RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: Dr. Fosgate
Showing results 1 to 25 of 53
Search took 0.22 seconds.
Replies: 53
Views: 8,890
Posted By Dr. Fosgate

RE: 2.4Ghz Range Sucks

Problem solved. I got the transmitter and receivers back from KO Propo this week. Put them in my truck today. Totally glitch free, and now has so much range I can hardly see the truck and still...
Replies: 53
Views: 8,890
Posted By Dr. Fosgate

RE: 2.4Ghz Range Sucks

In the truck (and the boat) the antenna is vertical. The truck has a clear polycarbonate body, with a hole in it so the antenna sticks out. This receiver only has a 5 or 6 inch antenna though. In...
Replies: 53
Views: 8,890
Posted By Dr. Fosgate

RE: 2.4Ghz Range Sucks

That is true. I would not put a cheap radio on the boat, but in the case of the cars and trucks I have, I am not as concerned.
Replies: 53
Views: 8,890
Posted By Dr. Fosgate

RE: 2.4Ghz Range Sucks

Atomic told me to contact KO first, and KO told me to send it in to them. At this point that is my plan, send it in. When I get it back I will see what the results are. If it still does not meet...
Replies: 53
Views: 8,890
Posted By Dr. Fosgate

RE: 2.4Ghz Range Sucks

Sorry then, no big deal. I figured with the get what you pay for and get a grip comments you were just taking a jab.

At this point I have tried the following equipment in many combinations with...
Replies: 53
Views: 8,890
Posted By Dr. Fosgate

RE: 2.4Ghz Range Sucks

I just got it in the mail Saturday! :D
Replies: 53
Views: 8,890
Posted By Dr. Fosgate

RE: 2.4Ghz Range Sucks

Yes, I bought it online from my atomic.

I sent KO Propo an email about it. I will contact my atomic and see what they can do.
Replies: 53
Views: 8,890
Posted By Dr. Fosgate

RE: 2.4Ghz Range Sucks

I just measured the output voltage of the BEC on the ESC. I am getting 5.59V.
Replies: 53
Views: 8,890
Posted By Dr. Fosgate

RE: 2.4Ghz Range Sucks

The manual on the ESC says 6V BEC. I can probably make up a pigtail and measure the voltage to confirm this.
Replies: 53
Views: 8,890
Posted By Dr. Fosgate

RE: 2.4Ghz Range Sucks

Thanks for the encouragement, I need it.

I probably should not have titled my post what I did, but at the point I wrote it I was ready to smash this radio on the cement and jump on it. I am...
Replies: 53
Views: 8,890
Posted By Dr. Fosgate

RE: 2.4Ghz Range Sucks

Well, I had high hopes the battery voltage was to blame.

I put 8 fresh new non rechargeable 1.5V AA batteries in the transmitter. The voltage jumped up to 12.9V on the display. Running the...
Replies: 53
Views: 8,890
Posted By Dr. Fosgate

RE: 2.4Ghz Range Sucks

Having never used 2.4GHz radio gear before I did not know what to expect. My 15 year old AM equipment can go 10 times as far as this radio can.

What do you mean by "get what I pay for"? This...
Replies: 53
Views: 8,890
Posted By Dr. Fosgate

RE: 2.4Ghz Range Sucks

Well, next step is going to be trying 1.5V batteries then.

On a side note, does anyone know the differences between the KR-407S, KR-408S, and KR-409S receivers, other than the price?
Replies: 53
Views: 8,890
Posted By Dr. Fosgate

RE: 2.4Ghz Range Sucks

Here are some photos of the installation in the truck. Is there anything I am doing wrong in these photos?

http://www.soundbuggy.com/Eric/radio_controlled/x5ur_test_2.JPG

...
Replies: 53
Views: 8,890
Posted By Dr. Fosgate

RE: 2.4Ghz Range Sucks

The batteries are new, so maybe that is an issue. But, they were in the truck, not the boat. In the boat I am using a 4-cell receiver pack.

The antenna is in the stock location on the truck...
Replies: 53
Views: 8,890
Posted By Dr. Fosgate

RE: 2.4Ghz Range Sucks

Below is a photo of my super scientific test setup. ;)

I placed that about 3 feet in the air. I set the failsafe to full motion in one direction. I walked away from the setup with the...
Replies: 53
Views: 8,890
Posted By Dr. Fosgate

RE: 2.4Ghz Range Sucks

Well, I think I covered that with the boat test. The boat is a nitro boat. It has only the receiver, the 4-cell battery pack, and two servos. I get about 80 feet of range from the boat (engine is...
Replies: 53
Views: 8,890
Posted By Dr. Fosgate

RE: 2.4Ghz Range Sucks

Here is some additional information. The motor in my truck is an old Green Machine 2. I believe it has internal capacitors installed in it. I do not have capacitors installed externally on the...
Replies: 53
Views: 8,890
Posted By Dr. Fosgate

RE: 2.4Ghz Range Sucks

Thanks guys for the responses!

The radio is brand new (or so I assume). I got it from www.myatomic.com

I took it out of the box, loaded it up with 8 rechargeable NiMH batteries (fully...
Replies: 53
Views: 8,890
Posted By Dr. Fosgate

RE: 2.4Ghz Range Sucks

Thank you very much for the response, I really appreciate it.

I did not want to post KO range sucks, unless all KO radios have poor range, which I don't know. I looked over the whole manual and...
Replies: 53
Views: 8,890
Posted By Dr. Fosgate

2.4Ghz Range Sucks

I just bought a KO Propo EX-5 UR. What is the range on it? I bought it assuming it was better than my 15 year old AM Airtronics XL2P. Well, I think I was wrong.

I put one receiver in my truck...
Replies: 0
Views: 668
Posted By Dr. Fosgate

Vintage Losi LXT Wheels and Tires

Hopefully this is a good spot to post this.

I dug my old Losi LXT out of storage and want to get it going again. I just want it for driving around the yard, and would like to step up to a...
Forum: Glow Engines
12-11-2009, 11:11 AM
Replies: 9
Views: 7,712
Posted By Dr. Fosgate

RE: O.S. .12CV Rebuild

It has been forever, but I finally have all the work done on my engine and it is ready to go in my boat. I ended up scrapping the pull start. I bought a rear cover for it, and I cut the nub off the...
11-29-2009, 05:30 PM
Replies: 1,928
Views: 228,851
Posted By Dr. Fosgate

RE: .12 Rigger Kits for CHEAP!

The sidewalls for my tub were pretty warped so I ended up building an assembly jig to keep them square when I glued the bottom on. So far I think the kit goes together pretty good. It takes a while...
11-29-2009, 02:37 AM
Replies: 1,928
Views: 228,851
Posted By Dr. Fosgate

RE: .12 Rigger Kits for CHEAP!

Thanks guys for the responses. I would love to see other transom ideas if you have em to post.

Here is probably a stupid question. What do I do inside the brass shaft tube? I think this has...
Showing results 1 to 25 of 53
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.