RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: kman527
Showing results 1 to 18 of 18
Search took 0.08 seconds.
Forum: Questions and Answers
02-12-2018, 06:52 PM
Replies: 13
Views: 6,741
Posted By kman527

John - do you know of any clubs that routinely...

John - do you know of any clubs that routinely check whether the members use fail safe on models a certain size or just on everything?
Forum: Questions and Answers
02-12-2018, 06:49 PM
Replies: 13
Views: 6,741
Posted By kman527

When I started thinking about this I thought if I...

When I started thinking about this I thought if I could get the plane into some kind of forward slip it would not impact the ground at a high speed even though it would probably meet its expiration...
Forum: Questions and Answers
02-11-2018, 04:31 PM
Replies: 13
Views: 6,741
Posted By kman527

Not yet but I have fiddled around a bit with Real...

Not yet but I have fiddled around a bit with Real Filght.
Forum: Questions and Answers
02-11-2018, 09:49 AM
Replies: 13
Views: 6,741
Posted By kman527

Fail safe best practices

In the last couple of years I have seen several accidents when control of gassers were totally lost for unknown reasons. (There was not much left so any post-mortems were not possible.) Luckily no...
Forum: Futaba Radios Direct support forum
01-04-2018, 07:32 PM
Replies: 50
Views: 12,924
Posted By kman527

Of course selecting the wing type fixed the...

Of course selecting the wing type fixed the issue. I dare say I have graduated from kindergarten on my way to graduation. Thanks for the quick reply and hint...
Forum: Futaba Radios Direct support forum
01-04-2018, 04:36 PM
Replies: 50
Views: 12,924
Posted By kman527

Help with programming 16SZ

Just got the 16SZ a few days ago and am loving the touch screen - I found using a pen with a stylus is MUCH easier that trying to fat finger the screen. The manual like all Futaba manuals is a...
Forum: Questions and Answers
11-26-2015, 05:14 PM
Replies: 11
Views: 815
Posted By kman527

Fuel tank was full when it stopped on the ground....

Fuel tank was full when it stopped on the ground. I have one of those clear plastic tanks and can see the clunk is OK. Tank is a 4titude nad the internal fuel line is pretty in flexible.
Forum: Questions and Answers
11-25-2015, 07:49 AM
Replies: 11
Views: 815
Posted By kman527

Charlie P I'll try making the low end a bit...

Charlie P

I'll try making the low end a bit richer the next time the temperature here goes above 40! The carb is brand new.
Forum: Questions and Answers
11-24-2015, 10:05 AM
Replies: 11
Views: 815
Posted By kman527

Thanks for the quick suggestions. Forgot to...

Thanks for the quick suggestions.

Forgot to mention that I did check the screen and there was nothing there. I did not have an in-line filter but will add that.

Question - if there was...
Forum: Questions and Answers
11-24-2015, 08:21 AM
Replies: 11
Views: 815
Posted By kman527

DLE 30 dies when fuselage pointed vertical on ground

Title pretty much says it all. This motor is a couple of years old. Always ran great until recently when several old hands suggested replacing the carb when the motor started acting erraticly and...
Forum: RCUniverse.com FAQ
07-08-2015, 04:49 PM
Replies: 1
Views: 586
Posted By kman527

I had one of these and could never get it to run...

I had one of these and could never get it to run correctly. Eventually figured out that the Pitts muffler I was using did not provide enough pressure to the fuel tank. After plugging one of the...
Forum: Futaba Radios Direct support forum
07-07-2015, 09:46 AM
Replies: 4
Views: 3,387
Posted By kman527

One of the guys in our club managed to come up...

One of the guys in our club managed to come up with a configuration that uses switch C for airbrake/neutral/flaps down. However trim on the ailerons only works on the left wing.

Can you send me a...
Forum: Futaba Radios Direct support forum
07-06-2015, 10:24 AM
Replies: 4
Views: 3,387
Posted By kman527

Since I'm getting yelled at for not knowing forum...

Since I'm getting yelled at for not knowing forum protocol - can I reply to this tread or not?
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
07-06-2015, 10:21 AM
Replies: 4
Views: 695
Posted By kman527

Zeeb - you have 4,000+ posts. I have 4 so cut me...

Zeeb - you have 4,000+ posts. I have 4 so cut me a little slack about posting. Several people at my club told me to post the question here and at Flying Giants. I figured they knew what they were...
Forum: Futaba Radios Direct support forum
07-05-2015, 03:56 PM
Replies: 4
Views: 3,387
Posted By kman527

Futaba 10J Programming

Plane is Aeroworks Edge 54 V3 35cc DLE ra

Left aileron on Ch.1
Right aileron on Ch.6

There are no separate speed brakes or flaps.

Should the right aileron be on another channel to do the...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
07-05-2015, 03:50 PM
Replies: 4
Views: 695
Posted By kman527

Moving this to direct support forum...

Moving this to direct support forum...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
07-04-2015, 05:43 PM
Replies: 4
Views: 695
Posted By kman527

Futaba 10J Programming

Plane is Aeroworks Edge 54 V3 35cc DLE ra

Left aileron on Ch.1
Right aileron on Ch.6

There are no separate speed brakes or flaps.

Should the right aileron be on another channel to do the...
Forum: ARF or RTF
09-12-2014, 05:56 PM
Replies: 247
Views: 98,962
Posted By kman527

I am on my second 540. Lost the first one when my...

I am on my second 540. Lost the first one when my mis-tuned DLE 20 died on a go-around with no place to land.

This is my first gas build so have very little experience. I will weigh it in the next...
Showing results 1 to 18 of 18


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.