RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: funman1
Showing results 1 to 25 of 88
Search took 0.42 seconds.
10-07-2008, 11:44 PM
Replies: 9
Views: 926
Posted By funman1

RE: GPS Speed?

My truck was a stock engine 427 but I run it pretty rich, and I have tons of extra metal and cage on it.
10-07-2008, 11:39 PM
Replies: 10
Views: 695
Posted By funman1

RE: LRP Spec 3 where cheapest?

Thanks suga.
With that code it makes it even cheaper then the guy on ebay!
It paid for 2nd day air, and it located in Reno, about 100 miles from me.
It should be here on Fri or Sat!!
10-07-2008, 03:02 PM
Replies: 10
Views: 695
Posted By funman1

RE: LRP Spec 3 where cheapest?

Dang this offer code won't work on TH :(

http://www.steveries.com/temp/nogo.jpg
10-07-2008, 12:54 AM
Replies: 10
Views: 695
Posted By funman1

RE: LRP Spec 3 where cheapest?

Dang they charge tax in CA where I am!
Heheh now I need a place that is not located in Cali so I don't have to pay another 7.25% AND shipping!
10-07-2008, 12:37 AM
Replies: 10
Views: 695
Posted By funman1

RE: LRP Spec 3 where cheapest?

As always thanks Suga!
I just turned my old piston on my 427 into part of my key chain.
Got sand in the old engine and it's done for sure now!
10-07-2008, 12:33 AM
Replies: 9
Views: 926
Posted By funman1

RE: GPS Speed?

41 is the best I've gotten my truck to on pavement.
But I Have a huge HEAVY rollcage
10-07-2008, 12:28 AM
Replies: 10
Views: 695
Posted By funman1

LRP Spec 3 where cheapest?

Looking to nab an LRP spec 3 for the best price online.
Looks like killer hobbies is throwing in the towel on their business so that's a no go :(

Thanks
~Steve~
09-09-2008, 01:02 PM
Replies: 5
Views: 658
Posted By funman1

Rebuild Stock LST2 Engine or LRP Spec3

Ok here's the deal with my old engine.

I ran it one day in some super dusty off road conditions.
It ran for about an hour then started act strange...

I tried to run it for about another...
07-19-2008, 04:29 PM
Replies: 5
Views: 708
Posted By funman1

RE: is my lst2 tuned correctly?

Looks and sounds fine to me..
You may want to check engine temp because they tend to overheat when you run WOT (Wide Open Throtle) like that in a field, Esp in high grass..
Hope that helps some..
07-12-2008, 02:09 PM
Replies: 8
Views: 3,234
Posted By funman1

RE: Team losi LST2 Fuel tank Problemo

Yes the problem is that the LST2 tank (when FULL of fuel) the fuel line sits above the carb!
So if you fill your tank to the very top it will siphon out of the tank into the carb flooding the...
06-26-2008, 01:08 PM
Replies: 2
Views: 390
Posted By funman1

RE: lst2 shock shaft nut

A6307 (5-40 Nuts Lock & Hex) 4pkg $2.00
06-21-2008, 01:17 AM
Replies: 4
Views: 489
Posted By funman1

RE: Servo Advice!?!

I got the Z620? I think that's the number..
I put two of them in my truck
They both are kinda loud
but will turn the tires on concrete at a dead stop.
06-07-2008, 06:22 PM
Replies: 55
Views: 4,856
Posted By funman1

RE: Another one bites the dust...

hahahaha
took me a min but finally got it :)
06-07-2008, 01:19 PM
Replies: 2
Views: 555
Posted By funman1

RE: Truck keeps dying and hard starting...

Just off the top of my head all those things scream
"I need a new Plug" :)

I would guess either too rich or new plug needed.
06-06-2008, 07:15 PM
Replies: 4
Views: 446
Posted By funman1

RE: Clutches

Part # A6356 (5&6MM Shim Set) $2.00
If you look at the parts explosion of the unit on Losi website it shows them, they go between the flywheel nut and the bearing.
06-04-2008, 09:33 PM
Replies: 19
Views: 2,124
Posted By funman1

RE: Can't belive this engine RUNS!?!?! W/ Pics

That's just the starter pin.
It slides into half of the connecting rod.
It's not bent, it's just almost falling out...
Snowduster Nice to see you joined, now go to the HPI forums hahahah:)
...
06-03-2008, 10:48 PM
Replies: 19
Views: 2,124
Posted By funman1

RE: Can't belive this engine RUNS!?!?! W/ Pics

hahah yeah this thing is back together, as is but (Did some soaking, but not much)
And with the engine sealed now it's running like a champ!!!

I think my firend is just going to drive it till...
06-02-2008, 12:59 AM
Replies: 19
Views: 2,124
Posted By funman1

Can't belive this engine RUNS!?!?! W/ Pics

Yes I know this is a savage engine in a Losi forum, but I don't own a savage anymore and thought you guys would like this.

My friend gave me this engine to work on for him.
So I was just going...
06-02-2008, 12:54 AM
Replies: 1
Views: 450
Posted By funman1

New work desk pics

Well I finally decided to get organized oon my work bench :)
I'm just a backyard basher so yes I know it's no racer workbench..

~Steve~
05-29-2008, 08:28 PM
Replies: 16
Views: 6,437
Posted By funman1

RE: LST Roll Cage

Yeah I found that out AFTER I bought it :(
It's since been replaced with a motor saver.
05-27-2008, 07:35 PM
Replies: 16
Views: 6,437
Posted By funman1

RE: LST Roll Cage

Here's my old pics..
I have since updated to metal body posts,
I feared I would break the shock towers by doing this, but now;
I haven't broken a metal body post, or a shock tower in over a...
05-27-2008, 07:19 PM
Replies: 10
Views: 861
Posted By funman1

RE: RPM a-arms

I run dyanmite on my front end.
Though I would never run integy crap on my vehicle.
05-26-2008, 11:48 PM
Replies: 2
Views: 366
Posted By funman1

RE: Problems with 1 way bearing on Megabaja spur gear!!

Do you just clean it and drop it back in?
You need to clean it, dry it,
and then add some one way bearing oil.
05-25-2008, 11:10 AM
Replies: 6
Views: 645
Posted By funman1

Cheapest place to get LRP Spec3

What is the best deal I can get on a new LRP Spec3?
Thanks
Showing results 1 to 25 of 88
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.