RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: sadsack
Showing results 1 to 6 of 6
Search took 0.25 seconds.
Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service
03-22-2010, 02:49 PM
Replies: 6
Views: 1,203
Posted By sadsack

RE: signal wire in Eclipse transmitter

I am glad you answered, creek. Good info on the servo current draw problem, my attention will now focus more in that area. I am using 9g servos in a 20a motor with 2200mah 20c lipo. Flying...
Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service
03-18-2010, 08:31 AM
Replies: 6
Views: 1,203
Posted By sadsack

RE: signal wire in Eclipse transmitter

I must admit, these forums are very helpful with you experts freely giving helpful advice. Thanks again. My Eclipse is now successfully transmitting in 2.4ghz! And what a neat installation. I...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
03-09-2010, 01:33 PM
Replies: 6
Views: 1,628
Posted By sadsack

RE: Corona DSSS 2.4 receivers

Corona has a new diy kit that installs inside any transmitter. Just solder three leads, signal, positive, ground and the antenna wire. The kit comes with 8ch receiver also. Get it at Hobby King...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
03-09-2010, 01:29 PM
Replies: 6
Views: 1,628
Posted By sadsack

RE: Corona DSSS 2.4 receivers

I hope it starts this time, I'm on my last finger
Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service
03-09-2010, 12:04 PM
Replies: 6
Views: 1,203
Posted By sadsack

RE: signal wire in Eclipse transmitter

Thank you Alan for the quick reply. Actually, I am installing the new diy 2.4g Corona module which is installed internally. I just need to find where a signal wire land where I can solder the...
Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service
03-08-2010, 10:59 PM
Replies: 6
Views: 1,203
Posted By sadsack

signal wire in Eclipse transmitter

Could I get a picture of where I can tap into the signal wire in the Eclipse transmitter?
Showing results 1 to 6 of 6


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.