RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: avyaboy
Showing results 1 to 16 of 16
Search took 0.66 seconds.
Forum: RC Helicopter General Discussions
10-05-2009, 03:17 PM
Replies: 3
Views: 1,940
Posted By avyaboy

RE: OS Max 32 SX H problems

You might have already done this but try the following (sorry if some of them it may be too obvious but who knows),

- See if fuel is actually reaching the carburator and keeps flowing
- If you...
Forum: RC Helicopter General Discussions
10-05-2009, 12:22 PM
Replies: 1
Views: 860
Posted By avyaboy

O.S. 91 SZ-H always rich (even with high speed needle closed all the way)

Hello, I have a strange problem with my O.S. 91 SZ-H installed in a Trex 700. It's always too rich, I can see a lot of oil comming out of the muffler, i've even closed the hi-speed needle all the way...
Forum: RC Helicopter General Discussions
08-05-2009, 03:46 PM
Replies: 3
Views: 534
Posted By avyaboy

RE: Removing Trex 700 cluch

Thanks for the help, I think getting the toll will be the right way to do it then,
Forum: RC Helicopter General Discussions
08-03-2009, 02:24 PM
Replies: 3
Views: 534
Posted By avyaboy

Removing Trex 700 cluch

Hi, I'm tryig to remove my Trex 700's clutch shoe from engine and it´s just stuck, I think I might buy an extraction tool, but I think there should be an easierand cheaper way to do it. Any help...
Forum: ARF or RTF
12-26-2007, 11:18 AM
Replies: 12
Views: 1,490
Posted By avyaboy

RE: Pitts 1/3 hard to turn right

I'm using a 16x10 prop, but I'm planning to test a 17-10 and a 16-12 to see how it behaves, I have to play with different prop sizes since I fly at 7500 feet ASL so engine performance is decreased,...
Forum: ARF or RTF
12-25-2007, 11:48 PM
Replies: 12
Views: 1,490
Posted By avyaboy

Pitts 1/3 hard to turn right

I have a Great Planes Pitts 1/3 scale ARF with an O.S. 160 FX engine that have been flying for three times now, however it's very hard or almost impossible to make it turn right with aileron input...
Forum: Kyosho Helicopters
05-23-2005, 04:30 PM
Replies: 3
Views: 790
Posted By avyaboy

RE: Caliber 30 "jumps" and changes RPM

hey!... thenks you may be right

i changed the clutch bell for a metal one, instlles the clutch liner, but it was VERY tight, so I had to take off much of the liner maerial in order to fit in the...
Forum: Kyosho Helicopters
05-23-2005, 03:40 PM
Replies: 3
Views: 790
Posted By avyaboy

Caliber 30 "jumps" and changes RPM

HI,

I OWN A CALBER 30, BUT FOR A WHILE IT'S DOING SOMETHING STRANGE.

WHEN IT'S RUNNING WELL LET'S SAY AT SOME 1700-1800 RPM'S (I'VE MEASURED) AND THAT'S EXACTLY WHEN I CAN FLY IT AROUND...
Forum: Kyosho Helicopters
09-20-2004, 11:36 AM
Replies: 4
Views: 1,471
Posted By avyaboy

RE: Nexus 30 & Futaba 9CH radio Help

I don't have a lot of experience, but I had a Nexus and it sometimes did the same thing.

It seemed that lowering the top end pitch would make it better, you can try to make the curve more like...
Forum: Kyosho Helicopters
09-20-2004, 11:28 AM
Replies: 3
Views: 932
Posted By avyaboy

High Frequency vibration Caliber 30

Hi,

I have just bought my second caliber 30 after a huge crash that I decided to replace the whole heli and use the other for parts.

However this heli has one particular problam that I...
Forum: RC Helicopter General Discussions
07-16-2004, 04:44 PM
Replies: 6
Views: 500
Posted By avyaboy

RE: WHAT PIPE FOR THE CALIBER 30

IS IT THE SAME PIPE IN ALL PICTURES?


WHERE CA I BUY THIS PIPE FROM?

I SAW A PIPE IN HELI-PROZ DESIGNED BY CURTIS YOUNGBLOOD IS THAT IT?
Forum: RC Helicopter General Discussions
07-16-2004, 04:11 PM
Replies: 6
Views: 500
Posted By avyaboy

WHAT PIPE FOR THE CALIBER 30

HI,

I OWN A CALIBER 30, AND I WANT SOME EXTRA POWER, I LIVE IN MEXICO CITY AT OVER 7000 FEET ABOVE SEA LEVEL, SO THE ENGINE IT'S NOT QUITE POWERFUL.

ANYBODYU KNOWS A GOOD PIPE THAT WOULD...
Forum: Kyosho Helicopters
07-11-2003, 10:27 PM
Replies: 4
Views: 756
Posted By avyaboy

Caliber30 loss of power

I replaced the blades and tightened the muffler wich was alittle loose and that seemed to solve the problem.

Weird
Forum: Kyosho Helicopters
06-03-2003, 03:23 PM
Replies: 8
Views: 919
Posted By avyaboy

rudder questions on the caliber

Do you have REVO mix on?...i had a similar on my caliber and I turned REVO mixing off. But I still have rudder problems, because the chopper always have a tendency. I think the Caliber 30 is very...
Forum: Kyosho Helicopters
06-02-2003, 01:28 PM
Replies: 4
Views: 756
Posted By avyaboy

Caliber30 loss of power

I think the blades are not losing speed, the RPM on the Blades seem not decreasing, but it's clearly heard that the engine is providing less power after the helicopter had a 3-4 seconds of hover.
...
Forum: Kyosho Helicopters
06-01-2003, 08:08 PM
Replies: 4
Views: 756
Posted By avyaboy

Caliber30 loss of power

Hi,

I have a Caliber 30 with an OS 32 SX as my second heli, and everything was doing perfectly.

Last Sunday I had a crash that seemed hard, but only a main blade was slightly cracked and one...
Showing results 1 to 16 of 16


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.