RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: reut1
Showing results 1 to 16 of 16
Search took 0.16 seconds.
04-23-2012, 11:34 AM
Replies: 3,640
Views: 641,068
Posted By reut1

RE: Official HPI Savage Flux XS thread...

definitely kind of rediculous. sent it out feb 12th.

i actually shipped my bikes brake out for service on april 10th from CT to TX, they got it on the 13th and it was repaired and got back to me...
04-23-2012, 10:58 AM
Replies: 3,640
Views: 641,068
Posted By reut1

RE: Official HPI Savage Flux XS thread...

i just called HPI and after a solid 2 months, my ESC is on the way to me. finally! haha. if this thing fries again then im replacing it with a mamba
03-26-2012, 09:59 AM
Replies: 3,640
Views: 641,068
Posted By reut1

RE: Official HPI Savage Flux XS thread...

i sent in my esc and motor and they got it on about February 15th. just called again today to see the status and they shipped back my motor since its in good condition but they are on backorder with...
02-11-2012, 04:19 PM
Replies: 3,640
Views: 641,068
Posted By reut1

RE: Official HPI Savage Flux XS thread...

so upon further investigation, the leads going into the esc from the motor are starting to melt a little bit. heat shrink on the leads are gone and the case of the esc is starting to melt. so im prob...
02-08-2012, 05:12 PM
Replies: 3,640
Views: 641,068
Posted By reut1

RE: Official HPI Savage Flux XS thread...

i did go and call them today and they told me to find out which is bad, motor or esc. so im doing that at the lhs this weekend and then ill be sending back whichever is defective.
02-07-2012, 04:27 PM
Replies: 3,640
Views: 641,068
Posted By reut1

RE: Official HPI Savage Flux XS thread...

some of my antenna is missing from the truck flipping and snapping off the tube. I know the wire doesn't go all the way up the tube but some of the wire at the bottom is shredded. I'll get pics...
02-03-2012, 06:20 PM
Replies: 3,640
Views: 641,068
Posted By reut1

RE: Official HPI Savage Flux XS thread...

well i kinda figured that it was electrical because of that issue, but the clicking i was hearing definitely would be more mechanical. I opened up the tranny tonight and it all looked fine, even...
02-03-2012, 02:43 PM
Replies: 3,640
Views: 641,068
Posted By reut1

RE: Official HPI Savage Flux XS thread...

been having some issues with the tranny last two runs. lots of crunching and clicking when I try to take off with it. and just now sometimes I will hit the gas and nothing will happen. i have to go...
01-21-2012, 10:06 AM
Replies: 3,640
Views: 641,068
Posted By reut1

RE: Official HPI Savage Flux XS thread...

well i got the motor out and reset the pinion. ran it for another 5 min and it came loose again. putting loctite on the grub screw this time and really going to crank down. mesh actually does look...
01-20-2012, 04:51 PM
Replies: 3,640
Views: 641,068
Posted By reut1

RE: Official HPI Savage Flux XS thread...

okay well I ran the truck for like 10 min because I figured that ggrinding I heard was something to be broken in and now I got no power. the motor seems like its spinning but either the spur is...
01-20-2012, 07:20 AM
Replies: 3,640
Views: 641,068
Posted By reut1

RE: Official HPI Savage Flux XS thread...

okay so i got my savage last night and when i just roll it around on the ground it seems like something is almost grinding/binding up in the drivetrain. each differential rolls smoothly when the...
01-13-2012, 04:07 AM
Replies: 3,640
Views: 641,068
Posted By reut1

RE: Official HPI Savage Flux XS thread...

ordered my XS last night! gonna tighten everything up once it comes in so hopefully the spacer wont melt on me immediately. if it does ill figure out some solution for it :D
01-10-2012, 02:27 PM
Replies: 3,640
Views: 641,068
Posted By reut1

RE: Official HPI Savage Flux XS thread...

i know i saw this a while back in the thread but I dont want to re-read all the pages for the answer. Im very tempted to get back into RC with this truck and i cant remember if ti was recommended...
10-13-2010, 02:50 PM
Replies: 4
Views: 564
Posted By reut1

RE: possibly buying a new engine

what is everyones favorite fuel? im placing an order through tower and could just throw that into my cart
10-13-2010, 07:36 AM
Replies: 4
Views: 564
Posted By reut1

possibly buying a new engine

so ive been out of the hobby for a few years but i am just getting back into it somewhat. ive got a nitro rustler with an OS .15 CVX which for whatever reason i could never get to run right. thought...
10-10-2010, 12:30 PM
Replies: 1,680
Views: 196,963
Posted By reut1

RE: Official NITRO RUSTLER thread!!

So after years and years of abandoning the hobby im getting back into it slowly after seeing a new friends heli. I sold all my other cars back in 05 (mini t and micro rs4, huge regret selling those!)...
Showing results 1 to 16 of 16


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.