RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: Tucson01
Showing results 1 to 25 of 125
Search took 0.73 seconds.
06-27-2007, 01:58 PM
Replies: 1
Views: 1,297
Posted By Tucson01

RE: Tamiya 44021

Please note I am not selling these today or tomorrow. I just was looking if there is any interest in these items for collectors.
I am not taking "Offers" on these items.

Thank you

Peace...
06-27-2007, 01:50 PM
Replies: 1
Views: 1,297
Posted By Tucson01

Tamiya 44021

Any Tamiya collectors out there? Or Kyosho collectors?

I will be selling off a few items in the near future. 1 to 2 months

Tamiya 44021 1/10 Tg10 Mini Cooper FS12-LT Nitro ( ( Still in...
Forum: RC Airboats
06-23-2005, 03:00 PM
Replies: 9
Views: 2,014
Posted By Tucson01

Air boat that can fly?

Check out this crazyness [X(]

http://www.putfile.com/media.php?n=HydroFoam
04-28-2005, 08:08 PM
Replies: 9
Views: 1,176
Posted By Tucson01

RE: cheep heli for a beginer.

Buy a "Simulator" or try one out at a friends. Crashing a simulated heli is
FREE! Crashing your heli gets expensive really fast.

When you buy a heli your going to want upgrades, save your...
04-28-2005, 06:27 PM
Replies: 8
Views: 1,235
Posted By Tucson01

RE: Micro heli with belt drive tail upgrade?

You would never get a belt inside the Esky boom. Even with a larger diameter boom you would have problems.
I haven't seen a Zoom/Shogun belt drive in action but I bet if you could see inside the...
04-27-2005, 05:07 PM
Replies: 956
Views: 106,979
Posted By Tucson01

RE: Esky honey bee CP

Tried the DD tail with IPS motor. DD motor pulls alot of amps cooked my 1amp diode[&:] Gives fast tail response but never had a problem with the stock tail as it was. Will save the 2 IPS motors
...
04-26-2005, 08:38 PM
Replies: 956
Views: 106,979
Posted By Tucson01

RE: Esky honey bee CP

Main gear replacement:

Pull off the skids at the frame

Pull the pin out of the head or drive it out with a small wire etc.
(If you hit anything while the blades were spinning the hole...
04-26-2005, 10:47 AM
Replies: 956
Views: 106,979
Posted By Tucson01

RE: Esky honey bee CP

When using the PE blades for FP heli you need to use the offset washers
this adds pitch to the blades. You dont need the washers on the CP heli.

I tried the Hummingbird blades they seem a bit...
04-23-2005, 01:31 PM
Replies: 4
Views: 402
Posted By Tucson01

RE: charging Lipos in Parallel Question?

Charge 2 packs at once .
Buy a few pairs of Banana Plugs and make up any type of charging cable(double check your polarity ;) when doing this)

Hobbico 12 Volt DC Quick Field Charger MkII

...
04-23-2005, 01:25 PM
Replies: 16
Views: 1,278
Posted By Tucson01

RE: My Honey Bee Has No Lift

Jag what charger are you using? The one that came with the HB2? Those things scare the hell out of me. [&:]

I picked up a used Hobbico Quick Field DC Charger MKII 12 Volt over a year ago best...
04-23-2005, 11:39 AM
Replies: 956
Views: 106,979
Posted By Tucson01

RE: Esky honey bee CP

I have had great luck with the PE blades so far. I trimmed the HB2 out can hover with 1/3 trim around half stick.

Heres a Nice Century heli story-- I ordered a couple sets of the $10 blades and...
04-22-2005, 03:50 PM
Replies: 956
Views: 106,979
Posted By Tucson01

RE: Esky honey bee CP

I have a Super 8UHP rather fly atm with the stock unit. I will program my Futaba next week after I trash the AA Energizers in the stock unit.

Pulled those damn flybar weights off what a...
04-21-2005, 06:34 PM
Replies: 956
Views: 106,979
Posted By Tucson01

RE: Esky honey bee CP

Got my used Honey Bee 2 today from Ebay..

HB2 -1 spare mainblade , 2 spare tail blades, spare tail motor, 2 x 1050 li-po's --shipped for $170

I know why the guy sold it he had no idea how...
06-01-2004, 09:39 AM
Replies: 70
Views: 5,837
Posted By Tucson01

RE: How old is everyone??

I'm 36 and Addicted to everything RC!

IT Director, Computers and the like are my life , slowly transitioning to a Remote Control Retirement. :D

Awarf Avistar, Ripmax Alienator, Slow Stick,...
05-29-2004, 11:09 AM
Replies: 3
Views: 532
Posted By Tucson01

RE: HOBBICO SUPERSTAR EP SELECT??

I bought one for my cousin from TowerHobbies from the scratch and dent.

Put a Magnetic Mayhem and a Great planes Gearbox on it and a tail wheel.

Have to say it flies fairly well even with...
05-29-2004, 10:43 AM
Replies: 3
Views: 403
Posted By Tucson01

RE: slow stick batteries/hobbyzone

The 8.4v 900s will work fine.

The 7.2v will have a quite bit less power and duration

Clean the Stator every few flights I use a tapered piece of balsa stick dipped in Alcohol.

I insert...
05-29-2004, 10:28 AM
Replies: 2
Views: 558
Posted By Tucson01

RE: Dihedral or Flatter Wing

Highflyingguy,

Always!!! take advice like the above post with a grain of SALT.

With a few CHEAP fixes you can fly in gust up to 15mph,

1. Get some 2 inch wide Fiberglass packing tape....
05-29-2004, 10:11 AM
Replies: 23
Views: 1,750
Posted By Tucson01

RE: Slow Stick Questions!!!

Evol,

1. Get some 2 inch wide Fiberglass packing tape.

2. Remove the fiberglass rods and that aluminum connector. Take the connector to Ace or any local hardware and buy Stainless
tubing...
05-29-2004, 09:55 AM
Replies: 2
Views: 520
Posted By Tucson01

GWS products will be available at TowerHobbies

Well, I can say I'm glad to see that TowerHobbies will be supplying GWS products.

Nothing but great service from this company and now they will carry GWS products
for my park flying...
05-28-2004, 10:36 PM
Replies: 39
Views: 97,853
Posted By Tucson01

RE: MX bike found!

Radio Shack had the Ricky Carmichael Bike fairly large bike and the frame is aluminum. Can find them on ebay for about $100 . They sold last christmas and I dont know if they continued production....
05-28-2004, 10:32 PM
Replies: 39
Views: 97,853
Posted By Tucson01

RE: MX bike found!

The tires on a the vintage kyosho yamaha are actually bald tires with a nobby slip cover that is glued onto them.

I bid on one had it up to $600 and that was to rich for me.

Most of the...
05-28-2004, 10:26 PM
Replies: 2
Views: 579
Posted By Tucson01

RE: need help finding lipo for shogun/zoom 400

I purchased 2 kokam 1500hc 3s 8 C pack from Towerhobbies $37 each and used a $5 coupon code ended up paying $35 each. Most shops sell these for $50

I believe you have to unwrap the leads as...
05-27-2004, 04:46 PM
Replies: 3
Views: 1,358
Posted By Tucson01

RE: air bubble in etec lipo? dangerous?

The cell is bad!

I just ran into this with a Thunder Power 2100 pack.

Not recommended!!! but I had to see so I disassembled the pack.

I found that the cell was leaking past the Silver...
05-22-2004, 03:57 PM
Replies: 11
Views: 711
Posted By Tucson01

RE: Shopping for new transmitter

I'm going Wi Fli in July if its released then :)

Looks like the module will fit right into my 8u super

and no receiver antenna is gonna be real nice (its inside)

...
05-21-2004, 08:40 PM
Replies: 22
Views: 1,243
Posted By Tucson01

RE: LIKE 90 LIKE AWSOME

Yukonho,

Thanks for the information. Its always better to release a superior product when its ready! I commend you!
I will be one happy customer in the end.

Keep up the good work, I have...
Showing results 1 to 25 of 125
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.