RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 14
1
2
3
11
Last »
Search: Posts Made By: FastVee
Showing results 1 to 25 of 344
Search took 0.75 seconds.
Forum: Speed - RC Gas Boats
11-28-2016, 01:31 AM
Replies: 11
Views: 5,368
Posted By FastVee

I have just received 32cc Zenoah for this...

I have just received 32cc Zenoah for this build,Also got WD200 made drive,mounts and clutch , this will be so good looking when done...

SS RC BOATS, build log?
Forum: Speed - RC Gas Boats
11-20-2016, 06:05 AM
Replies: 10
Views: 2,375
Posted By FastVee

Thanks! I will find it out soon, the engine and...

Thanks! I will find it out soon, the engine and pipe are on ther way here

I also ordered mount and clutch from Werner at wd200 for this , soon I´ll have all the bits so I can do a build here.
...
Forum: Speed - RC Gas Boats
11-16-2016, 12:52 PM
Replies: 10
Views: 2,375
Posted By FastVee

Thanks Ron, I allready have ordered wide(to...

Thanks Ron, I allready have ordered wide(to clear the radio box) 1" header ...
Forum: Speed - RC Gas Boats
11-15-2016, 11:07 PM
Replies: 10
Views: 2,375
Posted By FastVee

Looks like I will find out how noisy the tfl pipe...

Looks like I will find out how noisy the tfl pipe is... Sadly Dave does not have the correct pipe for my build. Great customer service thougt.

https://www.youtube.com/watch?v=hHuN-zn0A9c this is...
Forum: Speed - RC Gas Boats
11-15-2016, 12:54 AM
Replies: 10
Views: 2,375
Posted By FastVee

are TFL hobby pipes good? just saw this and no...

are TFL hobby pipes good? just saw this and no idea of the noise levels. http://www.tfl-hobby.de/Auspuff/Resos/Reso--Resonanzschalldaempfer-47-cm--Edelstahl--K30--fuer-30ccm-.html
Forum: Speed - RC Gas Boats
11-13-2016, 09:13 PM
Replies: 10
Views: 2,375
Posted By FastVee

Thanks, I am waiting a reply from Dave from...

Thanks, I am waiting a reply from Dave from prestwitch.

I am not racing, just wanting to build a nice relaxing "sunday boat" that is not too noisy.

-Pate
Forum: Speed - RC Gas Boats
11-13-2016, 02:11 AM
Replies: 10
Views: 2,375
Posted By FastVee

Quiet exhaust for g320pum -is there something for it?

So I have looked everywhere and cant find much. would like to have something quiet, low(ish) cost.

The chinese pipes I found are for smaller engines(7/8") headers and I have no idea will these...
Forum: Speed - RC Gas Boats
10-11-2016, 10:54 PM
Replies: 11
Views: 5,368
Posted By FastVee

Jeanneau, I am now, thanks! looked that build and...

Jeanneau, I am now, thanks! looked that build and liked it.

Wifey wants another kid(I dont mind lol)so budget just dropped...Will do a single drive with mod zen or tiger king now.

Will post...
Forum: Speed - RC Gas Boats
10-09-2016, 09:34 AM
Replies: 11
Views: 5,368
Posted By FastVee

Hi The Ghost, I joined the forum and looked your...

Hi The Ghost, I joined the forum and looked your build, very nice!

I also found the thread of your engine problem.I thought rcmk made quality stuff, shame about that issue.

-how do you like the...
Forum: Speed - RC Gas Boats
10-06-2016, 12:35 PM
Replies: 11
Views: 5,368
Posted By FastVee

justaddwata, thanks for the info. That link for...

justaddwata, thanks for the info. That link for the builds was allready in my favourites :D, there is plenty of pics there but not much info what does what,cog,etc.

But really helpful in many ways...
Forum: Speed - RC Gas Boats
10-06-2016, 07:12 AM
Replies: 11
Views: 5,368
Posted By FastVee

Large scale boat, single or twin drives? also build help would be nice

Hi all, I am just waiting for delivery of my first gas boat. It is 70" long and stepped v-hull. No pics yet sorry. unbranded outerlimits/deltaforce look a like.

I really like the looks of twin...
Forum: Speed - RC Gas Boats
09-11-2011, 03:02 PM
Replies: 534
Views: 169,494
Posted By FastVee

RE: apache owners

Another problemfree weekend.

few videos
http://www.youtube.com/watch?v=6g5ZfT-bQ70

http://www.youtube.com/watch?v=7xXd3dLhd-0
Forum: Speed - RC Gas Boats
08-20-2011, 07:13 AM
Replies: 534
Views: 169,494
Posted By FastVee

RE: apache owners

Just got back from testing minor mods... no gps but decent speed. 7 minutes of driving and the motors do draw more juice then the t600´s I had in this b4. -lipos were warm and slightly puffed after...
Forum: Speed - RC Gas Boats
08-05-2011, 04:50 AM
Replies: 534
Views: 169,494
Posted By FastVee

RE: apache owners

I have not timed runs yet with these motors.

I´ll try to remember that when I drive it next(later today) I think that 5-8 minutes should be close to truth) -a bit slower speeds with smaller...
Forum: Speed - RC Gas Boats
08-04-2011, 03:08 AM
Replies: 534
Views: 169,494
Posted By FastVee

RE: apache owners

Just wanted to post here also, my Navaho is finally working like planned, cheapo electric setup and over 40mph so far.

video
...
Forum: Speed - RC Gas Boats
06-19-2011, 04:14 AM
Replies: 534
Views: 169,494
Posted By FastVee

RE: apache owners

Not yet ready to turn her ic, but getting closer...

It was only an esc that went poof, about 40$ worth of chinese engineering:D -but if that would have not been mounted on the stainless servo...
Forum: Speed - RC Gas Boats
06-19-2011, 02:18 AM
Replies: 534
Views: 169,494
Posted By FastVee

RE: apache owners

Just wanted to show that electric boats can produce smoke also!

Enjoy!

http://www.youtube.com/watch?v=DS-FpuD4Su4&feature=player_embedded

Painted the boat also and it has 55mm Propshop...
Forum: Speed - RC Gas Boats
05-20-2011, 01:56 PM
Replies: 534
Views: 169,494
Posted By FastVee

RE: apache owners

Hi all, I just finished my Apache build (well, actually it´s a Navaho, from Mart) hope you dont mind me showing my boat!

Twin motors and struts, single rudder.



Why would you mind?...
Forum: Speed - Electric
05-02-2011, 11:49 AM
Replies: 11
Views: 860
Posted By FastVee

RE: Have I fried my ESC?

I think that your 2200mAh packs are way too small and the discharge current they offer is too low and that is harmful to the esc. (only 55A contin.)
It could be fried, if not I would not use these...
Forum: Speed - RC Gas Boats
01-19-2011, 12:48 PM
Replies: 534
Views: 169,494
Posted By FastVee

RE: apache owners

Hey all, I have my first Apache on it´s way from Mart. (well, a Navaho but I guess it´s close enough! )

I will build it to use blue smoke,hope you dont mind me asking few q´s here at the gas...
Forum: RC Scale Boating
07-12-2010, 12:41 PM
Replies: 18
Views: 18,519
Posted By FastVee

RE: Making the HK Princess boat more realistic

Thanks, next I will finish my friends boats(deltaforce 33,fastech and finnsport). after that I guess I´ll make outboard powered sportboat.

The fasteck and finnsport projects are updated at...
Forum: RC Scale Boating
07-11-2010, 04:26 PM
Replies: 18
Views: 18,519
Posted By FastVee

RE: Making the HK Princess boat more realistic

latest video

http://www.youtube.com/watch?v=VDd1L2_o-js
Forum: RC Scale Boating
07-01-2010, 04:20 AM
Replies: 18
Views: 18,519
Posted By FastVee

RE: Making the HK Princess boat more realistic

http://www.youtube.com/watch?v=ilTQzK2iuew&feature=player_em

wot
Forum: RC Scale Boating
06-27-2010, 02:47 PM
Replies: 18
Views: 18,519
Posted By FastVee

RE: Making the HK Princess boat more realistic

http://www.youtube.com/watch?v=7mddR4v0Pxs&feature=player_embedded#!


sorry, no wot.... I filmed and my friend drove...-his first time driving a rc boat so not the fastest speed here....
Forum: RC Scale Boating
06-24-2010, 04:12 PM
Replies: 18
Views: 18,519
Posted By FastVee

RE: Making the HK Princess boat more realistic

Tested 35mm and 3s also...on 3s it is too fast and cavitates badly(lifts the hull off water).

on 2s... WOW I really like the speed and handling!

Will post video when I return from the sea...
Showing results 1 to 25 of 344
 
Page 1 of 14
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.