RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: FLYBOY2000
Showing results 1 to 25 of 128
Search took 0.71 seconds.
Forum: RC Jets
05-06-2011, 08:02 AM
Replies: 21
Views: 2,232
Posted By FLYBOY2000

RE: KingCat after 5 year Hiatus

Actually

My King Cat was supposed to have the scale cockpit...so, the batteries are near the back of the fuse for CG purposes....very close to the smoke tank.!!
I'm opting to go with a full...
Forum: RC Jets
05-05-2011, 09:51 PM
Replies: 21
Views: 2,232
Posted By FLYBOY2000

RE: KingCat after 5 year Hiatus

,,,,,
So I've been doing some research and it seems like people prefer the Li Poly instead of A123's because of the way you can check remaining battery. I would like to use the two 2600 Relion...
Forum: RC Jets
04-28-2011, 11:19 PM
Replies: 21
Views: 2,232
Posted By FLYBOY2000

RE: KingCat after 5 year Hiatus

So I must have made a mistake on the type of servos that are in there..I believe they are 2721's... Dan did you need two voltage regulators for the relions?? I'd like to fly it with the installed...
Forum: RC Jets
04-21-2011, 09:19 PM
Replies: 21
Views: 2,232
Posted By FLYBOY2000

RE: KingCat after 5 year Hiatus

Thanks Dan and all,

I will have to go back and look, but I went with allthe JR servos that BVM spec'd for this bird. I think It MAY have the 4131's on flaps and Rudder ( ??) It is whatever BV...
Forum: RC Jets
04-21-2011, 07:15 AM
Replies: 21
Views: 2,232
Posted By FLYBOY2000

RE: KingCat after 5 year Hiatus

Thanks

So it looks like A123's are the way to go..I have to check to make sure my Schulze Chamelion has the firmware to charge those, I'm almost 99 percent sure it does. I had it sent to...
Forum: RC Jets
04-20-2011, 10:33 PM
Replies: 21
Views: 2,232
Posted By FLYBOY2000

RE: KingCat after 5 year Hiatus

Hi John,

As a matter of fact, after I bought the motor I drove up to Jetcat and had Spence (?) check it out and Bob also gave it his blessing..then later You gave it the checkout and the ECU...
Forum: RC Jets
04-20-2011, 11:40 AM
Replies: 21
Views: 2,232
Posted By FLYBOY2000

RE: KingCat after 5 year Hiatus

Thanks Scott,

I used to fly at El Toro then BlackStarr...but havent signed up anywhere recently. I know Pendelton used to have a wait list. I didn't even think about the gear..thanks. ...
Forum: RC Jets
04-20-2011, 07:30 AM
Replies: 21
Views: 2,232
Posted By FLYBOY2000

KingCat after 5 year Hiatus

Hi All,

About 5 years ago I completed a BVM KingCat!...( almost) I still have to install the cockpit and canopy. It was built mostly by me, with some final assembly being done by Henry Nguyen...
Forum: Kit Building
10-06-2010, 11:58 AM
Replies: 3
Views: 899
Posted By FLYBOY2000

Marutaka Citation-building OLD kit?

HI All,

I have a Marutaka/ Royal Citation original kit for sale. If I don't get asking price for it, I was thinking of building it myself. Only problem is...it is a OLD kit. It must be from...
02-25-2010, 10:55 AM
Replies: 2,583
Views: 283,207
Posted By FLYBOY2000

RE: Composite-Arf 2.6 Extra 330

Well, a call to Ray LaBonte on the east coast, my former sales rep, took care of the wing screw....Thanks Ray. Now I'm seeing if I can get the dual rudder working without a equalizer ( using the mix...
02-15-2010, 07:28 AM
Replies: 2,583
Views: 283,207
Posted By FLYBOY2000

RE: Composite-Arf 2.6 Extra 330

HI Gang,

I'm almost done with my update and ready to maiden my comp-arf 2.6. Is there anyone in South Orange County,
CA who can help with set-up /engine break-in(DA100), and finally maiden??...
01-29-2010, 11:30 AM
Replies: 2,583
Views: 283,207
Posted By FLYBOY2000

RE: Composite-Arf 2.6 Extra 330

Zeeb ,

Thanks for the great answer. I just picked up the Re-Lions, Maybe I'll run back and return them for A123's for the Rx as well. I've got regulators and relia-switches...so I guess i...
01-29-2010, 02:25 AM
Replies: 2,583
Views: 283,207
Posted By FLYBOY2000

RE: Composite-Arf 2.6 Extra 330

What is the difference between the AR9100 and the 922 JR receivers? (besides the $$)
01-28-2010, 11:52 PM
Replies: 2,583
Views: 283,207
Posted By FLYBOY2000

RE: Composite-Arf 2.6 Extra 330

Replace Clunk Line....will do

The airframe has never seen a single drop of gas. The fuel lines and Bennett tank have been dry..but will inspect the Tygon. The airplane has been sitting for...
01-28-2010, 11:18 AM
Replies: 2,583
Views: 283,207
Posted By FLYBOY2000

RE: Composite-Arf 2.6 Extra 330

Well guys Thanks,

I built this Extra and a BVM Kingcat 4 years ago. They have been stored in my garage for the past 4 years. You are right why risk all that $$ on a couple batteries.
I'm...
01-28-2010, 02:31 AM
Replies: 2,583
Views: 283,207
Posted By FLYBOY2000

RE: Composite-Arf 2.6 Extra 330

OK Here I am 4 YEARS later
I have a Brand New 2.6 with a Brand NEW DA 100 ( Never Run)
I built it and then its been in my garage So I dusted it off
I'm wondering if the batteries will still be...
10-27-2009, 10:30 AM
Replies: 1,253
Views: 225,335
Posted By FLYBOY2000

RE: New: Beech Baron and Duchess arf

Ok The sudden silence is a bit disconcerting!
Whats going on?
10-21-2009, 11:15 AM
Replies: 1,253
Views: 225,335
Posted By FLYBOY2000

RE: New: Beech Baron and Duchess arf

So I hope the production is going well. Cliff, about what is the price for the retracts/struts?
How is a Nov arrival date looking?

Thanks

-FB
09-27-2009, 11:24 PM
Replies: 1,253
Views: 225,335
Posted By FLYBOY2000

RE: New: Beech Baron and Duchess arf

That Video was very nice. That Baron looks just great..very nice.
Is it still powered with the Eflight .32??

FB
09-26-2009, 11:36 AM
Replies: 1,253
Views: 225,335
Posted By FLYBOY2000

RE: New: Beech Baron and Duchess arf

Again Great work scale.

About what price point are you shooting for the electric Retracts? Did you say 'artwork film' on the wings?.... I hope you guys don't go crazy with that 'printed' on...
09-26-2009, 12:51 AM
Replies: 1,253
Views: 225,335
Posted By FLYBOY2000

RE: New: Beech Baron and Duchess arf

Wow, wow wow!!!

Spec...Tac...U...Lar. ! I'm calling you on Monday to Order. Are those brakes on the mains?? Great scale detail.. all done for you.
I don't know if I'd spend all the time...
09-23-2009, 11:08 PM
Replies: 1,253
Views: 225,335
Posted By FLYBOY2000

RE: New: Beech Baron and Duchess arf

Single Control Tube system for the Flaps/Ailerons.. very eeenteresting!
Glad you'll be able to get some sleep all the way back state-side. Do what I do and ask for a layover in Honolulu, to get...
09-23-2009, 11:19 AM
Replies: 1,253
Views: 225,335
Posted By FLYBOY2000

RE: New: Beech Baron and Duchess arf

Scale,

Thanks...work hard on the molds. Glad to hear about the re-inforcement of the fuse. I'll call you when your back state-side.
One other question.. Are you using standard control...
09-22-2009, 02:52 AM
Replies: 1,253
Views: 225,335
Posted By FLYBOY2000

RE: New: Beech Baron and Duchess arf

Ok
I wanted to pre-order the Baron this morning and called their Washington number
Got someone who said that they 'don't have them yet' and ' wont have any until maybe end of October or early...
09-21-2009, 10:48 AM
Replies: 1,253
Views: 225,335
Posted By FLYBOY2000

RE: New: Beech Baron and Duchess arf

Wow,

Just discovered this thread. Calling now to pre-order. Looking at the work he has done on the Heli Bodies i.e.. the MD500..this guy knows how to make a mold!...and it shows.
Approved...
Showing results 1 to 25 of 128
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.