RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: GotNoRice
Showing results 1 to 25 of 62
Search took 0.24 seconds.
Replies: 1
Views: 5,857
Posted By GotNoRice

Seems it was the wire from the ESC to the RX...

Seems it was the wire from the ESC to the RX after all. It looked fine but I tested it using a meter and it was bad. Upon closer inspection, seems that it can flex a lot near the esc and the metal...
Replies: 1
Views: 5,857
Posted By GotNoRice

Mamba Monster X - 3 red beeps, won't arm.

I just put a Mamba Monster X + Castle 2200kv 1515 in my Slash 4x4 MT. Unfortunately all it does after it detects the battery is give me 3 red flashes/beeps (two short, one long), repeating every few...
Replies: 2
Views: 623
Posted By GotNoRice

Trenchers are larger for sure. I am assuming...

Trenchers are larger for sure. I am assuming that you are running on 2s. There should not be any issues with the ESC. I would keep an eye on motor temps and use that as the basis for your...
06-04-2018, 08:10 PM
Replies: 2
Views: 8,887
Posted By GotNoRice

Slash 4x4 MT ESC / Motor Upgrade

My RC is a Stampede 4x4 which has been lengthened using a Slash 4x4 HCG chassis and uses an E-Maxx body. I am running a Mamba Max Pro with a 4-pole Castle 1415 2400kv (older non-sensored version),...
10-22-2017, 05:34 PM
Replies: 2
Views: 1,129
Posted By GotNoRice

LiPo damage a non-LiPo ESC?

From what I understood, the main issue with an ESC being LiPo compatible is it having an LVC. I thought that was just to protect the battery, and not really a big deal if you are able to use a cheap...
05-10-2015, 06:04 PM
Replies: 4
Views: 1,162
Posted By GotNoRice

The packs are 3000mah. Both chargers say "Only...

The packs are 3000mah. Both chargers say "Only 7-Cell NiMH battery packs should be used with this charger". I'm not sure if it is a load voltage or not, it's just what it says on the label.
05-10-2015, 03:22 PM
Replies: 4
Views: 1,162
Posted By GotNoRice

NIMH chargers - more voltage or more amps better?

I was going to loan one of my vehicles to a friend. I don't feel that he is ready to deal with LiPo yet and he doesn't have a charger for that, so I was going to give him a Traxxas 7-Cell NIMH pack...
05-18-2011, 08:39 AM
Replies: 2
Views: 525
Posted By GotNoRice

RE: batterie life

<![if gte mso 9]><xml><w:worddocument><w:view></w:view><w:browserlevel></w:browserlevel></w:worddocument></xml><![endif]><![if gte mso 9]><xml><w:latentstyles latentstylecount="156"...
Replies: 5
Views: 559
Posted By GotNoRice

RE: slash4x4platinum verses stampede 4x4

Most people who are into racing probably wouldn't be going for a monster truck in the first place. The OP didn't mention anything about racing.

The only thing you get with a Slash 4x4 vs a...
05-08-2011, 09:27 PM
Replies: 7
Views: 10,234
Posted By GotNoRice

RE: Thunder AC6 Charger Question: Connection Break

It doesn't look like you have the main positive and negative wires of the battery connected to the charger.

You were trying to charge just using the balance connector?
Replies: 24
Views: 1,536
Posted By GotNoRice

RE: Old dog, New Tricks...

I'd personally use it as an excuse to go brushless.  It really is night and day, and there is less maintenance involved with a brushless system.

You can get really awesome combos, like the Castle...
04-30-2011, 08:11 AM
Replies: 9
Views: 1,318
Posted By GotNoRice

RE: Need LiPO battery advice please

Generally a charger, even in balance mode, will still charge at pack voltage over the main wires, and use the balance wires only when it needs to balance the pack. Many chargers will charge a pack at...
04-03-2011, 07:47 PM
Replies: 38
Views: 14,051
Posted By GotNoRice

RE: Expensive US made vs Chinese Batteries

By "USA made" do you mean actually made here?

More likely, "USA made" means they use cells that are made in China and then assemble them into packs here in the US.
04-03-2011, 12:04 PM
Replies: 2
Views: 463
Posted By GotNoRice

RE: One cell cuts out?

Not sure really, it didn't come with any documentation (cheap, on ebay, from china). But the solid red LED is different than the typical low-voltage warning where they all blink red.
04-01-2011, 11:31 AM
Replies: 2
Views: 463
Posted By GotNoRice

One cell cuts out?

I was running my Stampede 4x4 (upgraded with a Mamba Max Pro and Castle 2400kv) using a Turnigy 3s 25-35C burst pack. I had already run it for a while, i'd guess I was maybe 2/3rds the way through...
Replies: 15
Views: 1,133
Posted By GotNoRice

RE: Somebody please help me understand something

Not really... All you have to do is drop in the high-speed pinion (which is included) and a 3s LiPo. The high-speed pinion is pretty tough on the motor but during actual high-speed runs it's not...
Replies: 12
Views: 1,903
Posted By GotNoRice

RE: Can't decide on basher purchase (E-Revo BE, Savage Flux...)

Why not a Stampede 4x4?

I know you said you already have a 2wd Stampede but really the two trucks have little in common.
Replies: 5
Views: 1,383
Posted By GotNoRice

RE: MMP/2400 Combo, what are safe temps?

Well there is a spot where you can make contact with the actual metal fins of the heatsink and that is where I was touching.

I'm geared 17/54 currently. I was using 11/54 with my velineon and used...
03-23-2011, 09:07 AM
Replies: 3
Views: 1,763
Posted By GotNoRice

RE: li po battery with vintage ESC

I don't see how the Lipo could have damaged the ESC.  Although keep in mind that a fully charged 2s will be around 8.4v even though people commonly refer to the packs as 7.4v packs.  8.4v still...
Replies: 5
Views: 1,383
Posted By GotNoRice

MMP/2400 Combo, what are safe temps?

I recently swapped out the stock velineon system in my Stampede 4x4 for a Mamba Max Pro / Castle 2400kv combo. So far, even on 3s during hard bashing the motor barely warms up. I doubt it's ever got...
03-16-2011, 11:40 PM
Replies: 1
Views: 480
Posted By GotNoRice

Series using bullet plugs (no adapter)

I just got the expanded battery tray for my Stampede 4x4 and was pleased to find out that it is tall enough to let me stack two of my 2s Lipos on top of each other. Both my ESC and motor (MMP/2400kv)...
Replies: 0
Views: 915
Posted By GotNoRice

Would using an Associated SC450-BL ESC with a Velineon Motor fry it?

I put the XP SC450-BL Brushless Sensorless speed control from my B4.1 buggy in my friend's slash because he didn't have a speed control at the time. It worked fine for a while but then it stopped...
Replies: 3
Views: 462
Posted By GotNoRice

RE: optional pinion ?

It's all about temperatures.

If you want to be careful, it's simple. Just stop and check your motor often. If it is really hot then STOP and take a break. Make sure it's not cooking itself to...
Replies: 8
Views: 1,065
Posted By GotNoRice

RE: On road buggie wheeles

What I did was put a pair of Pro-Line Road Hawg II tires on the rear of my B4.1.  I actually used truck rears instead of buggy rears though, because the tires are larger and give more grip.

I kept...
Forum: RC Car Videos
03-07-2011, 03:07 PM
Replies: 0
Views: 455
Posted By GotNoRice

Stampede 4x4 hits cameraman

I was doing a few short runs with the 3s LiPo. Didn't quite hit the ramp the right way...

http://www.youtube.com/watch?v=Q9JADomkaMo
Showing results 1 to 25 of 62
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.