RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Search
Today's Posts
Mark Forums Read
Vendor Directory
Notices
Search: Posts Made By: tragzy
Showing results 1 to 20 of 20
Search took 0.11 seconds.
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
06-16-2012, 09:59 PM
Replies: 10
Views: 4,818
Posted By tragzy

HobbyWing XERUN low voltage cut-off

hello.

I am about to run my losi 8ight brushless conversion for the first time. It has a leapord 2200kv & Hobbywing XERUN 150a ESC.

This is my first Electric car, so can anyone tell me how i...
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
05-21-2012, 02:59 AM
Replies: 5
Views: 1,040
Posted By tragzy

RE: Low Voltage Cutoff

cheers ****s. @Cum: dont realy understand what you mean with the buzzers. anyone else got any info on them.<div>
</div><div>Thanks again guys for your help</div>
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
05-20-2012, 04:28 AM
Replies: 5
Views: 1,040
Posted By tragzy

Low Voltage Cutoff

Hello.

i am new to electric RC. I need to find out about low voltage cutoff.

Ok. If i set my ESC LVC to lets say; 3.2v per cell. By the end of my run when each cell reaches 3.2v, What will...
Forum: Redcat Racing Support
03-28-2012, 02:54 AM
Replies: 3
Views: 776
Posted By tragzy

RE: engine cuts out at half a tank

Is the engine HOT when it cuts out&gt;Too lean then......
Forum: Car Nitro & Gas Engines
03-26-2012, 03:05 AM
Replies: 13
Views: 2,488
Posted By tragzy

RE: SH .18?

wouldnt waste your money on sh engines (sh=short for ****!!)
Plaig RC sells The team infinity .21 engines for $139 AU. he is out of stock at the moment but check in the next two weeks or so and you...
Forum: Car Nitro & Gas Engines
03-26-2012, 02:55 AM
Replies: 5
Views: 964
Posted By tragzy

RE: putting different carbs on engines..?

BUMP
/ \
|_|
Forum: RC Truggy
03-25-2012, 11:42 PM
Replies: 88
Views: 79,837
Posted By tragzy

RE: Your TRUGGY and your setup

+++++1 on that
Forum: Car Nitro & Gas Engines
03-25-2012, 11:38 PM
Replies: 5
Views: 964
Posted By tragzy

putting different carbs on engines..?

Hello.
My team infinity 528's screw that holds the carby on has stripped. i dont realy want to drill a new hole.
i have put a hyper 21 carby on it. it fits well withouth a screw, i just heated the...
Forum: RC Car General Discussions
03-17-2012, 02:31 AM
Replies: 3
Views: 2,294
Posted By tragzy

HobbyKing Dremel/rotary Tool

hey.
was wondering if anyone here has had any experience with the HobbyKing Dremel/Tool from hobbyking for $15.
http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=10489
...
Forum: Redcat Racing Support
03-14-2012, 11:54 PM
Replies: 4
Views: 2,842
Posted By tragzy

RE: Redcat monssoon+HSP Sea-Rover PICS!!

bump
Forum: Redcat Racing Support
03-11-2012, 12:27 AM
Replies: 4
Views: 2,842
Posted By tragzy

Redcat monssoon+HSP Sea-Rover PICS!!

hey.
Post your pics of the wonderful Monsoon/sea-rover truggy!!
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
03-10-2012, 09:40 PM
Replies: 6
Views: 1,149
Posted By tragzy

RE: Electric cars explained?

thanks Kahnen and The Shark. If i get one it would probs be this &gt;...
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
03-10-2012, 09:02 PM
Replies: 6
Views: 1,149
Posted By tragzy

RE: Electric cars explained?

cheers man. that answer most of my questions
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
03-10-2012, 07:00 PM
Replies: 6
Views: 1,149
Posted By tragzy

Electric cars explained?

hi.
i have been into nitro cars for the last ten years. I am thinking going a bit different and getting an electric car.
coz ive been into nitro cars and not into electric. i do not have one clue...
Forum: RC Truggy
03-02-2012, 04:29 PM
Replies: 10
Views: 1,336
Posted By tragzy

RE: JPX .28 or Picco .28

very nice, how much?
Forum: RC Truggy
03-02-2012, 02:52 AM
Replies: 10
Views: 1,336
Posted By tragzy

RE: JPX .28 or Picco .28

shall i just use a file to gring off edge of chassis hole
Forum: RC Truggy
02-29-2012, 11:56 PM
Replies: 10
Views: 1,336
Posted By tragzy

RE: JPX .28 or Picco .28

also. what is the best engine out of these. picco 28 bump start or jpx 28
Forum: RC Truggy
02-29-2012, 11:51 PM
Replies: 10
Views: 1,336
Posted By tragzy

RE: JPX .28 or Picco .28

well if i was to go with the bump start jpx. i would need to grind the flywheel hole on my chassis in width, i just dunno how i can do that.
any suggestions?
Forum: RC Truggy
02-28-2012, 11:33 PM
Replies: 10
Views: 1,336
Posted By tragzy

RE: JPX .28 or Picco .28

well im going with the pullstart picco 28.
what will the best pipe be 4 it under $70 that will give the best power.
Forum: RC Truggy
02-28-2012, 01:26 AM
Replies: 10
Views: 1,336
Posted By tragzy

JPX .28 or Picco .28

hey guys.
im really stuck with the desision of jpx .28 or picco 28 for my kyosho str.
what do u guys rekon will perform the best out of the two?
any help is much appreciated
cheers.
Showing results 1 to 20 of 20


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.