RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: rk345345
Showing results 1 to 23 of 23
Search took 0.19 seconds.
04-06-2010, 10:46 AM
Replies: 4
Views: 704
Posted By rk345345

RE: 2 speed stuck again

I"ve had mine for 2 weeks, and all it's been is problems. Does not matter where the screw is, it does the same thing.. It shifted I think 1 time then stuck took it apart looked fine put it together...
04-02-2010, 12:24 PM
Replies: 4
Views: 704
Posted By rk345345

2 speed stuck again

2 speed stuck again. and I'm getting really pissed. I know Iknow ,put in a single speed. Then I have to spend more cash on that, when I already paid much more for the s30 two speed instead of the...
03-15-2010, 05:53 PM
Replies: 23
Views: 1,604
Posted By rk345345

RE: low end power

the spring and ball is Inthe two speed clutch? not the main engine clutch? I think thats mabey where I was getting confused.
03-14-2010, 10:50 AM
Replies: 23
Views: 1,604
Posted By rk345345

RE: low end power

yep it was the botton, not shure how it fell out while all put together. I did put the 2 way bering in backwards, oops. The part that was not screwed on was the mechanism to shift into second gear,...
03-13-2010, 06:43 PM
Replies: 23
Views: 1,604
Posted By rk345345

RE: low end power

bet i put the one way in backwards
03-13-2010, 06:33 PM
Replies: 23
Views: 1,604
Posted By rk345345

RE: low end power

great i put i back together and now it does not move at al haha great
03-13-2010, 05:18 PM
Replies: 23
Views: 1,604
Posted By rk345345

RE: low end power

i took the 2 speed out . and the allen screw to hold it two the shaft is not there so it musta been spinning freely and the break rod has part broken off that was laying in trans box any one know the...
03-13-2010, 02:13 PM
Replies: 23
Views: 1,604
Posted By rk345345

RE: low end power

ok lets say it is stuck in second. How do I go about getting it out and keeping it out. (without going to 1 speed) ?
03-13-2010, 10:46 AM
Replies: 23
Views: 1,604
Posted By rk345345

RE: low end power

I'll look into thoes bells. Hopefully the 2 speed is working, or will start working or I'll send the whole thing back to red cat. I've had it out like 3 times, switch does not work , had to replace...
03-12-2010, 11:29 PM
Replies: 23
Views: 1,604
Posted By rk345345

RE: low end power

THE ARM THAT POPS OUT IS METAL CORRECT? AND HITS THE PLASTIC KINDA WEDGE SHAPED DEAL ON THE PLASTIC GEAR?
03-12-2010, 09:25 PM
Replies: 23
Views: 1,604
Posted By rk345345

RE: low end power

stuck in second gear. I have read lots of problems with that. how do i check that I do turn the fly wheel and both spur gears turn should one be free or ?? this is the first two speed I have worked...
03-12-2010, 08:07 PM
Replies: 23
Views: 1,604
Posted By rk345345

RE: low end power

It runs great other than the low end. sometimes it'll bog real bad low end. but the lsn does not seem to do any thingother than make it impossible to start when I turn that.I'll keep trying to tune...
03-12-2010, 03:58 PM
Replies: 23
Views: 1,604
Posted By rk345345

low end power

I have NONE it takes a darn city block to get this thing to wind out. Is there any gearing changes availble on these Tordnado s30 buggy? or am I stuck with what they give me. also I have not heard...
03-11-2010, 11:06 AM
Replies: 7
Views: 5,653
Posted By rk345345

03-10-2010, 09:46 PM
Replies: 7
Views: 5,653
Posted By rk345345

tornado s30 tires

What size rims should I be looking for ? And any buggies that use the same rim that I could look under. A set of nice, on road rubber, on solid rims would be nice. Thanks again.
03-09-2010, 08:00 PM
Replies: 10
Views: 1,011
Posted By rk345345

RE: carb does not return all the way

ok thanks, I think i have at least got it working. I tightened the spring up a bit and if i turn the trim on the transmitter almost all the way to the braking side it will go all the way back. But...
03-09-2010, 05:40 PM
Replies: 10
Views: 1,011
Posted By rk345345

RE: carb does not return all the way

so I've completly loosend the stop collars just to see. I shure hope the servos not going bad , the sterring one did and I have only ran the break in tanks thru it have had it for about 4 days.
any...
03-09-2010, 04:04 PM
Replies: 10
Views: 1,011
Posted By rk345345

RE: carb does not return all the way

I was wondering about a spring. But whats the problem(cause) with(of) it not returning? It should rite?
03-09-2010, 09:41 AM
Replies: 10
Views: 1,011
Posted By rk345345

carb does not return all the way

Just got a tornados30.

no matter how loose I get the idel screw it will not return to alow enuff idel to stop moving, unless I puton brake then it will stay ideld down. the carb does not snap all...
03-03-2010, 10:39 PM
Replies: 9
Views: 1,006
Posted By rk345345

RE: tornado s30 c hub

so now all I need is the wing mount..
03-03-2010, 09:56 PM
Replies: 9
Views: 1,006
Posted By rk345345

RE: tornado s30 c hub

That explains why I can't find them. Sorry for the confusion. I have not actually gotten the car yet,its on its wayups says friday, but I orderd a load of blue garbage already. And really woulda...
03-03-2010, 06:12 PM
Replies: 9
Views: 1,006
Posted By rk345345

RE: tornado s30 c hub

Yeah I looked there. They do not have them. I can get them in purple, but I got probly $500 in blue crap all over it and it will look kinda dumb with one purple part.
03-02-2010, 01:35 PM
Replies: 9
Views: 1,006
Posted By rk345345

tornado s30 c hub

Please tell me theres somewhere I can get aluminum c hubs.

Also aluminum wingmount.

Trying to find them in blue.


Thanks</p>
Showing results 1 to 23 of 23


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.