RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: champion221elite
Showing results 1 to 25 of 45
Search took 0.13 seconds.
Forum: Speed - Electric
11-20-2013, 07:27 AM
Replies: 1
Views: 464
Posted By champion221elite

Is the servo plugged into the correct rx port?

Is the servo plugged into the correct rx port?
Forum: Speed - Electric
11-20-2013, 07:23 AM
Replies: 3
Views: 5,297
Posted By champion221elite

I have the same motor/ esc combo on my 29" Sprint...

I have the same motor/ esc combo on my 29" Sprint Cat on 6s. I programmed the esc for 6s and set the timing to 11.25 degrees.
Forum: Speed - RC Gas Boats
07-08-2013, 10:52 AM
Replies: 8
Views: 4,452
Posted By champion221elite

RE: Mountain Hobbies boats... GTG?

Thanks for the info guys. I will avoid Mountain Hobbies.
Forum: Speed - Electric
07-04-2013, 12:25 PM
Replies: 0
Views: 1,626
Posted By champion221elite

6s prop for Blackjack 29?

To start out, I bought the Blackjack 29 as a second boat/ and for a bit of a tinkering project. Specs say the 1800 kv motor/ 80 amp esc are good to 6s. I have my reservations about running 6s on...
Forum: Speed - RC Gas Boats
07-02-2013, 08:54 AM
Replies: 8
Views: 4,452
Posted By champion221elite

Mountain Hobbies boats... GTG?

I have plans to eventually build my own gas boat from the hull up, but my area lacks any lhs or racer support. While searching for an RTR gas boat, Ive come across the usual suspects such as Pro...
Forum: Speed - Electric
05-26-2013, 04:22 PM
Replies: 4
Views: 2,964
Posted By champion221elite

RE: HK Genesis 6s Setup

I wouldnt be pushing 6s through a Turnigy 180 ESC, especially when running on the internal BEC. There was just a thread about this subject and the consensus was to run 1 cell less than the...
Forum: Speed - Electric
05-11-2013, 02:24 PM
Replies: 17
Views: 7,548
Posted By champion221elite

RE: 180a turnigy boat esc

I have a Hobby Wing Seaking 180 A controller that goes into LVC mode regardless of me running 4s or 6s. I have programmed the LVC at 3.4 and even 3.0 volts but it still cuts in. I had to...
Forum: Batteries & Chargers
04-24-2013, 10:59 PM
Replies: 3
Views: 1,291
Posted By champion221elite

RE: Gens Ace balance connector style

Thanks for the reply! I was hoping they were XH style.
Forum: Batteries & Chargers
04-24-2013, 09:24 PM
Replies: 3
Views: 1,291
Posted By champion221elite

Gens Ace balance connector style

Im looking into getting some Gens Ace lipos, but cant find any info on which style of balance connector they use. All of my current lipos and balance boards are XH and I would like to keep...
Forum: Speed - Electric
04-23-2013, 12:10 PM
Replies: 17
Views: 6,261
Posted By champion221elite

RE: Chris Fine/ Fine Design Marine

If you're implying that Chris put me up to this, Im going to stop you right there. My OP was 100% un-solicited and is a true reflection of my dealings with Chris. That is all.
Forum: Speed - Electric
04-17-2013, 12:36 PM
Replies: 17
Views: 6,261
Posted By champion221elite

RE: Chris Fine/ Fine Design Marine

I cannot comment about the dealings of another person. All I can say is that my experience was positive, and was handled quickly.
Forum: Speed - Electric
04-07-2013, 12:18 PM
Replies: 17
Views: 6,261
Posted By champion221elite

RE: Chris Fine/ Fine Design Marine

I guess its true... bad news travels much faster than good news.
Forum: Speed - Electric
04-05-2013, 10:42 AM
Replies: 17
Views: 6,261
Posted By champion221elite

Chris Fine/ Fine Design Marine

First off, let me say that I am in no way affiliated with, or in a position to profit from any of Chris Fines activities or sales. I am merely a customer who wishes to share details of a recent...
Forum: RC Boats General Discussion
03-28-2013, 12:08 PM
Replies: 10
Views: 1,084
Posted By champion221elite

RE: Nitro harmful

The home owners association is shutting you down because of noise. Their ''environmental'' concerns are simply an excuse to discourage you from running your boats.
Forum: RC Boats General Discussion
03-27-2013, 06:05 PM
Replies: 0
Views: 1,811
Posted By champion221elite

HOR Racing/ 41" carbon/ kevlar Zonda cat

I've been kicking around the idea of getting the ARTR41" carbon/ kevlar Zonda cat hull from HOR Racing. Does anyone have experience with HOR Racing, and more specifically the 41" Zonda cat hull?
...
Forum: Speed - Electric
03-18-2013, 03:44 PM
Replies: 3
Views: 964
Posted By champion221elite

RE: HK Genesis build

Thanks for the info John! I was hoping to run the Genesis as a single motor/ drive, but your observations do make perfect sense.
Forum: Speed - Electric
03-18-2013, 01:16 PM
Replies: 3
Views: 964
Posted By champion221elite

RE: HK Genesis build

Since this thread hasnt received any suggestions yet, I will post some components that im thinking about for critique.MOTOR: Likely a Leopard. Unsure of size, but a KV rating of 1100 to 1200 will...
Forum: Speed - Electric
03-18-2013, 04:54 AM
Replies: 3
Views: 964
Posted By champion221elite

HK Genesis build

I would like to build up a decently fast brushless cat hull and came across the Genesis hull at hobby king. Factory specs show it comes with a 36x74 inrunner motor rated at 2075 kv and 100 amps. ...
Forum: Batteries & Chargers
03-10-2013, 12:39 PM
Replies: 12
Views: 2,861
Posted By champion221elite

RE: hobbyking shipping

I ordered two of HK's Nanotech 3S 5000 mah 45c packs last week. I understood these batteries were backordered at the US warehouse, but placed the order anyways. Still no word on my order being...
Forum: Speed - Electric
03-04-2013, 06:07 AM
Replies: 21
Views: 2,659
Posted By champion221elite

RE: 41

Sweet boat! What kind of speed is it capable of at say 80% and 100% throttle?
Forum: Speed - Electric
02-16-2013, 05:32 AM
Replies: 40
Views: 8,502
Posted By champion221elite

RE: RE:

Im interested to hear how this project worked out as i would like to do a similar boat in the future as my modeling experience grows.
Forum: E-Flite Helicopters
02-09-2013, 01:56 AM
Replies: 2
Views: 765
Posted By champion221elite

RE: My Blade 120sr Q?

Make sure the heli is on a flat surface and slide the battery into the holder. Power on the transmitter and wait a few seconds before connecting the flight battery to the heli. Make sure the...
Forum: Speed - Electric
02-05-2013, 11:42 AM
Replies: 0
Views: 605
Posted By champion221elite

Refitting older R/C boat from the mid 1990's

My brother has an older cat hull from the mid 1990's that he's thinking about updating. Here's the specs that I know.

Hull: ABS plastic, about 24" to 26" long, approx 10" wide and weighs about...
Forum: Speed - Electric
01-15-2013, 03:20 PM
Replies: 3
Views: 699
Posted By champion221elite

RE: Returning boater needs help

Its the 29" model. Ive been told its currently propped for 4s.
<br type="_moz" />
Forum: Speed - Electric
01-15-2013, 08:12 AM
Replies: 3
Views: 699
Posted By champion221elite

RE: Returning boater needs help

Also wondering if it would be better to run twin 2s / 3s in series, or twin 4s/ 6s in parallel?<br type="_moz" />
Showing results 1 to 25 of 45
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.