RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: oisf3a
Showing results 1 to 25 of 55
Search took 0.80 seconds.
Forum: Electric Pattern Aircraft
04-19-2010, 02:13 AM
Replies: 72
Views: 17,486
Posted By oisf3a

RE: Delro ADDICTION

Hi again,

I managed to get in 16 flights last week (for me this is a lot ...!) with my new Addiction. After som minor adjustments I think the basic setup is now completed.
The model performs...
Forum: Electric Pattern Aircraft
04-12-2010, 02:55 AM
Replies: 72
Views: 17,486
Posted By oisf3a

RE: Delro ADDICTION

Hello Henning

Congrats on your maiden flights !
I have also made a very light rudder, and even though I have two servos for the elevator in the tail my batteries are almost as far back as...
Forum: Electric Pattern Aircraft
03-25-2010, 02:30 PM
Replies: 72
Views: 17,486
Posted By oisf3a

RE: Delro ADDICTION

Hi


Another Delro Addiction has taken to the air, this time from the still cold and winterly Norway.
I had the chance to fly the model for first time today from a paved runway while our...
Forum: Electric Pattern Aircraft
03-20-2010, 04:17 AM
Replies: 72
Views: 17,486
Posted By oisf3a

RE: Delro ADDICTION

Hi again

One more question regarding the setup of the Addiction.
I have mounted the motor so that the backplate of the spinner aligns perfectly with the front of the fuselage. This is how the...
Forum: Electric Pattern Aircraft
03-19-2010, 06:20 AM
Replies: 72
Views: 17,486
Posted By oisf3a

RE: Delro ADDICTION

Hi

I am in the last stages of completing my Delro Addiction. The manual says the CG should be @ 168 mm from the leading edge of the wing root.
This is approximately at the rear of the wing...
Forum: RC Pattern Flying
12-07-2009, 04:33 AM
Replies: 10
Views: 1,805
Posted By oisf3a

RE: Anyone tried glow-powering a Seb. Miss-Wind50?

Hi again

You are of course welcome to inspect my Miss Wind anytime if you still have some motivation left after seeing the nose pictures !

Øistein
Forum: RC Pattern Flying
12-06-2009, 11:55 AM
Replies: 10
Views: 1,805
Posted By oisf3a

RE: Anyone tried glow-powering a Seb. Miss-Wind50?

Hi Audun

With your well-known passion for biplanes I am not surprised about your idea...
I have had the Miss Wind 50E for about a month but only managed to fly 8-10 flights due to the bad...
Forum: RC Pattern Flying
11-01-2009, 09:25 AM
Replies: 14
Views: 2,104
Posted By oisf3a

RE: Futaba Fasst and servos from diffrent brands?

Hello Rune

I have mixed Futaba, JR/Graupner, Hitec, Savox/Align, HG .... the two last years with no problems at all.
I am planning to use a mix og JR and Futaba servos for my new model for the...
Forum: Electric Pattern Aircraft
07-02-2009, 01:02 AM
Replies: 181
Views: 32,487
Posted By oisf3a

RE: Delro E-Motion kit

Hi

Could some of you that have flown both the e-Motion and the Addiction comment on how they compare with respect to flight characteristics.
I am especially interested in how they perform in...
Forum: Electric Pattern Aircraft
05-05-2009, 02:03 PM
Replies: 3
Views: 1,315
Posted By oisf3a

Smoked CC HV85 ESC !

Hi

Today I tested my CC 85HV ESC / AXI 5330 F3A combo for the first time. I used a APC 20-14 pulling about 70A static.
I used the 1.56 firmware and the typical settings like low advance and...
Forum: RC Pattern Flying
03-08-2009, 07:33 AM
Replies: 10
Views: 1,755
Posted By oisf3a

RE: Graupner servoes - any experience in pattern plane?

Hi Espen

Note that Graupner servos are actually made by JR.... The type number are not the same but the servos themselves are more or less identical.
I have used DS8081 several times with good...
Forum: RC Pattern Flying
10-04-2008, 03:22 PM
Replies: 8
Views: 1,025
Posted By oisf3a

RE: prop for OS 91FX

David, were have you been the last years ?

Anyway, nice to hear you're on it again :-)


I assume we'll see you on the competition scene next year ?

And regarding your switch from...
Forum: RC Pattern Flying
08-25-2008, 03:13 PM
Replies: 27
Views: 6,580
Posted By oisf3a

RE: Best glow driver?

Hi

This is definitely the ultimate glow driver for YS...


www.hobbycity.com/hobbycity/store/uh_viewItem.asp?idProduct=6609&Product_Name=iCharger_1010B_200W_10s_Balance/Charger

As a...
Forum: Electric Pattern Aircraft
07-11-2008, 01:37 AM
Replies: 16
Views: 3,032
Posted By oisf3a

RE: Receivers for electric models

Hi

I understand you are after a 35 Mhz receiever but I will just inform you that I have been flying a Futaba FASST 2.4 Module in my Graupner MC24 since october 2007 in two different F3A models,...
Forum: Electric Pattern Aircraft
04-16-2008, 01:34 PM
Replies: 5
Views: 2,964
Posted By oisf3a

RE: Spin 99 / Jeti Box error message

Hi again

I was out flying this afternoon, and when I put the Jeti box inside my clothes for a few minutes it suddenly came to life and connected to the ESC.
Obviously a temperature tolerance...
Forum: Electric Pattern Aircraft
04-16-2008, 04:54 AM
Replies: 5
Views: 2,964
Posted By oisf3a

RE: Spin 99 / Jeti Box error message

Thanks a lot.

That confirms what I had suspected, because sometimes I have been able to get it out of the error mode by keeping it powered on and in my hands for a long time.
Yesterday, it was...
Forum: Electric Pattern Aircraft
04-15-2008, 02:46 PM
Replies: 5
Views: 2,964
Posted By oisf3a

Spin 99 / Jeti Box error message

Hi all

I have a Axi 5330 F3A / Spin 99 combo where I want to change the brake parameters. However , when I connect the Jeti Box I just get the message "Communication error". It has worked OK...
Forum: Electric Pattern Aircraft
12-09-2007, 11:48 AM
Replies: 23
Views: 4,030
Posted By oisf3a

RE: High prices of electric motors and batteries

Hi OhD !

I have not yet heard of anyone else being able to get 400 flights out of a LiPo pack when being used for F3A so this is interesting. Could you inform us a little bit about your...
Forum: RC Pattern Flying
11-17-2007, 10:56 AM
Replies: 11
Views: 2,039
Posted By oisf3a

RE: Vinter time!

Hi Rune

I was also out flying today, nice winter weather. I got only two flights with my old Impact.
It was more exciting than usual because I had two major changes to the whole setup....

...
Forum: YS Engines Support
09-25-2007, 01:22 PM
Replies: 8
Views: 1,315
Posted By oisf3a

RE: Header for 170

Hi XMANS

Do you have any experience from cleaning carbonized head assemblys using this coolant cooking method ?
I have a YS 140L head (actually from a 140DZ) that is totally messed up with...
Forum: RC Pattern Flying
11-25-2006, 03:01 PM
Replies: 35
Views: 18,433
Posted By oisf3a

RE: "T" Canalizer - Mole or Beauty Spot?

Hi

I am about to start building two T-canalizers for my Synergys but can't find any drawings even though I think I have seen some here on the forum. Can someone help me with drawings for the...
Forum: RC Pattern Flying
05-31-2006, 01:41 PM
Replies: 1,280
Views: 568,172
Posted By oisf3a

RE: post some pictures of your pattern plane!!

Hi

This is my new Synergy with OS140Rx. It flew for the first time a few days ago. No surprises, It felt very good after a little tweaking of the throws and expos. The OS140Rx is spinning an...
Forum: RC Pattern Flying
02-07-2006, 06:04 AM
Replies: 1,280
Views: 568,172
Posted By oisf3a

RE: post some pictures of your pattern plane!!

Hallo Magne

Your new model looks really, really nice ! Looking forward to see it fly in F3A next year...right ?
What is encouraging to me is to see that it is possible to complete such a...
Forum: RC Pattern Flying
02-03-2006, 04:10 PM
Replies: 37
Views: 4,844
Posted By oisf3a

RE: Rolling issues with Comp ARF Impact

Hello Dean and others

Your analysis of the problem is perfectly in line with mine, but you probably described it with better words.

The aileron hinge arrangement on the Impact is definitely...
Forum: RC Pattern Flying
01-29-2006, 04:13 PM
Replies: 37
Views: 4,844
Posted By oisf3a

RE: Rolling issues with Comp ARF Impact

Here in Norway, at least three Impact owners have had the same rolling problems as described by others in this thread.
I've investigated this in numerous flights and my preliminar conclusion is...
Showing results 1 to 25 of 55
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.