RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: cmdiduca
Showing results 1 to 12 of 12
Search took 0.62 seconds.
Forum: RC Warbirds and Warplanes
06-28-2015, 06:58 PM
Replies: 4,698
Views: 832,915
Posted By cmdiduca

My plane is on the way! I am needing suggestions...

My plane is on the way! I am needing suggestions on engine size. I would like to put an 85cc on in her. Anyone have this size motor in theirs? If it seems like that is not going to work out ,I was...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
04-08-2015, 02:30 PM
Replies: 1
Views: 548
Posted By cmdiduca

18 mz wav files

I'm sure this has been covered before but here goes. I am looking to add voice prompts to all of my switch commands. Where can I find suitable files for download?
Forum: ARF or RTF
03-13-2015, 05:27 PM
Replies: 763
Views: 187,348
Posted By cmdiduca

Wat is a good General flying weight for this...

Wat is a good General flying weight for this plane?
Forum: ARF or RTF
03-13-2015, 05:26 PM
Replies: 763
Views: 187,348
Posted By cmdiduca

Wat is a good General flying weight for this...

Wat is a good General flying weight for this plane?
Forum: ARF or RTF
03-13-2015, 07:21 AM
Replies: 763
Views: 187,348
Posted By cmdiduca

I have not built my plane yet as I am just...

I have not built my plane yet as I am just getting out of the hospital for a hip replacement. I am taking a few day off from the hobby until I can get back down to th3 shop. I may use a separate...
Forum: ARF or RTF
03-13-2015, 06:53 AM
Replies: 763
Views: 187,348
Posted By cmdiduca

Looking for an aftermarket tail wheel setup! Any...

Looking for an aftermarket tail wheel setup! Any ideas?
Forum: ARF or RTF
03-03-2015, 01:46 PM
Replies: 763
Views: 187,348
Posted By cmdiduca

From what I have been reading here. Guys have...

From what I have been reading here. Guys have been using dle 55 with no weight or very little weight added as ballast. Total weight of that setup is somewhere around 3.5 lbs. you may need to add a...
Forum: ARF or RTF
03-02-2015, 05:34 PM
Replies: 763
Views: 187,348
Posted By cmdiduca

So I am going to be building my first stik. I...

So I am going to be building my first stik. I must say I have enjoyed reading through all of the material in this thread. I am going to use a dle 40 cc twin and I am curious if you guys are using the...
Forum: Giant Scale Aircraft - General
02-09-2014, 02:15 PM
Replies: 1,699
Views: 604,586
Posted By cmdiduca

Dle 55 makes no specific mention of soft mounts...

Dle 55 makes no specific mention of soft mounts either way. It shows only the hard mounting in the manual.
Chris
Forum: Giant Scale Aircraft - General
02-09-2014, 07:13 AM
Replies: 1,699
Views: 604,586
Posted By cmdiduca

I appreciate the responses! I still have some...

I appreciate the responses! I still have some time before I mount the engine to decide. Have any of you fitted the inner doors to your plane. I have seen the pictures of the aerotech doors. Shame...
Forum: Giant Scale Aircraft - General
02-08-2014, 10:19 AM
Replies: 1,699
Views: 604,586
Posted By cmdiduca

Very good thanks for the quick reply!!!!

Very good
thanks for the quick reply!!!!
Forum: Giant Scale Aircraft - General
02-08-2014, 09:46 AM
Replies: 1,699
Views: 604,586
Posted By cmdiduca

I am just beginning my giant and wanted to find...

I am just beginning my giant and wanted to find out if it is needed to isolate the engine with rubber mounts. I am going to use a dle 55. I can't seem to get a good answer on this.
Showing results 1 to 12 of 12


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.