RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: dhamultun
Showing results 1 to 8 of 8
Search took 0.09 seconds.
Forum: RC Jets
02-07-2021, 09:19 AM
Replies: 5,088
Views: 1,234,619
Posted By dhamultun

What landing gear did you install?

What landing gear did you install?
Forum: RC Jets
11-10-2012, 05:02 PM
Replies: 62
Views: 7,849
Posted By dhamultun

RE: BVM F-86 80

Congratulations! Really nice work. Would love to see some video.
Forum: RC Jets
11-05-2012, 03:28 PM
Replies: 16
Views: 2,038
Posted By dhamultun

RE: Kingtech K80-F Startup video and questions

Barry, As we discussed I'm going to teach the ECU my throttle settings again and remove the felt clunk. Hopefully the PW will drop withing the normal range during idle. Unfortunately I'll most...
Forum: RC Jets
11-04-2012, 04:10 PM
Replies: 16
Views: 2,038
Posted By dhamultun

RE: Kingtech K80-F Startup video and questions

I watched Devin's video, but had not noticed that he was inline with the turbine disk and exhaust. Smitty is 100% correct always infront and do not allow spectators beside or behind when running...
Forum: RC Jets
11-04-2012, 04:01 PM
Replies: 16
Views: 2,038
Posted By dhamultun

RE: Kingtech K80-F Startup video and questions

I did program the ECU with my transmitter. I agree that it may be the most likely source of the problem. Going to re-learn the ECU and re-test.
Forum: RC Jets
11-04-2012, 03:56 PM
Replies: 16
Views: 2,038
Posted By dhamultun

RE: Kingtech K80-F Startup video and questions

Checked the run settings, they all look good. Might try re-learning the ECU for my transmitter and see if it helps and test again.
Forum: RC Jets
11-04-2012, 11:52 AM
Replies: 16
Views: 2,038
Posted By dhamultun

RE: Kingtech K80-F Startup video and questions

Bought it new from Barry. Took me awhile to get all the required fittings for a test run. I'll take a look at the settings later, I assumed they would have been set properly from the factory. I'll...
Forum: RC Jets
11-04-2012, 09:43 AM
Replies: 16
Views: 2,038
Posted By dhamultun

RE: Kingtech K80-F Startup video and questions

Hey Devin! I started my K-80-E today same conditions. I'm in Vaudreuil-Dorion. It worked fine but I found my idle RPM was too fast 56,000 RPM? Hope you don't mind that i've hijacked your...
Showing results 1 to 8 of 8


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.