RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: Basil Yousif
Showing results 1 to 25 of 500
Search took 0.99 seconds.
11-17-2023, 10:23 PM
Replies: 3
Views: 495
Posted By Basil Yousif

I just purchased the 2,440 mm (96") Wingspan...

I just purchased the 2,440 mm (96") Wingspan 80cc-100cc engine P51 - I got two planes one in Gunfighter scheme and the other in Miss America scheme.
The Manual sais the Center of Gravity CG is...
10-21-2023, 09:29 PM
Replies: 0
Views: 305
Posted By Basil Yousif

Futaba 18MZ - Two Sitches to operate Jet wheel Brakes.

I have the Futaba 18MZ and want to configure the Brake on my Jet to operate from two switches. One solid switch and the other a spring loaded. Solid switch setting for keeping the Jet stationary...
04-22-2023, 11:03 AM
Replies: 6
Views: 1,351
Posted By Basil Yousif

HI Bill - That's what I though it's also like my...

HI Bill - That's what I though it's also like my 16iz the charge circuit is in the battery so all it wants is DC current. And for sure you can't charge the batery with a charger.
Great so a plain...
04-15-2023, 08:58 AM
Replies: 6
Views: 1,351
Posted By Basil Yousif

Futaba 18MZ - power adapter/battery charger dead - Amazon adapter good

I have a Futaba 18MZ transmitter around 7 years old. The power adapter battery charger went out. Can I use a 12olt DC 3 amp monitor 110v adapter they have on Amazon for $11.
Same specs on the output...
Forum: Marketplace
07-29-2022, 02:32 PM
Replies: 0
Views: 283
Posted By Basil Yousif

Top RC Giant 60cc P51 Gunner, Blondie or Old Crow Parts needed

I am looking for parts for A Top RC 60CC P51 - Parts. I have the fuselages for a Gunner and a Blondie P51's, If someone has a crashed model with bad fuselage, I can buy the wings elevator panels cowl...
03-13-2022, 08:24 AM
Replies: 5
Views: 1,050
Posted By Basil Yousif

I have the manual and went through the program...

I have the manual and went through the program mix to try to do this but every time I went to a time oriented function it only reduced the turning time of the nose wheel I couldn't get it to stop the...
03-01-2022, 06:46 PM
Replies: 5
Views: 1,050
Posted By Basil Yousif

Where in the menu do I set the Rudder as Master...

Where in the menu do I set the Rudder as Master and Nose Wheel as slave. And where in the menu is the delay function.
02-25-2022, 01:11 PM
Replies: 5
Views: 1,050
Posted By Basil Yousif

18MZ - Dual rate on Jet Nosewheel problem

I am setting up the electric Nosewheel for a Turbine Jet on a Futaba 18MZ - 6 year old radio. Nosewheel is on ch9 and retract switch is on DG1 of the 14channel R7014SB receiver.

I used the AFR...
12-29-2021, 02:20 PM
Replies: 1
Views: 775
Posted By Basil Yousif

18MZ - 2015 radio - FASSTEST 18 channel - sbus2

I have the Futaba 18MZ purchased in 2016-2017 - It's the one just under the WC Model. Does it have telemetry and uses Sbus2. I am setting up a Jet with a R7014SB receiver. SHould I go with the...
05-24-2021, 08:21 PM
Replies: 28
Views: 3,622
Posted By Basil Yousif

I guess it's just a matter of the plane being too...

I guess it's just a matter of the plane being too heavy for the wing framing. One guy says he Fiberglass's the wing and has no trouble with breakage on landings. It's very strong. Also if done...
05-23-2021, 07:31 PM
Replies: 28
Views: 3,622
Posted By Basil Yousif

There are some different outfits that build...

There are some different outfits that build popular Airplanes

https://carolinacustomkits.com/shop/ols/products/tf-giant-corsair

These guys make a kit for $469

But there's this Composite P51...
05-19-2021, 03:03 PM
Replies: 28
Views: 3,622
Posted By Basil Yousif

Let me know what you find out. If it's reasonable...

Let me know what you find out. If it's reasonable I'll get in on it.
05-19-2021, 09:31 AM
Replies: 28
Views: 3,622
Posted By Basil Yousif

I think it would cost way too much to send them a...

I think it would cost way too much to send them a wing and have them rebuild it. I would look to getting out of this plane at that point and seeing if I could get a Phoenix Models P51...
05-15-2021, 04:37 PM
Replies: 28
Views: 3,622
Posted By Basil Yousif

Wing Just disintergrated on landing

I faunally got these wings you sold me put together and on the plane. First landing they disintegrated...
01-14-2021, 04:04 PM
Replies: 0
Views: 983
Posted By Basil Yousif

YS 120SR Helicopter engine - Muffler and Application

I just got the YS 120SR Heli engine to put into a older Align 700. The muffler for this thing is very expensive like $250 but one for a YS.90RS is only $100 and it's a Hatori #939 Is there any...
04-30-2020, 12:06 PM
Replies: 1
Views: 1,199
Posted By Basil Yousif

The Event has been rescheduled to September 26th...

The Event has been rescheduled to September 26th 2020.
https://cimg9.ibsrv.net/gimg/www.rcuniverse.com-vbulletin/1275x1650/rotorsoverroseville2020__fa02aa169de737c43187aa431f772c2248f90ab7.jpg
02-14-2020, 01:11 PM
Replies: 1
Views: 1,199
Posted By Basil Yousif

Rotors Over Roseville 2020

Rotors Over Roseville 2020 Model R/C Helicopter Event

Saturday May 16th 2020 starts at 9 :00AM

Location:AMOS Flying Field
4015 E Catlett Rd, Lincoln, CA 95648

On the Corner of E Catlett...
12-01-2019, 03:24 PM
Replies: 28
Views: 3,622
Posted By Basil Yousif

I love to use the Marine Grade Epoxy and...

I love to use the Marine Grade Epoxy and Fiberglass mesh to reinforce the retract area. But can't compensate for incorrectly built wing.
11-29-2019, 08:37 PM
Replies: 28
Views: 3,622
Posted By Basil Yousif

Yep you r right I looked in the wing and there...

Yep you r right I looked in the wing and there grain is running horizontally. Ok this is great info i'll rebuild the wing and install thin plywood Shear webs where I can.
Replies: 2
Views: 1,451
Posted By Basil Yousif

I do have two R7008Sb's but wanted to use them on...

I do have two R7008Sb's but wanted to use them on a Jet with Telemetry. Oh well the jet will have to wait. There is a Used 6014HS for $129. Bummer I have so many 617's sitting around!!
Replies: 2
Views: 1,451
Posted By Basil Yousif

Futaba R617FS Dual Receiver setup

I just got a Top Flight P47 and trying to go Budget on it to get it up in the air so I'm trying to use two Futaba R617FS Receivers to run all the 11 servos.
The problem is when I Bind both of the...
11-27-2019, 10:58 PM
Replies: 28
Views: 3,622
Posted By Basil Yousif

Thanks you really know your building. I think the...

Thanks you really know your building. I think the new wing should be good these were a bad run that probably are all destroyed by now. I'll fix it and get this extra one as a extra.
Is the Sheer web...
11-27-2019, 03:20 PM
Replies: 28
Views: 3,622
Posted By Basil Yousif

https://cimg4.ibsrv.net/gimg/www.rcuniverse.com-vb...

https://cimg4.ibsrv.net/gimg/www.rcuniverse.com-vbulletin/1024x768/sam_6176_2990cc7d582574faae3e1576eb2e5a0a08e26ef2.jpg...
11-26-2019, 04:24 PM
Replies: 28
Views: 3,622
Posted By Basil Yousif

Ill take these wings!!

I'll take these wings can you send a PM
11-18-2019, 04:35 PM
Replies: 28
Views: 3,622
Posted By Basil Yousif

I can fix it but if I could build one from...

I can fix it but if I could build one from scratch It wouldn't fail like this wing.
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.