RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: NathanGerhards
Showing results 1 to 25 of 42
Search took 0.69 seconds.
Forum: ARF or RTF
10-10-2003, 03:32 AM
Replies: 571
Views: 81,972
Posted By NathanGerhards

RE: GP Lancair ES Pictures

You don't glue the flap servos, yes with the ailerons.
The really only hard piece to worry about is the front and back formers. Alittle hard to work with. they didn't fit mine, I had to sand down...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
10-03-2003, 03:32 AM
Replies: 2
Views: 386
Posted By NathanGerhards

RE: Assymetric here also.

You explained it all, Thank you so very much!!!!
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
10-02-2003, 04:29 AM
Replies: 2
Views: 386
Posted By NathanGerhards

Assymetric here also.

I have Hitec 322 in my plane and one servo moves 1/4 inch more than the other direction. I have to use my JR 8103 to program the throw to match others, but now the dilemma is that I have both servos...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
10-02-2003, 04:15 AM
Replies: 137
Views: 14,755
Posted By NathanGerhards

RE: VOTE! Airtronics-Futaba-Jr-Hitec

JR 8103 or 10x ALL THE WAY.
Futaba next.
Jr just has better graphics and quality and program ease.!!!!!!!
Forum: ARF or RTF
09-28-2003, 04:36 AM
Replies: 226
Views: 23,868
Posted By NathanGerhards

RE: OK who is getting GP. Lancair ??

I am finishing up mine and not to brag, I put the Saito 100 and it fits almost all inside. I had to dremel two small oval shaped circles parallel for the rocker covers. Them being chrome color...
Forum: ARF or RTF
09-28-2003, 04:14 AM
Replies: 226
Views: 23,868
Posted By NathanGerhards

RE: OK who is getting GP. Lancair ??

Maybe it was me, but I had a problem with the Servo covers on the flaps. "AFTER" I made the servo mounts onto the cover, I began to seat them into the wing and it was so for off not even funny. I...
Forum: ARF or RTF
09-27-2003, 05:29 AM
Replies: 0
Views: 431
Posted By NathanGerhards

regarding control thows for GP Lancair

I am on the finishing stage of my kit. I just read about the Elevator throws in High are only 1/2 up and 1/2 down. That just doesn't seem that much. IS IT? and and low rates its 1/4 squared. ...
Forum: RC Car General Discussions
08-31-2003, 08:19 AM
Replies: 8
Views: 936
Posted By NathanGerhards

oops and

so its the wind itself that determinds what direction the sail will swing out. So that means you don't have to have left and right just one way that rolls in and the let out. true?
Forum: RC Car General Discussions
08-31-2003, 08:15 AM
Replies: 9
Views: 1,726
Posted By NathanGerhards

I am right behind you

I plan on using 1/2 of a small wing from a plane with fully semetrical wing.
Forum: RC Car General Discussions
08-31-2003, 08:14 AM
Replies: 8
Views: 936
Posted By NathanGerhards

so what your saying

those little tabs that stop the over turning of the servo are cut off?
Then tech. the servo will spin faster as you advance the stick.
Forum: RC Car General Discussions
08-31-2003, 08:10 AM
Replies: 3
Views: 704
Posted By NathanGerhards

so then.....

it takes a special servo, not just plain one with a whinch adapter?
Forum: RC Car General Discussions
08-29-2003, 09:13 AM
Replies: 3
Views: 704
Posted By NathanGerhards

Sail Winch servo

So I've learned that this wind jammer uses a winch towind the lind of the sail in, though how do you determin what direction the wing will then go. How do you minipulate the sail. ie. The sail is...
Forum: Questions and Answers
08-26-2003, 09:57 AM
Replies: 6
Views: 724
Posted By NathanGerhards

Please do not take this wrong

Everyone starts out new at something. RC is not something you can just jump into, though if you have all the money in the world then I would say to do just that. But for the majority. Start slow...
Forum: Questions and Answers
08-26-2003, 09:40 AM
Replies: 7
Views: 4,167
Posted By NathanGerhards

just 2 cents here

all above are correct, I want to make a comment on when you said it is fine three feet off the ground, that is because you are in ground effect. its like a cusion of air keeping the plane flying.
Forum: Questions and Answers
08-26-2003, 09:36 AM
Replies: 26
Views: 2,295
Posted By NathanGerhards

Try cross control

On turning final,had a little and I mean little bit of rudder opposit of wind and then ailerons opposit of rudder. then add even aileron and opposit rudder to slow the plane down, besure youmay need...
Forum: The Clubhouse
08-24-2003, 06:46 AM
Replies: 20
Views: 7,993
Posted By NathanGerhards

Swiveling

On the Sail type car, not wing pers`e, how is the wing swiveled. Such as on a sail boat?
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
08-21-2003, 11:58 AM
Replies: 0
Views: 387
Posted By NathanGerhards

Looking for JR ch 46 (72.710)

In need of JR rx single conversion gray color ch 46 (72.710) please email me at [email protected] with ch46 in the subject line.
Thanks
Nathan
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
08-21-2003, 09:42 AM
Replies: 5
Views: 648
Posted By NathanGerhards

If you change

He is right about High and low, but chaging any ch you should get your TX dialed for it. For instance if you are ch 12 (low band) and change to 15 (low band) or 13 Low band) to 46 (high band)...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
08-21-2003, 09:09 AM
Replies: 22
Views: 1,418
Posted By NathanGerhards

We need more RC fellows like you

Like you that care and don't seem like they are only doing it forthemself is a true RC club member. Because of you I printed it out and shared it with my club members. Some knew somewhat of the...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
08-17-2003, 08:32 AM
Replies: 7
Views: 998
Posted By NathanGerhards

Thanks soo much

All that you said makes sense and that's what I thought. I just wanted to clear it up so I don't have to CLEAN up my airplane from the trees. if you know what I mean. ha ha h
Thanks
Nathan
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
08-15-2003, 07:56 AM
Replies: 7
Views: 998
Posted By NathanGerhards

confused

I have the 8103 JR and on 46, I was told that Hitec works with it but I know it is single convertion, my q also was is dual mean it can go either? I use JR stuff with expensive airplanes and I have...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
08-15-2003, 07:19 AM
Replies: 7
Views: 998
Posted By NathanGerhards

will this chrystal work, Sing;e radio with Dual chrystal

This is a Hitec AM/FM 72 MHz Dual Conversion Receiver Crystal.

FEATURES: Replaces or changes the frequency crystal of a receiver.
This is used for Hitec radios on Channels 11-60.
...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
08-14-2003, 11:14 AM
Replies: 2
Views: 478
Posted By NathanGerhards

Exellent!

What a great help. Thanks
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
08-14-2003, 09:51 AM
Replies: 2
Views: 478
Posted By NathanGerhards

Very Familiar with JR8103? Q here

I have my CG Extra300 set-up with flaperons and works great, now I am on my second added plane and want to use the same set-up but also add two more servoes to actually run as the main flaps. IS...
Forum: The Clubhouse
07-28-2003, 04:59 PM
Replies: 13
Views: 1,445
Posted By NathanGerhards

When landing P Factor

High Angles of attack/ yes higher throttle, though any throttle setting will give you a more p factor, the descending blade bites more. Most of us land with nose high attitude. I do with my RC and...
Showing results 1 to 25 of 42
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.