

"CAUTION!!! Fail Safe Switches like the Reliaswitch use power in the "OFF" Position. Due to the internal...
Replies: 13
Views: 1,640
Posted By Francis Fernand

Replies: 13
Views: 1,640
Posted By Francis Fernand

RE: "Replacement" for 5945MG

Michael Glavin,

Thanks again for your response. Another question.

Is better to have 1 4400maH LiOn pack with 1 Switch or 2 2200maH packs with 2 switches ?

Regards,
Replies: 13
Views: 1,640
Posted By Francis Fernand

RE: "Replacement" for 5945MG

Michael Glavin,

Is a 2200maH LiOn battery pack enough for 5 servos HS-5945MG and 1 Std. servo for throttle for this 27% CAP ?
Replies: 13
Views: 1,640
Posted By Francis Fernand

RE: "Replacement" for 5945MG

27% CAP with a DA50
Replies: 13
Views: 1,640
Posted By Francis Fernand

"Replacement" for 5945MG

Mike/Michael,

Which karbonite geared servo is the substitute of the 5945MG Digital Coreless ?
08-07-2004, 09:18 PM
Replies: 275
Views: 31,060
Posted By Francis Fernand

RE: Attn: Hobbico Elite Owners

Hey Geistware / Coomarlin,

I did receive my Elite and try it today for the first discharge and charge.

I have a Futaba 9C Tx with a 8cell - 700maH - Ni-Cad battery pack.

I did first...
Forum: Gas Engines
04-11-2004, 09:57 PM
Replies: 14
Views: 1,097
Posted By Francis Fernand

RE: DA -50 or a ZDZ 60/Pitts 1/3

RCfly-in,

I have a GP Pitts that used to have instaled a ZDZ-60. It performs very wel. Now, when I adquired the airplane, I installed a DA-50 and this combo is awesome. No leads needed, CG aft...
Forum: Gas Engines
03-28-2004, 04:50 PM
Replies: 13
Views: 1,329
Posted By Francis Fernand

RE: 50cc Gas-Difference in weight

I have my GP Pitts with the DA50. Unlimited vertical. CG aft at limit without adding lead. Nice Flying plane.
03-22-2004, 07:51 PM
Replies: 2
Views: 330
Posted By Francis Fernand

RE: RX battery question

Hey Doc_Detroit,

No extra harness. You can hook the other battery to an empty channel and you can have two switches. No problem. You can check www.rcbatteryclinic.com .
03-09-2004, 08:33 PM
Replies: 13
Views: 833
Posted By Francis Fernand

RE: Morris topcap cg

I need an answer too.
Forum: Gas Engines
03-08-2004, 08:45 AM
Replies: 2
Views: 434
Posted By Francis Fernand

RE: Da50 muffler pressure tap

For smoke only.

If you're not gonna use smoke, just use the screw supplied with the muffler.
03-03-2004, 04:58 PM
Replies: 4
Views: 571
Posted By Francis Fernand

RE: Hughes RC charge plus

Please, need this info too.
02-23-2004, 07:57 AM
Replies: 2
Views: 494
Posted By Francis Fernand

Charging 6V with a Futaba 4.8V Wal-wart ??

I have the Futaba 4.8V at 100 maH walwart charger from Futaba.

I have a 1100 maH 6V battery.

Is possible to charge this 6V battery with this type of charger ?.

If so, how many hours do...
01-28-2004, 04:16 PM
01-28-2004, 03:05 PM
Replies: 3
Views: 452
Posted By Francis Fernand

Any good or bad experience of ¨Superbatterypacks¨ LiOn packs and accesories.

Hi all,

I was searching for LiOn packs and accesories and found SUPERBATTERYPACKS.COM to have very good prices on LiOn packs and accesories, compared to Duralite / Powerflite guys.

Has...
01-15-2004, 04:50 PM
Replies: 3
Views: 888
Posted By Francis Fernand

RE: ZEN 50 C.G. ????

Caliberdave,

Thanks for your reply

Yes, I need it.
12-25-2003, 06:49 PM
Replies: 3
Views: 888
Posted By Francis Fernand

ZEN 50 C.G. ????

Hi guys,

A friend of mine gave me his ZEN 50 while he's in other country. I have no manuals and I was wondering what is a good C.G. for firts flights.

I found the C.G. is now in 127mm...
Showing results 1 to 25 of 88
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.