RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: hennigm4
Showing results 1 to 16 of 16
Search took 0.18 seconds.
Forum: RC Tanks
02-26-2012, 05:13 PM
Replies: 2
Views: 503
Posted By hennigm4

DBU install ?s and problems

I installed a DBU in both a Tiger II and a Panther G. Both units are installed identical. I left the old HL BU in tackt did not cut it out or disconnect it.

So far the issues are as follows:
...
Forum: RC Tanks
02-11-2012, 05:27 PM
Replies: 3
Views: 1,121
Posted By hennigm4

RC Sherman tank 1/16th

Whats the best place to buy a Sherman for RC tank fighting, 1/16th scale?? I see Mato makes one and Tamiya, whats the best route to go??

Thanks,

Mike
Forum: RC Tanks
01-29-2012, 06:14 PM
Replies: 2
Views: 699
Posted By hennigm4

Mato 3:1 brass gearbox

Does anyone know if the brass gearbox bushings can be replace with bearings? My gearshafts cause the entire bushing to rotate in the frame. Bearings would make everything smoother. Has anyone done...
Forum: RC Tanks
01-17-2012, 06:38 PM
Replies: 2
Views: 710
Posted By hennigm4

RE: HL king tiger rear tensioner install help

Think I have it figured out, I used an extra screw I had lying around, Just need to put a flat spot on the axle when I get it adjusted correctly.

Mike
Forum: RC Tanks
01-16-2012, 01:37 PM
Replies: 2
Views: 710
Posted By hennigm4

HL king tiger rear tensioner install help

So while waiting for my new gears to arrive, I decided to install my rear tensioner. The directions are in German, no problem. Fortunantly before I cut the current plastic mounting flange off I...
Forum: RC Tanks
01-15-2012, 01:03 PM
Replies: 3
Views: 674
Posted By hennigm4

HL KT stripped gears

Hello,

So I was out playing in the 23 degree weather today, trying out my newly mounted IR emmitter. Got stuck in a ditch and stripped the metal gears on the right side. Is the brass setup a...
Forum: RC Tanks
01-14-2012, 11:47 AM
Replies: 4
Views: 624
Posted By hennigm4

HL KT IR emmiter location?

I have a HL King tiger that has the IR emmiter located on the turret, it does not go up or down with the gun.

Im guessing this is not too good for IR battleing. Has anyone figured out a fix for...
Forum: RC Tanks
01-10-2012, 07:08 PM
Replies: 3
Views: 651
Posted By hennigm4

? about radio to use with DBCRC2

I have two HL tanks,stock IR. I was looking at the DBCRC2 so that they will be Tamiya compatible and to use the 2.4 radios to avoid frequency issues. My question is, I have a Spektrum DX6i and a DX8,...
Forum: RC Tanks
12-26-2011, 04:32 PM
Replies: 17
Views: 1,822
Posted By hennigm4

RE: Military Channel:Greatest Tank Battles

They have the series on Netfliks if anyone is using the online option.  The battle of Kurst was pretty amazing, over 500 tanks in a 4 mile area.
Forum: RC Tanks
12-22-2011, 06:18 PM
Replies: 1
Views: 638
Posted By hennigm4

Two tanks same freq. What crystals to use?

So I have two Heng long tanks, both on same freq channel 3, what crystals can I get from the local hobby shop that I can switch with one? Obviosly I could order the original HL crystals but I wanted...
Forum: RC Tanks
12-04-2011, 05:16 PM
Replies: 358
Views: 196,935
Posted By hennigm4

RE: RC Tank Clubs

Looking for a club in Loudoun County Virginia. Just purchased the Heng Long tanks.

Thanks,

Mike
Forum: Electric General Discussion
12-17-2010, 05:16 PM
Replies: 5
Views: 802
Posted By hennigm4

RE: looking for a good starter

Parkzone T-28, full sized or the new Parkzone Radien are two good choices. Get help with either so you dont crash them.

Mike
Forum: Electric General Discussion
07-12-2010, 04:34 PM
Replies: 3
Views: 879
Posted By hennigm4

RE: GP Eagle 580 EP motor, esc, battery cooling?

Their is two small panels right aft of the gear, cut those out, so far so good on mine, I used a 13x6.5 prop today with 10 min run times, 3s 3300 battery.
Forum: Electric General Discussion
07-12-2010, 04:29 PM
Replies: 5
Views: 1,221
Posted By hennigm4

RE: Great Planes ElectroStik screeching noise. update!

Timing for sure, I just had this issue with my rimfire .32, default ESC was Low, I set it to Medium and all is good. My ESC is the HobbyKing. Im sure GP can provide you instructions, check their...
Forum: Electric General Discussion
07-04-2010, 05:52 PM
Replies: 12
Views: 3,132
Posted By hennigm4

RE: Help trying to get back into RC planes - Parkzone any good?

Go with the t-28, good all around plane with no bad habits.  you can use dual rates and have a decent performer with 10 min flight times, plus parts are cheap.  This is the plane that got me back...
Forum: Electric General Discussion
07-04-2010, 05:46 PM
Replies: 0
Views: 408
Posted By hennigm4

Eagle Cap 580 XLS 50"

Hello to all, new to the forum. Have a question for anyone that has the matt chapman eagle 580. What prop do you use with the rimfire .32?? I have tried the 13x8, 12x6 with not a whole lot of...
Showing results 1 to 16 of 16


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.