RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: lifesintheair
Showing results 1 to 25 of 60
Search took 0.65 seconds.
Forum: Gas Engines
08-31-2004, 07:15 AM
Replies: 36
Views: 3,444
Posted By lifesintheair

RE: Ignition Noise on a Fuji 50 ( I AM GOING NUTS HELP!!)

I will later on.

brian M.
Forum: Gas Engines
08-30-2004, 04:49 AM
Replies: 11
Views: 1,626
Posted By lifesintheair

RE: 19.2volt cordless drill/excellent 50cc starter

Can you give us the model number?


Thanks My hand hurts from spinning the prop!!!!!!!!!!!!!!


Brian M.
Forum: Gas Engines
08-30-2004, 04:32 AM
Replies: 36
Views: 3,444
Posted By lifesintheair

RE: Ignition Noise on a Fuji 50 ( I AM GOING NUTS HELP!!)

Well here's the UPDATE.

I have tried everything you and I could think of and everything that you guys said. It made my radio check even futher (last ones about 75 Ft.) I was getting ready to...
Forum: Gas Engines
08-27-2004, 10:26 AM
Replies: 36
Views: 3,444
Posted By lifesintheair

RE: Ignition Noise on a Fuji 50 ( I AM GOING NUTS HELP!!)

I will try it again today. I can't get a radio check from the plane only 10 feet or less with engine running and antenna down without the throttle going hay wire and control surfaces NO control...
Forum: Gas Engines
08-27-2004, 09:07 AM
Replies: 36
Views: 3,444
Posted By lifesintheair

RE: Ignition Noise on a Fuji 50 ( I AM GOING NUTS HELP!!)

It was against he firewall it did the same thing, Then I tried it away from the firewall and it still does the same thing also. All radio equip is at least 18" away from the motor. No leads are near...
Forum: Gas Engines
08-27-2004, 06:51 AM
Replies: 36
Views: 3,444
Posted By lifesintheair

RE: Ignition Noise on a Fuji 50 ( I AM GOING NUTS HELP!!)

I just tried it yesterday and no luck at all.

I have moved everything electronic related to the middle of the plane, at least 18" away ffrom the motor and still can't get no more than 10 feet...
Forum: Gas Engines
08-25-2004, 02:34 PM
Replies: 36
Views: 3,444
Posted By lifesintheair

RE: Ignition Noise on a Fuji 50 ( I AM GOING NUTS HELP!!)

Still raining!!!!!!!!!!!!!! [:@][:o][&o]
Forum: Gas Engines
08-25-2004, 05:34 AM
Replies: 36
Views: 3,444
Posted By lifesintheair

RE: Ignition Noise on a Fuji 50 ( I AM GOING NUTS HELP!!)

The only thing I have left to do is change the push rod to nyrod. I have moved everything forward that has to do with the engine, manual cut off switch, micro kill switch with remote servo that...
Forum: Gas Engines
08-23-2004, 10:40 PM
Replies: 36
Views: 3,444
Posted By lifesintheair

RE: Ignition Noise on a Fuji 50 ( I AM GOING NUTS HELP!!)

I moved the cut-off micro switch and servo all ignition wires against the firewall, I Moved the ignition switch all the way forward also. I am going to move the RX/Battery as far back as I can get...
Forum: Gas Engines
08-23-2004, 06:53 AM
Replies: 36
Views: 3,444
Posted By lifesintheair

RE: Ignition Noise on a Fuji 50 ( I AM GOING NUTS HELP!!)

This is the older fuji 50 with the Automatic timing module. There is no ground.

Brian M.
Forum: Gas Engines
08-23-2004, 12:42 AM
Replies: 36
Views: 3,444
Posted By lifesintheair

RE: Ignition Noise on a Fuji 50 ( I AM GOING NUTS HELP!!)

It's only about 6-10 inches away from it.
I also have a external switch too. I have also heard of people taking the Negitive side of the battery lead and grounding it to the motor? Has any one...
Forum: Gas Engines
08-22-2004, 11:04 PM
Replies: 36
Views: 3,444
Posted By lifesintheair

Ignition Noise on a Fuji 50 ( I AM GOING NUTS HELP!!)

I have a sukhoi with a Fuji 50 I only have fm RX's (Hitec 8CH FM and a 147 futaba FM) and the hobby budget is pretty low right now to buy a PCM RX. I need to know any ideas of what people have used...
Forum: Gas Engines
08-13-2004, 07:19 AM
Replies: 15
Views: 1,033
Posted By lifesintheair

RE: Fuji and Amsoil 100:1

Thanks I plan to do just that.


Brian M
Forum: Gas Engines
08-12-2004, 10:41 PM
Replies: 5
Views: 661
Posted By lifesintheair

RE: Range check,, how far ????

I just had the same prolbem with a 9CAP I went through 3 RX's (PCM) and even 2 sets of servo's (digitals) in my Sukhoi with a Fuji 50. Then we put my module in a buddy's TX and not even a glitch. We...
Forum: Gas Engines
08-12-2004, 09:16 PM
Replies: 15
Views: 1,033
Posted By lifesintheair

RE: Fuji and Amsoil 100:1

Thank you for the info I plan to get the 50:1 tomorrow

brian M.
Forum: Gas Engines
08-12-2004, 08:20 PM
Replies: 15
Views: 1,033
Posted By lifesintheair

RE: Fuji and Amsoil 100:1

Thanks for the info!!!!!

Brian M.
Forum: Gas Engines
08-12-2004, 08:07 PM
Replies: 15
Views: 1,033
Posted By lifesintheair

RE: Fuji and Amsoil 100:1

So if I buy the 50:1 and lower amsoil It will work then at 40:1
Forum: Gas Engines
08-12-2004, 08:06 PM
Replies: 15
Views: 1,033
Posted By lifesintheair

RE: Fuji and Amsoil 100:1

So what did that site mean then?
Forum: Gas Engines
08-12-2004, 12:18 PM
Replies: 15
Views: 1,033
Posted By lifesintheair

RE: Fuji and Amsoil 100:1

This is from Aircraft proving grounds from the moderator that replied to this's site" http://www.rcaircraft.net/ "

So why won't this work for me?

Thanks, Brian M.
Forum: Gas Engines
08-12-2004, 12:04 PM
Replies: 15
Views: 1,033
Posted By lifesintheair

RE: Fuji and Amsoil 100:1

The engine isn't new. It is already broke in. I use the 100:1 amsoil at 60:1 in a G26 heli engine with the manufacture reccomendations. The mix instructions on the bottle goes all the way down to...
Forum: Gas Engines
08-12-2004, 08:44 AM
Replies: 15
Views: 1,033
Posted By lifesintheair

Fuji and Amsoil 100:1

Can you run Amsoil 100:1 premix at 40:1 in this engine? I run 100:1 in my Gasser heli at 60:1 with no prolbems.

Any info will help.


Thanks,

Brian M.
Forum: MarketPlace questions or problem?
01-13-2004, 05:51 PM
Replies: 1
Views: 300
Posted By lifesintheair

Motor rebuilding offer deleted? Why?

Don't you have a notification system for telling someone that there post was deleted? Give us people who want to provide a cheap service to other members for trueing coms and dynoing a motor a break!...
Forum: RC Helicopter General Discussions
11-08-2003, 11:39 PM
Replies: 11
Views: 3,279
Posted By lifesintheair

RE: Kavan Jet Ranger

Send some pics my way. I am interested in buying it if you want to sell it. I like older kits.

[email protected]

Thanks,
Brian M.
Forum: MarketPlace questions or problem?
09-19-2003, 10:30 PM
Replies: 6
Views: 457
Posted By lifesintheair

RE: How to rate a buyer?

I figured it out!!!!!!! They have to make you an offer in the classifieds first. Then you can rate them. The'll be in the drop down menu after that.

Thanks ADM.....

Brian M
Forum: MarketPlace questions or problem?
09-19-2003, 07:08 AM
Replies: 6
Views: 457
Posted By lifesintheair

RE: How to rate a buyer?

Adm,
I tried to do what you said. But I had to relist it first. Once I relisted it, I marked it sold and it just said it was expired. The drop downlist did NOT list the buyer on the thread...
Showing results 1 to 25 of 60
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.