RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 4
1
2
3
Last »
Search: Posts Made By: LenAlessi
Showing results 1 to 25 of 85
Search took 1.10 seconds.
Forum: RC Jets
04-07-2021, 05:28 AM
Replies: 2
Views: 677
Posted By LenAlessi

Try Increasing the percentage of travel to at...

Try Increasing the percentage of travel to at least 125% if the Futaba was at 100%
Forum: RC Jets
01-05-2020, 06:31 AM
Replies: 538
Views: 111,601
Posted By LenAlessi

Increase the travel of the channel. Since...

Increase the travel of the channel. Since Spektrum uses +- 150% you may need to crank it up to 125% or more to have equivalent travel of another radio that only goes to 125%.
Forum: RC Jets
06-21-2019, 12:57 PM
Replies: 10
Views: 1,435
Posted By LenAlessi

Slow the channel down?

Slow the channel down?
Forum: RC Jets
11-13-2018, 10:21 AM
Replies: 17
Views: 2,133
Posted By LenAlessi

Any mix to the gain channel(s) will change the...

Any mix to the gain channel(s) will change the gain. A positive value will increase gain for rate mode controls (non-Heading Hold (HH)) while a negative value decreases gain for rate mode channels. ...
Forum: RC Jets
08-28-2018, 12:39 PM
Replies: 3
Views: 2,346
Posted By LenAlessi

Is this what you need?

Is this what you need?
Forum: RC Jets
08-26-2018, 10:04 AM
Replies: 3
Views: 478
Posted By LenAlessi

PM sent

PM sent
Forum: RC Jets
08-25-2018, 12:52 PM
Replies: 3
Views: 478
Posted By LenAlessi

WANTED Nose Gear DER JET Cougar

WANTED Nose Gear parts/strut for DER JET Cougar - especially yoke that holds axle. Please PM me if available. Thanks!
Len
Forum: RC Jets
06-28-2018, 12:39 PM
Replies: 14
Views: 1,905
Posted By LenAlessi

Data (Straight Thru) Duplex Jack (DC-101J-666)

Data (Straight Thru) Duplex Jack (DC-101J-666)
Forum: RC Jets
06-28-2018, 11:20 AM
Replies: 14
Views: 1,905
Posted By LenAlessi

I use these. ...

I use these.
https://ppeci.com/index.php/products/list/cat/duplex-jacks/240
Forum: RC Jets
09-14-2017, 11:02 AM
Replies: 59
Views: 20,229
Posted By LenAlessi

Is it possible that a strong signal from the TX...

Is it possible that a strong signal from the TX being in close proximity to the controller when it is powered-up is scrambling things? I once had a controller that would lose it's proportional...
Forum: RC Jets
07-15-2017, 09:12 AM
Replies: 6
Views: 1,432
Posted By LenAlessi

If you haven't already tried it, try increasing...

If you haven't already tried it, try increasing the travel of the channel in both directions.
Forum: RC Jets
07-11-2017, 03:04 AM
Replies: 60
Views: 5,291
Posted By LenAlessi

If you can post your SPM file I will have a look...

If you can post your SPM file I will have a look at it to see where the problem is.
Len
Forum: RC Jets
06-29-2017, 11:44 AM
Replies: 60
Views: 5,291
Posted By LenAlessi

Pulsing Smoke Sequencer - Step by Step

Hi Guys,
I threw together a sequencer and supporting program mixes this AM that I believe will work to produce pulsing smoke. I haven't tried it in actual application but the TX monitor says it's...
Forum: RC Jets
04-05-2017, 02:16 AM
Replies: 25
Views: 3,140
Posted By LenAlessi

Looks the same but don't know if it is. ...

Looks the same but don't know if it is.
https://www.amazon.com/Deep-Blue-Professional-ADB88860-Aquarium/dp/B00BUFZJP0
Forum: RC Jets
04-02-2017, 11:03 AM
Replies: 22
Views: 2,425
Posted By LenAlessi

+1 I have melted some of them with 4A @ 6-7V...

+1

I have melted some of them with 4A @ 6-7V while charging A123 packs.
Forum: RC Jets
03-31-2017, 02:16 PM
Replies: 37
Views: 6,649
Posted By LenAlessi

Sorry - I was talking just about the Tygon...

Sorry - I was talking just about the Tygon portion of the fuel system. Turbine is relatively new and things look great under the hood last time I looked a few months ago when I changed an O-ring. ...
Forum: RC Jets
03-31-2017, 04:45 AM
Replies: 37
Views: 6,649
Posted By LenAlessi

I have a Euro Sport that is over 8 years old and...

I have a Euro Sport that is over 8 years old and the original Tygon tubing is as flexible, or slightly more so, as the day it was installed.
Forum: RC Jets
01-22-2017, 08:43 AM
Replies: 6
Views: 1,275
Posted By LenAlessi

Recheck/adjust Pump Start voltage

Recheck/adjust Pump Start voltage
Forum: RC Jets
11-13-2015, 06:41 AM
Replies: 440
Views: 117,705
Posted By LenAlessi

Thanks for the info Dean - I'll move it back...

Thanks for the info Dean - I'll move it back some.
Len
Forum: RC Jets
11-12-2015, 02:32 PM
Replies: 440
Views: 117,705
Posted By LenAlessi

I am assembling a turbine ready Dolphin with...

I am assembling a turbine ready Dolphin with trainer wing for a friend. I have the CG set just shy of 1/4" ahead of the indicated CG on the wing root. Any idea if this is a good starting point or...
Forum: RC Jets
03-13-2009, 10:47 PM
Replies: 9
Views: 1,316
Posted By LenAlessi

RE: 12X RTRM question

It's pretty easy... Go into Device Select and change the control of Aux7 from AUX7 KB to the Right Trimmer by scrolling until the Right Trimmer is displayed. Now you can move the steering with the...
Forum: RC Jets
02-12-2009, 06:07 AM
Replies: 0
Views: 626
Posted By LenAlessi

Fei Bao Velox XL - Shim height for turbine

Looking for how much to shim the front of the turbine mounts on a Fei Bao Velox XL to eliminate climbing with the application of power. Thanks in advance.


Len
Forum: JetCat Turbine Direct Support
02-25-2008, 06:47 AM
Replies: 17
Views: 1,779
Posted By LenAlessi

RE: my kerostart failed today

How do I know which version kero plug I have? I received a replacement about 2 months ago but have not used it yet.

TIA,

Len
Forum: JR Radio & Spektrum Radios
01-04-2008, 01:38 PM
Replies: 8
Views: 1,227
Posted By LenAlessi

RE: 9303 2.4Ghz programming

You can go to the following link and scroll down the page to MANUALS where you can access 9 different manuals/programming examples that may prove helpful. While they are for the 72mHz version of the...
Forum: JR Radio & Spektrum Radios
10-28-2007, 02:27 AM
Replies: 2
Views: 1,635
Posted By LenAlessi

RE: X9303 NEED AILERON SETUP HELP

Once you select Flaperon as the wing type you are finished - there is no need to assign a dual channel for ailerons as it has already been done by the system. Just plug the right aileron into the...
Showing results 1 to 25 of 85
 
Page 1 of 4
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.