RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: DRosa
Showing results 1 to 7 of 7
Search took 0.25 seconds.
01-01-2010, 06:19 PM
Replies: 3
Views: 1,380
Posted By DRosa

RE: Art tech falcon 400

Ya we had to plug the rate wire into channel 5(it was tied and not plugged into the RX) and no luck there either,although I received a text from my cousin today stating he figured it out,turns out we...
12-27-2009, 07:26 PM
Replies: 3
Views: 1,380
Posted By DRosa

Art tech falcon 400

My cousin has recieved a Falcon 400 for christmas and we can't get the gyro to iniatlize,we have tried turning the tx on in heading hold and non-heading hold and turning the heli on,throttle trim set...
09-15-2009, 08:56 PM
Replies: 3
Views: 1,848
Posted By DRosa

RE: default radio settings on the genesis 450 pe

Thanks,there must be a few differences in the set-up's between the Blue ray and the Genesis because I tried the Blue ray set-up and it needed some tweaking to make it right,but it put me in the right...
09-14-2009, 12:05 PM
Replies: 3
Views: 1,848
Posted By DRosa

default radio settings on the genesis 450 pe

I screwed up when saving the default settings from my radio.Now I can't get the damn thing to work,could someone please either give me some in sight or better yet send me the default settings for the...
09-06-2009, 04:05 PM
Replies: 3
Views: 898
Posted By DRosa

RE: Help me please...

I forgot to mention which way the switch should be,for normal flight the toggle should be flipped forward,and flipped back towards you will be idle up.Hope this helps.
09-06-2009, 04:02 PM
Replies: 3
Views: 898
Posted By DRosa

RE: Help me please...

Are the toggle switch's on the radio both switched forward?The one on the left is idle up and will give you negative pitch for flying inverted when throttle stick is at bottom.
08-21-2009, 10:34 PM
Replies: 1
Views: 826
Posted By DRosa

feathering shaft removal

What size are the nuts on the feathering shaft on the genesis,and is there a special tool to get at them in the blade grips?
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.