RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: touch and go
Showing results 1 to 25 of 198
Search took 1.11 seconds.
Forum: Glow Engines
09-01-2012, 06:05 PM
Replies: 30
Views: 3,164
Posted By touch and go

RE: How to rejuvenate a long stored OS 1.08 ?

Try this: put a propeller on the engine and remove the glow plug. Put some machine oil in the top of the cylinder. Use your hot air gun to heat up the engine. When the engine gets hot enough you...
Forum: Kit Building
01-04-2008, 01:28 PM
Replies: 16
Views: 2,162
Posted By touch and go

RE: Magnets ??

Ace Hardware.
Replies: 6
Views: 1,037
Posted By touch and go

RE: Servos for 84" Flybaby With 1.20 FS?

The 821s should be OK for the Fly Baby for normal flying. Do not make the mistake that I made which was to put loc-tite on the servo arm screws when installing them into the servo output shafts. It...
Replies: 10
Views: 2,583
Posted By touch and go

RE: Binding spectrum reciever

I had the same problem and called Horizon. I was not using the switch that came with the Spektrum system; I bet you aren't either. The Spektrum switch uses a battery charge wire set that has three...
11-19-2007, 08:46 PM
Replies: 1,854
Views: 272,406
Posted By touch and go

RE: Venus II

I've been flying my new Venus II for two weekends now and am having a great time flying this bird! I have an OS 1.08 2 cycle up front which allows for unlimited verticle climbs. Knife edge is a...
Forum: Kit Building
11-01-2007, 04:26 PM
Replies: 9
Views: 1,467
Posted By touch and go

RE: TF Piper Arrow GE kit - first flight

Your plane looks great and congradulations on a successful first flight!
10-22-2007, 02:53 PM
Replies: 4
Views: 907
Posted By touch and go

Where to get downed plane locater

The area surrounding our flying field has a lot of "bunch grass" which literally grows to about 12 feet high and is very thick. Moreover, there are some nasty critters slithering out in the bunch...
10-13-2007, 03:03 AM
Replies: 12
Views: 1,237
Posted By touch and go

RE: Plan protection while building

Especially useful for large builds is clear plastic sheeting found in such places as the paint department of big box home improvement stores.
Forum: Beginners
10-03-2007, 12:59 PM
Replies: 17
Views: 1,871
Posted By touch and go

RE: CESSENA 182 by Hanger 9

I have flown my Hanger 9 Cessna 182 a lot and have not noticed it to have any tendency at all to snap roll. In my opinion, it flys like a big trainer. Mine is powered by a Saito 180 which I am very...
Forum: Kit Building
08-21-2007, 02:23 PM
Replies: 8
Views: 1,869
Posted By touch and go

RE: Blind nut / firwall / engine mount procedure

Try this: Put the mount where it needs to be on the firewall and mark the holes on the firewall. Then drill the first hole and install the T-nut by pulling it into the back of the firewall using one...
08-10-2007, 12:19 PM
Replies: 325
Views: 128,817
Posted By touch and go

RE: Piper Tri-Pacer from Wendell Hostetler is now here!!

In response to Trisquire: In order to convert Wendell's Tripacer design to a Pacer, i.e. a conventional gear airplane, I lengthened the main gear, I moved the main gear forward so that the axle is...
Forum: Aerodynamics
08-03-2007, 12:36 PM
Replies: 13
Views: 2,543
Posted By touch and go

Effect of Aileron Chord on Roll Rate?

I was reading about the development of the new LSA RV-12 from Van's aircraft. Van's extended the chord of the aileron's by attaching an extension to the trailing edge of the ailerons (it is likely...
07-25-2007, 11:43 AM
Replies: 2
Views: 771
Posted By touch and go

RE: 33% HOSTETLER TRI PACER

As for others who have built or are building the Hostetler TriPacer see: http://www.rcuniverse.com/forum/m_1499086/anchors_1499086/mpage_1/key_hostetler/anchor/tm.htm#1499086
07-19-2007, 09:32 AM
Replies: 325
Views: 128,817
Posted By touch and go

RE: Piper Tri-Pacer from Wendell Hostetler is now here!!

Albeit slowly, some progress has been made. See photos.
05-24-2007, 08:17 AM
Replies: 4
Views: 1,317
Posted By touch and go

RE: Sun 'n Fun Fly-in

There is only one picture on the bottom and its on the left hand side; if that is the one you are referring to its a Piper Pacer, "Miss Pearl", and it has a wingspan of about 30 feet.
05-17-2007, 04:14 PM
Replies: 24
Views: 3,174
Posted By touch and go

RE: UPS SHIPPING WARNING ALL SHOULD READ!!!!

The original post says "he told them to insure it for $2000"; was this insurance in fact obtained? If so, then this fact may help your situation. Did you find out who the insurer was and make a...
05-03-2007, 01:05 PM
Replies: 325
Views: 128,817
Posted By touch and go

RE: Piper Tri-Pacer from Wendell Hostetler is now here!!

Congradulations! Your plane looks great and glad to hear that it is a good flyer. My Pacer version of Hostetler's Tripacer is in the process of being painted right now; hopefully in a few more...
05-01-2007, 12:17 PM
Replies: 1
Views: 616
Posted By touch and go

RE: CMPro Cessna Skylane

Check out the Hanger 9 Cessna 182 ARF. I have one and it looks and flies very well.
04-27-2007, 08:43 AM
Replies: 3
Views: 1,073
Posted By touch and go

RE: Sun 'n Fun Fly-in Photos

Here is the Cessna NG - "Next Generation" and the Eclipse VLJ (very light jet):
04-26-2007, 08:21 AM
Replies: 12
Views: 3,251
Posted By touch and go

What is this plane

Can anybody tell me what kind of plane this is?
04-23-2007, 04:57 PM
Replies: 3
Views: 1,073
Posted By touch and go

Sun 'n Fun Fly-in Photos

More Fly-in Photos:
04-23-2007, 04:42 PM
Replies: 4
Views: 1,317
Posted By touch and go

Sun 'n Fun Fly-in

Here are some Sun 'n Fun fly-in photos from Lakeland, Florida taken last weekend:
03-27-2007, 02:40 PM
Replies: 11
Views: 1,416
Posted By touch and go

RE: Why? Why? Why?

The rules of the sea, and the air, are that if two vessels, or aircraft, are on a collision course, such as converging at a right angle to each other, the vessel/aircraft on the right has the right...
Forum: Beginners
03-25-2007, 08:21 PM
Replies: 8
Views: 736
Posted By touch and go

RE: home remedy?

In answer to your first question, try a little bit of acetone on a rag.
Showing results 1 to 25 of 198
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.