RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: bluecollar
Showing results 1 to 14 of 14
Search took 0.12 seconds.
Forum: Speed - Electric
04-07-2012, 06:07 AM
Replies: 3
Views: 533
Posted By bluecollar

RE: ? on LIPO for my exceed shark

i dont have a volt meter but its stock motor and prop
Forum: Speed - Electric
04-06-2012, 07:10 PM
Replies: 3
Views: 533
Posted By bluecollar

? on LIPO for my exceed shark

Can I run a 3s 65c 4400mah lipo on my exceed shark with a 75a esc? if not please tell me whats the max ican run
Forum: Speed - RC Gas Boats
02-20-2012, 05:43 PM
Replies: 7
Views: 1,277
Posted By bluecollar

RE: Central RC new 53

ok thanks
Forum: Speed - RC Gas Boats
02-20-2012, 04:20 PM
Replies: 7
Views: 1,277
Posted By bluecollar

RE: Central RC new 53

hey central rc do u set the boat with hardware also or just provide the boat?
Forum: Speed - RC Gas Boats
02-19-2012, 02:47 PM
Replies: 7
Views: 1,277
Posted By bluecollar

RE: Central RC new 53

what gas motor would u reccomend to push this boat 70+mph
Forum: Speed - RC Gas Boats
01-30-2012, 09:22 AM
Replies: 6
Views: 786
Posted By bluecollar

RE: need help for sikk please!

ok ill check but i neverf even pulled carb off to change head gasket
Forum: Speed - RC Gas Boats
01-30-2012, 06:55 AM
Replies: 6
Views: 786
Posted By bluecollar

RE: need help for sikk please!

ok  i will look compression does seem good but it does not seem like its gettin fuel in the engine but i never even touched the carb
Forum: Speed - RC Gas Boats
01-29-2012, 02:31 PM
Replies: 6
Views: 786
Posted By bluecollar

need help for sikk please!

just replaced head gasket on sikk motor and had a real hard time getting piston back in but did get it. now motor will not start or even try to start. i even tried starting fluid and still nothing. i...
Forum: Speed - RC Gas Boats
01-10-2012, 07:36 AM
Replies: 14
Views: 995
Posted By bluecollar

RE: need help for my rio 51

thx to blizzar05 should have some  orings soon. just need to figure out how they go on
Forum: Speed - RC Gas Boats
01-09-2012, 04:50 PM
Replies: 14
Views: 995
Posted By bluecollar

RE: need help for my rio 51

no bailer but found leak hooked up hose and water just pouring out exhaust o rings were do i get ones for a sikk motor and r they easy to replace?
Forum: Speed - RC Gas Boats
01-09-2012, 11:36 AM
Replies: 14
Views: 995
Posted By bluecollar

RE: need help for my rio 51

ok thanks will try the vacum plug and see if that helps
<br type="_moz" />
Forum: Speed - RC Gas Boats
01-09-2012, 05:39 AM
Replies: 14
Views: 995
Posted By bluecollar

RE: need help for my rio 51

While tub it drips out the stuffing tube quite a bit and then while running i only get about 5-7 min before engine dies because of the water it sucked in. where the stuffing tube meets shaft i no...
Forum: Speed - RC Gas Boats
01-08-2012, 07:02 PM
Replies: 14
Views: 995
Posted By bluecollar

RE: need help for my rio 51

yes the plug hole has been sealed how do i pressure check just blow air through it? when i set in the water not running,water does come through stuffing tube but figured that was normal i did greese...
Forum: Speed - RC Gas Boats
01-08-2012, 05:45 PM
Replies: 14
Views: 995
Posted By bluecollar

need help for my rio 51

need help with my new rio does anyone work on these boats near orlando i am getting a ton water in it and cant pin point where. i just bought the boat used and tired of working on it already.
Showing results 1 to 14 of 14


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.